- 您現在的位置：買賣IC網 > PDF目錄377766 > LTC1966 (Linear Technology Corporation) Precision Micropower, SIGMA RMS-to-DC Converter PDF資料下載
參數資料
| 型號： | LTC1966 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Precision Micropower, SIGMA RMS-to-DC Converter |
| 中文描述： | 精密微，適馬有效值- DC轉換器 |
| 文件頁數： | 14/32頁 |
| 文件大?。?/td> | 444K |
| 代理商： | LTC1966 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
14
LTC1966
sn1966 1966fas
A 1
μ
F capacitor is a good choice for many applications.
The peak error at 50Hz/60Hz will be <1% and the DC error
will be <0.1% with frequencies of 10Hz or more.
Note that both Figure 6 and Figure 8 assume AC-coupled
waveforms with a crest factor less than 2, such as sine
waves or triangle waves. For higher crest factors and/or
AC + DC waveforms, a larger C
AVE
will generally be
required. See “Crest Factor and AC + DC Waveforms.”
Capacitor Type Selection
The LTC1966 can operate with many types of capacitors.
The various types offer a wide array of sizes, tolerances,
parasitics, package styles and costs.
Ceramic chip capacitors offer low cost and small size, but
are not recommended for critical applications. The value
stability over voltage and temperature is poor with many
types of ceramic dielectrics. This will not cause an RMS-
to-DC accuracy problem except at low frequencies, where
it can aggravate the effects discussed in the previous
section. If a ceramic capacitor is used, it may be neces-
sary to use a much higher nominal value in order to
assure the low frequency accuracy desired.
Another parasitic of ceramic capacitors is leakage, which
is again dependent on voltage and particularly tempera-
ture. If the leakage is a constant current leak, the I R drop
of the leak multiplied by the output impedance of the
LTC1966 will create a constant offset of the output voltage.
If the leak is Ohmic, the resistor divider formed with the
LTC1966 output impedance will cause a gain error. For
APPLICATIOU
W
U
U
<0.1% gain accuracy degradation, the parallel impedance
of the capacitor leakage will need to be >1000 times the
LTC1966 output impedance. Accuracy at this level can be
hard to achieve with a ceramic capacitor, particularly with
a large value of capacitance and at high temperature.
For critical applications, a film capacitor, such as metal-
ized polyester, will be a much better choice. Although
more expensive, and larger for a given value, the value
stability and low leakage make metal-film capacitors a
trouble-free choice.
With any type of capacitor, the self-resonance of the
capacitor can be an issue with the switched capacitor
LTC1966. If the self-resonant frequency of the averaging
capacitor is 1MHz or less, a second smaller capacitor
should be added in parallel to reduce the impedance seen
by the LTC1966 output stage at high frequencies. A
capacitor 100 times smaller than the averaging capacitor
will typically be small enough to be a low cost ceramic with
a high quality dielectric such as X7R or NPO/COG.
Input Connections
The LTC1966 input is differential and DC coupled. The
LTC1966 responds to the RMS value of the differential
voltage between Pin 2 and Pin 3, including the DC portion
of that difference. However, there is no DC-coupled path
from the inputs to ground. Therefore, at least one of the two
inputs must be connected with a DC-return path to ground.
Both inputs must be connected to something. If either
input is left floating, a zero volt output will result.
Figure 8. Peak Error vs Input Frequency with One Cap Averaging
INPUT FREQUENCY (Hz)
1
–2.0
P
–1.6
–1.2
–0.8
–0.4
10
20
50
60
100
1966 F08
0
–1.8
–1.4
–1.0
–0.6
–0.2
C = 100
μ
F
C = 47
μ
F
C = 22
μ
F
C = 10
μ
F
C = 4.7
μ
F
C = 2.2
μ
F
C = 1
μ
F
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1966CMS8 | Precision Micropower, SIGMA RMS-to-DC Converter |
| LTC1967 | Precision Extended Bandwidth, RMS-to-DC Converter |
| LTC1967CMS8 | Precision Extended Bandwidth, RMS-to-DC Converter |
| LTC1967IMS8 | Precision Extended Bandwidth, RMS-to-DC Converter |
| LTTJ | Precision Extended Bandwidth, RMS-to-DC Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1966CMS8 | 功能描述:IC PREC RMS/DC CONV MCRPWR 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - RMS 至 DC 轉換器 系列:- 標準包裝:46 系列:- 電流 - 電源:1.2mA 電源電壓:±18 V，36 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| LTC1966CMS8#PBF | 功能描述:IC PREC RMS/DC CONV MCRPWR 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - RMS 至 DC 轉換器 系列:- 標準包裝:46 系列:- 電流 - 電源:1.2mA 電源電壓:±18 V，36 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| LTC1966CMS8#TR | 功能描述:IC PREC RMS/DC CONV MCRPWR 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - RMS 至 DC 轉換器 系列:- 標準包裝:46 系列:- 電流 - 電源:1.2mA 電源電壓:±18 V，36 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| LTC1966CMS8#TRPBF | 功能描述:IC PREC RMS/DC CONV MCRPWR 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - RMS 至 DC 轉換器 系列:- 標準包裝:46 系列:- 電流 - 電源:1.2mA 電源電壓:±18 V，36 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| LTC1966CMS8PBF | 制造商:Linear Technology 功能描述:RMS-to-DC Converter Prec. uPower MSOP8 |
發布緊急采購，3分鐘左右您將得到回復。