- 您現在的位置：買賣IC網 > PDF目錄10316 > LTC2236IUH#TRPBF (Linear Technology)IC ADC 10BIT 25MSPS 3V 32-QFN PDF資料下載
參數資料
| 型號： | LTC2236IUH#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 13/28頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 10BIT 25MSPS 3V 32-QFN |
| 標準包裝： | 2,500 |
| 位數： | 10 |
| 采樣率（每秒）： | 25M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 90mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-QFN 裸露焊盤（5x5） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，雙極; 1 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2238/LTC2237/LTC2236
20
223876fa
APPLICATIO S I FOR ATIO
WU
UU
Maximum and Minimum Conversion Rates
The maximum conversion rate for the LTC2238/LTC2237/
LTC2236 is 65Msps (LTC2238), 40Msps (LTC2237), and
25Msps (LTC2236). For the ADC to operate properly, the
CLK signal should have a 50% (
±5%) duty cycle. Each half
cycle must have at least 7.3ns (LTC2238), 11.8ns
(LTC2237), and 18.9ns (LTC2236) for the ADC internal
circuitry to have enough settling time for proper operation.
An optional clock duty cycle stabilizer circuit can be used
if the input clock has a non 50% duty cycle. This circuit
uses the rising edge of the CLK pin to sample the analog
input. The falling edge of CLK is ignored and the internal
falling edge is generated by a phase-locked loop. The input
clock duty cycle can vary from 40% to 60% and the clock
duty cycle stabilizer will maintain a constant 50% internal
duty cycle. If the clock is turned off for a long period of
time, the duty cycle stabilizer circuit will require a hundred
clock cycles for the PLL to lock onto the input clock. To use
the clock duty cycle stabilizer, the MODE pin should be
connected to 1/3VDD or 2/3VDD using external resistors.
The lower limit of the LTC2238/LTC2237/LTC2236 sample
rate is determined by droop of the sample-and-hold cir-
cuits. The pipelined architecture of this ADC relies on
storing analog signals on small valued capacitors. Junc-
tion leakage will discharge the capacitors. The specified
minimum operating frequency for the LTC2238/LTC2237/
LTC2236 is 1Msps.
Figure 14. Digital Output Buffer
DIGITAL OUTPUTS
Table 1 shows the relationship between the analog input
voltage, the digital data bits, and the overflow bit.
LTC2228/27/26
222876 F14
OVDD
VDD
0.1
F
43
TYPICAL
DATA
OUTPUT
OGND
OVDD
0.5V
TO 3.6V
PREDRIVER
LOGIC
DATA
FROM
LATCH
OE
Table 1. Output Codes vs Input Voltage
AIN+ – AIN–
D9 – D0
(2V Range)
OF
(Offset Binary)
(2’s Complement)
>+1.000000V
1
11 1111 1111
01 1111 1111
+0.998047V
0
11 1111 1111
01 1111 1111
+0.996094V
0
11 1111 1110
01 1111 1110
+0.001953V
0
10 0000 0001
00 0000 0001
0.000000V
0
10 0000 0000
00 0000 0000
–0.001953V
0
01 1111 1111
11 1111 1111
–0.003906V
0
01 1111 1110
11 1111 1110
–0.998047V
0
00 0000 0001
10 0000 0001
–1.000000V
0
00 0000 0000
10 0000 0000
<–1.000000V
1
00 0000 0000
10 0000 0000
Digital Output Buffers
Figure 14 shows an equivalent circuit for a single output
buffer. Each buffer is powered by OVDD and OGND, iso-
lated from the ADC power and ground. The additional
N-channel transistor in the output driver allows operation
down to low voltages. The internal resistor in series with
the output makes the output appear as 50
to external
circuitry and may eliminate the need for external damping
resistors.
As with all high speed/high resolution converters, the
digital output loading can affect the performance. The
digital outputs of the LTC2238/LTC2237/LTC2236 should
drive a minimal capacitive load to avoid possible interac-
tion between the digital outputs and sensitive input cir-
cuitry. The output should be buffered with a device such as
an ALVCH16373 CMOS latch. For full speed operation the
capacitive load should be kept under 10pF.
Lower OVDD voltages will also help reduce interference
from the digital outputs.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2N0-CU-S | CONVERTER MOD DC/DC 5V 200W |
| D38999/26WJ61SNLC | CONN HSG PLUG 61POS STRGHT SCKT |
| D38999/20WH55SALC | CONN HSG RCPT 55POS WALL MT SCKT |
| MS27484T24B35SLC | CONN HSG PLUG 128POS STRGHT SCKT |
| MS27484T24B35B | CONN HSG PLUG 128POS STRGHT SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2237 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 80Msps Low Power 3V ADC |
| LTC2237CUH | 制造商:LINER 制造商全稱:Linear Technology 功能描述:10-Bit, 65/40/25Msps Low Noise 3V ADCs |
| LTC2237CUH#PBF | 功能描述:IC ADC 10-BIT 40MSPS 3V 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2237CUH#TRPBF | 功能描述:IC ADC 10BIT 40MSPS 3V 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2237IUH | 制造商:Linear Technology 功能描述:ADC Single Pipelined 40Msps 10-bit Parallel 32-Pin QFN EP |
發布緊急采購，3分鐘左右您將得到回復。