- 您現在的位置：買賣IC網 > PDF目錄377763 > LTC1736I (Linear Technology Corporation) Isolated Flyback Switching Regulator with 9V Output PDF資料下載
參數資料
| 型號： | LTC1736I |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Isolated Flyback Switching Regulator with 9V Output |
| 中文描述： | 隔離反激式開關穩壓9V輸出 |
| 文件頁數： | 9/28頁 |
| 文件大?。?/td> | 322K |
| 代理商： | LTC1736I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
9
LTC1736
OPERATIOU
The main control loop is shut down by pulling Pin 2 (RUN/
SS) low. Releasing RUN/SS allows an internal 1.2
μ
A
current source to charge soft-start capacitor C
SS
. When
C
SS
reaches 1.5V, the main control loop is enabled with the
I
TH
voltage clamped at approximately 30% of its maximum
value. As C
SS
continues to charge, I
TH
is gradually re-
leased allowing normal operation to resume. If V
OUT
has
not reached 70% of its final value when C
SS
has charged
to 4.1V, latchoff can be invoked as described in the
Applications Information section.
The internal oscillator can be synchronized to an external
clock applied to the FCB pin and can lock to a frequency
between 90% and 130% of its nominal rate set by capaci-
tor C
OSC
.
An overvoltage comparator OV guards against transient
overshoots (>7.5%) as well as other more serious condi-
tions that may overvoltage the output. In this case, the top
MOSFET is turned off and the bottom MOSFET is turned on
until the overvoltage condition is cleared.
Foldback current limiting for an output shorted to ground
is provided by amplifier A. As V
FB
drops below 0.6V, the
buffered I
TH
input to the current comparator is gradually
pulled down to a 0.86V clamp. This reduces peak inductor
current to about 1/4 of its maximum value.
(Refer to Functional Diagram)
Low Current Operation
The LTC1736 has three low current modes controlled by
the FCB pin. Burst Mode operation is selected when the
FCB pin is above 0.8V (typically tied to INTV
CC
). During
Burst Mode operation, if the error amplifier drives the I
TH
voltage below 0.86V, the buffered I
TH
input to the current
comparator will be clamped at 0.86V. The inductor current
peak is then held at approximately 20mV/R
SENSE
(about 1/
4 of maximum output current). If I
TH
then drops below
0.5V, the Burst Mode comparator B will turn off both
MOSFETs to maximize efficiency. The load current will be
supplied solely by the output capacitor until I
TH
rises
above the 60mV hysteresis of the comparator and switch-
ing is resumed. Burst Mode operation is disabled by
comparator F when the FCB pin is brought below 0.8V.
This forces continuous operation and can assist second-
ary winding regulation.
When the FCB pin is driven by an external oscillator, a low
noise cycle-skipping mode is invoked and the internal
oscillator is synchronized to the external clock by com-
parator C. In this mode the 25% minimum inductor
current clamp is removed, providing constant frequency
discontinuous operation over the widest possible output
current range. This constant frequency operation is not
quite as efficient as Burst Mode operation, but provides a
lower noise, constant frequency spectrum.
The FCB pin is tied to ground when forced continuous
operation is desired. This operation is the least efficient
mode, but is desirable in certain applications. The output
can source or sink current in this mode. When sinking
current while in forced continuous operation, current will
be forced back into the main power supply potentially
boosting the input supply to dangerous voltage levels—
BEWARE.
Foldback Current, Short-Circuit Detection
and Short-Circuit Latchoff
The RUN/SS capacitor, C
SS
, is used initially to limit the
inrush current of the switching regulator. After the con-
troller has been started and been given adequate time to
charge up the output capacitors and provide full load
current, C
SS
is used as a short-circuit time-out circuit. If
the output voltage falls to less than 70% of its nominal
output voltage, C
SS
begins discharging on the assumption
that the output is in an overcurrent and/or short-circuit
condition. If the condition lasts for a long enough period
as determined by the size of the C
SS
, the controller will be
shut down until the RUN/SS pin voltage is recycled. This
built-in latchoff can be overridden by providing a current
>5
μ
A at a compliance of 5V to the RUN/SS pin. This
current shortens the soft-start period but also prevents net
discharge of C
SS
during an overcurrent and/or short-
circuit condition. Foldback current limiting is activated
when the output voltage falls below 70% of its nominal
level whether or not the short-circuit latchoff circuit is
enabled.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1736IG | Isolated Flyback Switching Regulator with 9V Output |
| LTC1748IFW | 14-Bit, 80Msps Low Noise ADC |
| LTC1748 | 14-Bit, 80Msps Low Noise ADC |
| LTC1748CFW | 14-Bit, 80Msps Low Noise ADC |
| LTC1754ES6-3.3 | Micropower, Regulated 3.3V/5V Charge Pump with Shutdown in SOT-23 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1736IG | 功能描述:IC REG SW SYNC STEPDWN HE 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG#PBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG#TR | 功能描述:IC REG SW SYNC STEPDWN HE 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG#TRPBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1740CG | 功能描述:IC ADC 14BIT 6MSPS 36SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。