參數資料
型號: LTC2366IS6#TRPBF
廠商: Linear Technology
文件頁數: 10/24頁
文件大?。?/td> 0K
描述: IC ADC 12BIT 3MSPS TSOT23-6
標準包裝: 2,500
位數: 12
采樣率(每秒): 3M
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 14.4mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: SOT-23-6 細型,TSOT-23-6
供應商設備封裝: TSOT-23-6
包裝: 帶卷 (TR)
輸入數目和類型: 1 個單端,單極
配用: DC1190A-A-ND - BOARD SAR ADC LTC2366
LTC2365/LTC2366
18
23656fb
For more information www.linear.com/LTC2365
SINGLE-ENDED ANALOG INPUT
Driving the Analog Input
The analog input of the LTC2365/LTC2366 is easy to drive.
Theinputdrawsonlyonesmallcurrentspikewhilecharging
the sample-and-hold capacitor at the end of conversion.
During the conversion, the analog input draws only a small
leakage current. If the source impedance of the driving
circuit is low, then the input of the LTC2365/LT2366 can
be driven directly. As source impedance increases, so will
acquisition time. For minimum acquisition time with high
source impedance, a buffer amplifier should be used. The
main requirement is that the amplifier driving the analog
input must settle after the small current spike before the
next conversion starts (settling time must be less than
56ns for full throughput rate). While choosing an input
amplifier, also keep in mind the amount of noise and
harmonic distortion the amplifier contributes.
Choosing an Input Amplifier
Choosing an input amplifier is easy if a few requirements
are taken into consideration. First, to limit the magnitude
of the voltage spike seen by amplifier from charging the
sampling capacitor, choose an amplifier that has a low
output impedance (<100) at the closed-loop bandwidth
frequency. For example, if an amplifier is used in a gain
of 1 and has a unity-gain bandwidth of 50MHz, then the
output impedance at 50MHz must be less than 100. The
secondrequirementisthattheclosed-loopbandwidthmust
be greater than 40MHz to ensure adequate small signal
settling for full throughput rate. If slower op amps are
used, more time for settling can be provided by increasing
the time between conversions. The best choice for an op
amp to drive the LTC2365/LTC2366 will depend on the
application.Generally,applicationsfallintotwocategories:
AC applications where dynamic specifications are most
critical and time domain applications where DC accuracy
and settling time are most critical. The following list is a
summary of the op amps that are suitable for driving the
LTC2365/LTC2366.(Moredetailedinformationisavailable
on the Linear Technology website at www.linear.com.)
LTC1566-1:LowNoise2.3MHzContinuousTimeLowpass
Filter.
LT1630: Dual 30MHz Rail-to-Rail Voltage Feedback
Amplifier. 2.7V to ±15V supplies. Very high AVOL, 500V
offset and 520ns settling to 0.5LSB for a 4V swing. THD
and noise are –93dB to 40kHz and below 1LSB to 320kHz
(AV = 1, 2VP-P into 1k, VS = 5V), making the part excellent
for AC applications (to 1/3 Nyquist) where rail-to-rail per-
formance is desired. Quad version is available as LT1631.
LT1632:Dual45MHzRail-to-RailVoltageFeedbackAmpli-
fier. 2.7V to ±15V supplies. Very high AVOL, 1.5mV offset
and 400ns settling to 0.5LSB for a 4V swing. It is suitable
for applications with a single 5V supply. THD and noise
are –93dB to 40kHz and below 1LSB to 800kHz (AV = 1,
2VP-P into 1k, VS = 5V), making the part excellent for AC
applications where rail-to-rail performance is desired.
Quad version is available as LT1633.
LT1813: Dual 100MHz 750V/s 3mA Voltage Feedback
Amplifier.5Vto±5Vsupplies.Distortionis–86dBto100kHz
and –77dB to 1MHz with ±5V supplies (2VP-P into 500).
Excellent part for fast AC applications with ±5V supplies.
LT1801: 180MHz GBWP, –75dBc at 500kHz, 2mA/Ampli-
fier, 8.5nV/√Hz.
LT1806/LT1807: 325MHz GBWP, –80dBc Distortion at
5MHz, Unity-Gain Stable, R-R In and Out, 10mA/Ampli-
fier, 3.5nV/√Hz.
LT1810: 180MHz GBWP, –90dBc Distortion at 5MHz,
Unity-Gain Stable, R-R In and Out, 15mA/Amplifier,
16nV/√Hz.
LT1818/LT1819: 400MHz, 2500V/s, 9mA, Single/Dual
Voltage Mode Operational Amplifier.
LT6200:165MHzGBWP,–85dBcDistortionat1MHz,Unity-
Gain Stable, R-R In and Out, 15mA/Amplifier, 0.95nV/√Hz.
LT6203: 100MHz GBWP, –80dBc Distortion at 1MHz,
Unity-Gain Stable, R-R In and Out, 3mA/Amplifier,
1.9nV√Hz.
applications inForMation
相關PDF資料
PDF描述
MS27468T25B24SLC CONN HSG RCPT 24POS JAMNUT SCKT
VE-B7R-MW-S CONVERTER MOD DC/DC 7.5V 100W
VE-B1W-MW-S CONVERTER MOD DC/DC 5.5V 100W
14280-18PG-300 CONN RCPT 18POS PNL MNT PIN
D38999/24FG75AN CONN HSG RCPT 4POS JAM NUT PINS
相關代理商/技術參數
參數描述
LTC2366ITS8#PBF 制造商:Linear Technology 功能描述:12BIT ADC 3MSPS SERIAL 8SOT23 制造商:Linear Technology 功能描述:IC, ADC, 12BIT, 3MSPS, TSOT-23-8, Resolution (Bits):12bit, Sampling Rate:3MSPS, Supply Voltage Type:Single, Supply Voltage Min:2.35V, Supply Voltage Max:3.6V, Supply Current:2.6mA, Digital IC Case Style:TSOT-23, No. of Pins:8 , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:MS-ADC/General Purpose, Cut Tape 12-bit 2Msps SAR ADC in
LTC2366ITS8#TRMPBF 功能描述:IC ADC 12BIT 3MSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC2366ITS8#TRPBF 功能描述:IC ADC 12BIT 3MSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2367CDE-16#PBF 功能描述:IC ADC 16BIT SPI/SRL 500K 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
LTC2367CDE-16#TRPBF 功能描述:IC ADC 16BIT SPI/SRL 500K 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極