- 您現在的位置：買賣IC網 > PDF目錄10129 > LTC2393CUK-16#TRPBF (Linear Technology)IC ADC 16BIT SER/PAR 1M 48-QFN PDF資料下載
參數資料
| 型號： | LTC2393CUK-16#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT SER/PAR 1M 48-QFN |
| 標準包裝： | 2,000 |
| 位數： | 16 |
| 采樣率（每秒）： | 1M |
| 數據接口： | 串行，并聯(lián) |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 175mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 48-QFN-EP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | DC1500A-A-ND - BOARD SAR ADC LTC2393-16 |
LTC2393-16
14
239316fa
APPLICATIONS INFORMATION
Signal-to-Noise Ratio (SNR)
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
the RMS amplitude of all other frequency components
except the first five harmonics and DC. Figure 5 shows
that the LTC2393-16 achieves a typical SNR of 94.2dB at
a 1MHz sampling rate with a 20kHz input.
Total Harmonic Distortion (THD)
Total harmonic distortion (THD) is the ratio of the RMS sum
of all harmonics of the input signal to the fundamental itself.
The out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency (fSMPL/2).
THD is expressed as:
THD
= 20 log
V2
2
+ V32 + V42...VN2
V1
where V1 is the RMS amplitude of the fundamental fre-
quency and V2 through VN are the amplitudes of the second
through Nth harmonics.
POWER CONSIDERATIONS
The LTC2393-16 provides three sets of power supply
pins: the analog 5V power supply (AVP), the digital 5V
power supply (DVP) and the digital input/output interface
power supply (OVP). The flexible OVP supply allows the
LTC2393-16tocommunicatewithanydigitallogicoperating
between 1.8V and 5V, including 2.5V and 3.3V systems.
Power Supply Sequencing
The LTC2393-16 does not have any specific power supply
sequencing requirements. Care should be taken to observe
the maximum voltage relationships described in the Ab-
solute Maximum Ratings section. The LTC2393-16 has a
power-on-reset (POR) circuit. With the POR, the result of
the first conversion is valid after power has been applied
to the ADC. The LTC2393-16 will reset itself if the power
supply voltage drops below 2.5V. Once the supply voltage
is brought back to its nominal value, the POR will reinitial-
ize the ADC and it will be ready to start a new conversion.
Nap Mode
The LTC2393-16 can be put into the nap mode after a
conversion has been completed to reduce the power
consumption between conversions. In this mode some
of the circuitry on the device is turned off. Nap mode is
enabled by keeping CNVST low between conversions. When
the next conversion is requested, bring CNVST high and
hold for at least 250ns, then start the next conversion by
bringing CNVST low. See Figure 6.
Power Shutdown Mode
When PD is tied high, the LTC2393-16 enters power shut-
down and subsequent requests for conversion are ignored.
Before entering power shutdown, the digital output data
needs to be read. However, if a request for power shutdown
(PD = high) occurs during a conversion, the conversion
Figure 6. Nap Mode Timing for the LTC2393-16
CNVST
BUSY
NAP
tCONV
tACQ
NAP MODE
239316 F06
t5
相關PDF資料 |
PDF描述 |
|---|---|
| MS27473T18B35SC | CONN PLUG 66POS STRAIGHT W/SCKT |
| IDT7201LA15TPI | IC MEM FIFO 512X9 15NS 28-PDIP |
| MS3102R36-6P | CONN RCPT 6POS BOX MNT W/PINS |
| IDT7201LA12TPG | IC MEM FIFO 512X9 12NS 28-PDIP |
| ADM207EANZ | IC TXRX RS232 5DVR/3REC 24DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2393HLX-16#PBF | 功能描述:IC ADC 16BIT SER/PAR 1M 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2393ILX-16#PBF | 功能描述:IC ADC 16BIT SER/PAR 1M 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2393ILX-16#PBF | 制造商:Linear Technology 功能描述:ANALOG TO DIGITAL (A/D) CONVERTER IC |
| LTC2393IUK-16#PBF | 功能描述:IC ADC 16BIT SER/PAR 1M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯(lián) 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC2393IUK-16#TRPBF | 功能描述:IC ADC 16BIT SER/PAR 1M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯(lián) 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發(fā)布緊急采購，3分鐘左右您將得到回復。