- 您現在的位置：買賣IC網 > PDF目錄377763 > LTC1754ES6-5 (LINEAR TECHNOLOGY CORP) Micropower, Regulated 3.3V/5V Charge Pump with Shutdown in SOT-23 PDF資料下載
參數資料
| 型號： | LTC1754ES6-5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Micropower, Regulated 3.3V/5V Charge Pump with Shutdown in SOT-23 |
| 中文描述： | SWITCHED CAPACITOR REGULATOR, PDSO6 |
| 封裝： | PLASTIC, SOT-23, 6 PIN |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 201K |
| 代理商： | LTC1754ES6-5 |
7
LTC1754-3.3/LTC1754-5
range. The capacitor manufacturer’s data sheet should be
consulted to determine what style and value of capacitor
is needed to ensure 0.6
μ
F at all temperatures.
Output Ripple
Low frequency regulation moderipple exists due to the
hysteresis in the sense comparator and propagation delay
in the charge pump control circuit. The amplitude and
frequency of this ripple are heavily dependent on the load
current, the input voltage and the output capacitor size.
For large V
IN
the ripple voltage can become substantial
because the increased strength of the charge pump causes
fast edges that may outpace the regulation circuitry.
Generally the regulation ripple has a sawtooth shape
associated with it.
A high frequency ripple component may also be present
on the output capacitor due to the charge transfer action
of the charge pump. In this case the output can display a
voltage pulse during the charging phase. This pulse
results from the product of the charging current and the
ESR of the output capacitor. It is proportional to the input
voltage, the value of the flying capacitor and the ESR of the
output capacitor.
Typical combined output ripple for the LTC1754-5 with
V
IN
= 3V under maximum load is 65mV
P-P
using a low ESR
10
μ
F output capacitor. A smaller output capacitor and/or
larger output current load will result in higher ripple due to
higher output voltage slew rates.
There are several ways to reduce output voltage ripple. For
applications requiring higher V
IN
or lower peak-to-peak
ripple, a larger C
OUT
capacitor (22
μ
F or greater) is recom-
mended. A larger capacitor will reduce both the low and
high frequency ripple due to the lower charging and
discharging slew rates, as well as the lower ESR typically
found with higher value (larger case size) capacitors. A low
ESR ceramic output capacitor will minimize the high
frequency ripple, but will not reduce the low frequency
ripple unless a high capacitance value is used. To reduce
both the low and high frequency ripple, a reasonable
compromise is to use a 10
μ
F to 22
μ
F tantalum capacitor
in parallel with a 1
μ
F to 3.3
μ
F ceramic capacitor on V
OUT
.
An R-C filter may also be used to reduce high frequency
voltage spikes (see Figure 1).
Figure 1. Output Ripple Reduction Techniques
In low load or high V
IN
applications, smaller values for the
flying capacitor may be used to reduce output ripple. A
smaller flying capacitor (0.01
μ
F to 0.47
μ
F) delivers less
charge per clock cycle to the output capacitor resulting in
lower output ripple. However, with a smaller flying capaci-
tor, the maximum available output current will be reduced
along with the efficiency.
Note that when using a larger output capacitor the turn on
time of the device will increase.
Inrush Currents
During normal operation V
IN
will experience current tran-
sients in the 50mA to 100mA range whenever the charge
pump is enabled. However during start-up, inrush cur-
rents may approach 250mA. For this reason it is important
to minimize the source impedance between the input
supply and the V
IN
pin. Too much source impedance may
result in regulation problems or prevent start-up.
Ultralow Quiescent Current Regulated Supply
The LTC1754 contains an internal resistor divider (refer to
the Simplified Block Diagram) that typically draws 1.5
μ
A
from V
OUT
. During no-load conditions, this internal load
causes a droop rate of only 150mV per second on V
OUT
with C
OUT
= 10
μ
F. Applying a 2Hz to 100Hz, 2% to 5% duty
cycle signal to the SHDN pin ensures that the circuit of
Figure 2 comes out of shutdown frequently enough to
maintain regulation. Since the LTC1754 spends nearly the
entire time in shutdown, the no-load quiescent current is
approximately (V
OUT
)(1.5
μ
A)/(
η
V
IN
).
The LTC1754 must be out of shutdown for a minimum
duration of 200
μ
s to allow enough time to sense the output
voltage and keep it in regulation. A 2Hz, 2% duty cycle
LTC1754-X
15
μ
F
TANTALUM
V
OUT
V
OUT
V
OUT
1
μ
F
CERAMIC
LTC1754-X
2
10
μ
F
TANTALUM
10
μ
F
TANTALUM
V
OUT
1754 F01
+
+
+
APPLICATIOU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1756EGN | Smart Card Interface |
| LTC1756 | Smart Card Interface |
| LTC1772B | Constant Frequency Current Mode Step-Down DC/DC Controller in SOT-23 |
| LTC1772BES6 | Constant Frequency Current Mode Step-Down DC/DC Controller in SOT-23 |
| LTC1772CS6 | Quadruple 2-Input Positive-NAND Gate 14-SOIC -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1754ES6-5#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER 600KHZ 5V 5 制造商:Linear Technology 功能描述:DC-DC CONVERTER, 700KHZ, 5V, 50mA, SOT-23-6; Primary Input Voltage:5.5V; No. of Outputs:1; Output Voltage:5V; Output Current:50mA; No. of Pins:6; Operating Temperature Min:-40C; Operating Temperature Max:85C ;RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DC-DC CONVERTER, 600KHZ, 5V, 50mA, SOT-23-6; Primary Input Voltage:5.5V; No. of Outputs:1; Output Voltage:5V; Output Current:50mA; No. of Pins:6; Operating Temperature Min:-40C; Operating Temperature Max:85C ;RoHS Compliant: Yes |
| LTC1754ES6-5#TR | 功能描述:IC REG SWITCHED CAP 5V SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
| LTC1754ES6-5#TRM | 功能描述:IC REG SWITCHED CAP 5V SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
| LTC1754ES6-5#TRMPBF | 功能描述:IC REG SWITCHED CAP 5V SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色產品:BD91x Series Step-Down Regulators 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:兩者兼有 輸出數:2 輸出電壓:3.3V，0.8 V ~ 2.5 V 輸入電壓:4.5 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:1MHz 電流 - 輸出:1.5A 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:VQFN020V4040 產品目錄頁面:1373 (CN2011-ZH PDF) 其它名稱:BD9152MUV-E2TR |
| LTC1754ES6-5#TRMPBF (CUT REEL) | 制造商:Linear Technology 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。