參數資料
型號: LTC1856IG#TRPBF
廠商: Linear Technology
文件頁數: 11/24頁
文件大?。?/td> 0K
描述: IC ADC 16BIT 100KSPS 28-SSOP
標準包裝: 2,000
位數: 16
采樣率(每秒): 100k
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 40mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 28-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 28-SSOP
包裝: 帶卷 (TR)
輸入數目和類型: 8 個單端,雙極;4 個差分,雙極
19
LTC1854/LTC1855/LTC1856
185456fa
APPLICATIO S I FOR ATIO
WU
UU
MUX ADDRESS
The first four bits of the input word assign the MUX
configuration for the requested conversion. For a given
channel selection, the converter will measure the voltage
between the two channels indicated by the + and – signs
in the selected row of Table 1. Note that in differential
mode (SGL/DIFF = 0) measurements are limited to four
adjacent input pairs with either polarity. In single-ended
mode, all input channels are measured with respect to
COM. Both the “+” and “–” inputs are sampled simulta-
neously so common mode noise is rejected. Bits 5 and 6
of the input words are Don’t Care bits.
POWER DOWN SELECTION (NAP, SLEEP)
The last two bits of the input word (Nap and Sleep) deter-
mine the power shutdown mode of the LTC1854/LTC1855/
LTC1856. See Table 2. Nap mode is selected when Nap =
1 and Sleep = 0. The previous conversion result will be
clocked out and a conversion will occur before entering
the Nap mode. The Nap mode starts at the end of the con-
version which is indicated by the rising edge of the BUSY
signal. Nap mode lasts until the falling edge of the 2nd SCK
(see Figure 9). Automatic nap will be achieved if Nap = 1
is selected each time an input word is written to the ADC.
Table 2. Power Down Selection
NAP
SLEEP
POWER DOWN MODE
0
Power On
1
0
Nap
X
1
Sleep
Sleep mode will occur when Sleep = 1 is selected,
regardless of the selection of the Nap input. The previous
conversion result can be clocked out and the Sleep mode
will start on the falling edge of the last (16th) SCK. Notice
that the CONVST should stay either high or low in sleep
mode (see Figure 10). To wake up from the sleep mode,
apply a rising edge on the CONVST signal and then apply
Sleep = 0 on the next SDI word and the part will wake up
on the falling edge of the last (16th) SCK (see Figure 11).
In Sleep mode, all bias currents are shut down and only the
power on reset circuit and leakage currents (about 10
mA)
remain. Sleep mode wake-up time is dependent on the
value of the capacitor connected to the REFCOMP (Pin 16).
The wake-up time is typically 40ms with the recom-
mended 10
mF capacitor connected on the REFCOMP pin.
DYNAMIC PERFORMANCE
FFT (Fast Fourier Transform) test techniques are used to
test the ADC’s frequency response, distortion and noise
at the rated throughput. By applying a low distortion sine
wave and analyzing the digital output using an FFT
algorithm, the ADC’s spectral content can be examined
for frequencies outside the fundamental. Figure 12 shows
a typical LTC1856 FFT plot which yields a SINAD of 87dB
and THD of – 101dB.
相關PDF資料
PDF描述
CXS3102A2214S CONN RCPT 19POS PNL MNT SKT
VI-B6T-IV-S CONVERTER MOD DC/DC 6.5V 150W
VE-251-IU-F4 CONVERTER MOD DC/DC 12V 200W
LT1381CS IC DVR/RCVR 5V RS232 DUAL 16SOIC
SF6282-7PG-520 CONN PLUG 7POS CABLE PIN
相關代理商/技術參數
參數描述
LTC1857CG 制造商:Linear Technology 功能描述:ADC Single SAR 100ksps 12-bit Serial 28-Pin SSOP
LTC1857CG#PBF 功能描述:IC ADC 8CH 12BIT 100KSPS 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:SoftSpan™ 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1857CG#PBF 制造商:Linear Technology 功能描述:ADC, 8CH, 12BIT, 100KSPS, SSOP-28
LTC1857CG#TRPBF 功能描述:IC A/D CONV 8CH 12BIT 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:SoftSpan™ 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1857CGPBF 制造商:Linear Technology 功能描述:ADC,LTC1857 12bit 100kSPS 8 ch SPI SSOP