- 您現在的位置：買賣IC網 > PDF目錄377763 > LTC1756 (Linear Technology Corporation) Smart Card Interface PDF資料下載
參數資料
| 型號： | LTC1756 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Smart Card Interface |
| 中文描述： | 智能卡接口 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 149K |
| 代理商： | LTC1756 |
8
LTC1756
APPLICATIO
S I
N
FOR
ATIO
U
The bypass capacitor at V
IN
is also important. Large dips
on the input supply due to ESR may cause problems with
the internal circuitry of the LTC1756. A good choice for the
input bypass capacitor is a 10
μ
F Y5V style ceramic
W
U
Low Power Operation
The LTC1756 is inherently a low power device. When there
is no Smart Card present the supply current is less than
2.5
μ
A. When a Smart Card is present the LTC1756 oper-
ates with a quiescent current of only 75
μ
A, thus the
majority of power is consumed by charge pump losses
and the card itself. If the card can be made to consume less
power during idle times a significant power savings will be
achieved. Whenever possible Clock Stop Mode should be
used (or alternatively a very low “idling” clock speed).
Furthermore, in the Active state, the bidirectional pins
should all be relinquished whenever possible since there
is some static current flow when a bidirectional pin is
pulled down.
Overtemperature Fault Protection
An overtemperature circuit disables the chip and places
the LTC1765 in the Alarm state if the IC’s junction tem-
perature exceeds 150
°
C.
Dynamic Pull-Up Current Sources
The current sources on the bidirectional pins (DATA and
I/O) are dynamically activated to achieve a fast rise time
with a relatively small static current (Figure 1). Once a
bidirectional pin is relinquished, a small start-up current
begins to charge the node. An edge rate detector deter-
mines if the pin is released by comparing its slew rate with
an internal reference value. If a valid transition is detected,
a large pull-up current enhances the edge rate on the node.
The higher slew rate corroborates the decision to charge
the node thereby effecting a dynamic form of hysteresis.
Once the node has reached the power supply voltage the
internal comparator requires several hundred nanosec-
onds to reset. Pulling down on the pin before the reset
delay expires will result in a momentary contention and a
higher current flow. Therefore, the comparator delay sets
the upper limit on the maximum data rate of the bidirec-
tional channels to about 500kHz.
Figure 1. Dynamic Pull-Up Current Sources
–
+
δ
V
δ
t
I
START
1756 F01
V
REF
BIDIRECTIONAL PIN
V
CC
OR V
IN
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1772B | Constant Frequency Current Mode Step-Down DC/DC Controller in SOT-23 |
| LTC1772BES6 | Constant Frequency Current Mode Step-Down DC/DC Controller in SOT-23 |
| LTC1772CS6 | Quadruple 2-Input Positive-NAND Gate 14-SOIC -40 to 85 |
| LTC1772 | Constant Frequency Current Mode Step-Down DC/DC Controller in SOT-23 |
| LTC1773 | Synchronous Step-Down Regulator Controller(同步步降穩壓器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1756EGN | 功能描述:IC SMART CARD 16-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| LTC1756EGN#PBF | 功能描述:IC SMART CARD INTERFACE 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| LTC1756EGN#TR | 功能描述:IC SMART CARD INTERFACE 16SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| LTC1756EGN#TRPBF | 功能描述:IC SMART CARD INTERFACE 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| LTC1757A-1EMS8 | 功能描述:IC CTRLR RF POWER SINGLE 8MSOP RoHS:否 類別:RF/IF 和 RFID >> RF 電源控制器 IC 系列:- 標準包裝:3,000 系列:- RF 型:GSM 頻率:450MHz ~ 2GHz 特點:四頻帶 封裝/外殼:8-VFBGA 供應商設備封裝:8-MicroSMD（1.51x1.51） 包裝:帶卷 (TR) 其它名稱:LMV243BLX |
發布緊急采購，3分鐘左右您將得到回復。