- 您現在的位置：買賣IC網 > PDF目錄377763 > LTC1775IGN (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LTC1775IGN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 2 A SWITCHING CONTROLLER, 165 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 289K |
| 代理商： | LTC1775IGN |
11
LTC1775
A reasonable starting point is to choose a ripple current
that is about 40% of I
O(MAX)
. Note that the largest ripple
current occurs at the highest V
IN
. To guarantee that ripple
current does not exceed a specified maximum, the induc-
tor should be chosen according to:
L
V
f
I
V
V
OUT
L MAX
(
OUT
IN MAX
(
≥
( )(
)
–
)
)
1
Burst Mode Operation Considerations
The choice of R
DS(ON)
and inductor value also determines
the load current at which the LTC1775 enters Burst Mode
operation. When bursting, the controller clamps the peak
inductor current to approximately:
I
mV
R
BURSTPEAK
DS ON
(
(
)
)
=
60
The corresponding average current depends on the amount
of ripple current. Lower inductor values (higher
I
L
) will
reduce the load current at which Burst Mode operation
begins.
The output voltage ripple can increase during Burst Mode
operation if
I
L
is substantially less than I
BURST
. This will
primarily occur when the duty cycle is very close to unity
(V
IN
is close to V
OUT
) or if very large value inductors are
chosen. This is generally only a concern in applications
with V
OUT
≥
5V. At high duty cycles, a skipped cycle
causes the inductor current to quickly descend to zero.
However, it takes multiple cycles to ramp the current back
up to I
BURST(PEAK)
. During this interval, the output capaci-
tor must supply the load current and enough charge may
be lost to cause significant droop in the output voltage. It
is a good idea to keep
I
L
comparable to I
BURST(PEAK)
.
Otherwise, one might need to increase the output capaci-
tance in order to reduce the voltage ripple or else disable
Burst Mode operation by forcing continuous operation
with the FCB pin.
Fault Conditions: Current Limit and Output Shorts
The LTC1775 current comparator can accommodate a
maximum sense voltage of 300mV. This voltage and the
sense resistance determine the maximum allowed peak
inductor current. The corresponding output current limit
is:
mV
R
DS ON
T
)
( )
I
I
LIMIT
L
=
(
300
1
2
(
)
–
ρ
The current limit value should be checked to ensure that
I
LIMIT(MIN)
> I
O(MAX)
. The minimum value of current limit
generally occurs with the largest V
IN
at the highest ambi-
ent temperature, conditions which cause the highest power
dissipation in the top MOSFET. Note that it is important to
check for self-consistency between the assumed junction
temperature of the top MOSFET and the resulting value of
I
LIMIT
which heats the junction.
Caution should be used when setting the current limit
based upon R
DS(ON)
of the MOSFETs. The maximum
current limit is determined by the minimum MOSFET on-
resistance. Data sheets typically specify nominal and
maximum values for R
DS(ON)
, but not a minimum. A
reasonable, but perhaps overly conservative, assumption
is that the minimum R
DS(ON)
lies the same amount below
the typical value as the maximum R
DS(ON)
lies above it.
Consult the MOSFET manufacturer for further guidelines.
The LTC1775 includes current foldback to help further
limit load current when the output is shorted to ground. If
the output falls by more than half, then the maximum
sense voltage is progressively lowered from 300mV to
about 80mV. Under short-circuit conditions with very low
duty cycle, the LTC1775 will begin skipping cycles in order
to limit the short-circuit current. In this situation the
bottom MOSFET R
DS(ON)
will control the inductor current
valley rather than the top MOSFET controlling the inductor
current peak. The short-circuit ripple current is deter-
mined by the minimum on-time t
ON(MIN)
of the LTC1775
(approximately 0.5
μ
s), the input voltage, and inductor
value:
I
L(SC)
= t
ON(MIN)
V
IN
/L.
The resulting short-circuit current is:
mV
R
DS ON BOT
T
)
( )
I
I
SC
L SC
(
=
(
+
80
1
2
(
)(
)
)
ρ
APPLICATIOU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1775CGN | Quadruple 2-Input Positive-NAND Gate 14-TVSOP -40 to 85 |
| LTC1775CS | Quadruple 2-Input Positive-NAND Gate 14-SOIC -40 to 85 |
| LTC1775I | Quadruple 2-Input Positive-NAND Gate 14-SOIC -40 to 85 |
| LTC1775IS | Quadruple 2-Input Positive-NAND Gate 14-SOIC -40 to 85 |
| LTC1775 | High Power Current Mode Synchronous Step-Down Switching Regulator(大功率，同步電流模式步降開關穩壓器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1775IGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1775IGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1775IGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1775IS | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1775IS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。