- 您現在的位置：買賣IC網 > PDF目錄377769 > LTC2401IMS (LINEAR TECHNOLOGY CORP) 18-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 PDF資料下載
參數資料
| 型號： | LTC2401IMS |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | ADC |
| 英文描述： | 18-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 |
| 中文描述： | 1-CH 24-BIT DELTA-SIGMA ADC, SERIAL ACCESS, PDSO10 |
| 封裝： | PLASTIC, MSOP-10 |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 171K |
| 代理商： | LTC2401IMS |
10
LTC2401/LTC2402
APPLICATIOU
The LTC2402’s single ended rejection of line frequencies
(
±
2%) and harmonics is better than 110dB. Since the
device performs two independent single ended conver-
sions each with >110dB rejection, the overall common
mode and differential rejection is much better than the
80dB rejection typically found in other differential input
delta-sigma converters.
In addition to excellent rejection of line frequency noise,
the LTC2402 also exhibits excellent single ended noise
rejection over a wide range of frequencies due to its 4
th
order sinc filter. Each single ended conversion indepen-
dently rejects high frequency noise (>60Hz). Care must be
taken to insure noise at frequencies below 15Hz and at
multiples of the ADC sample rate (15,600Hz) are not
present. For this application, it is recommended the
LTC2402 is placed in close proximity to the bridge sensor
in order to reduce the noise injected into the ADC input. By
performing three successive conversions (CH0-CH1-CH0),
the drift and low frequency noise can be measured and
compensated for digitally.
The absolute accuracy (less than 10 ppm total error) of the
LTC2402 enables extremely accurate measurement of
small signals sitting on large voltages. Each of the two
pseudo differential measurements performed by the
LTC2402 is absolutely accurate independent of the com-
mon mode voltage output from the bridge. The pseudo
differential result obtained from digitally subtracting the
two single ended conversion results is accurate to within
W
U
U
the noise level of the device (3
μ
V
RMS
) divided by square
root of 2, independent of the common mode input voltage.
Typically, a bridge sensor outputs 2mV/V full scale. With
a 5V excitation, this translates to a full-scale output of
10mV. Divided by the RMS noise of 4.2
μ
V(= 3
μ
V 1.414),
this circuit yields 2,300 counts with no averaging or
amplification. If more counts are required, several conver-
sions may be averaged (the number of effective counts is
increased by a factor of square root of 2 for each doubling
of averages).
An RTD Temperature Digitizer
RTDs used in remote temperature measurements often
have long lead lengths between the ADC and RTD sensor.
These long lead lengths lead to voltage drops due to
excitation current in the interconnect to the RTD. This
voltage drop can be measured and digitally removed using
the LTC2402 (see Figure 8).
The excitation current (typically 200
μ
A) flows from the
ADC through a long lead length to the remote temperature
sensor (RTD). This current is applied to the RTD, whose
resistance changes as a function of temperature (100
to
400
for 0
°
C to 800
°
C). The same excitation current flows
back to the ADC ground and generates another voltage
drop across the return leads. In order to get an accurate
measurement of the temperature, these voltage drops
must be measured and removed from the conversion
result. Assuming the resistance is approximately the same
V
CC
LTC2402
FS
SET
ZS
SET
SCK
CH0
SDO
F
O
CS
CH1
GND
3-WIRE
SPI INTERFACE
1
5V
9
8
7
10
24012 F08
2
4
3
+
–
V
RTD
P
t
100
5
I
DC
= 0
I
EXCITATION
= 200
μ
A
I
EXCITATION
= 200
μ
A
R2
R1
Figure 8. RTD Remote Temperature Measurement
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2402 | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2402C | 18-Bit Universal Bus Driver With 3-State Outputs 56-TSSOP -40 to 85 |
| LTC2402I | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2402IMS | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2404CG | 4-/8-Channel 24-Bit uPower No Latency ADCs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2401IMS#PBF | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401IMS#TR | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401IMS#TRPBF | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC2402CMS | 功能描述:IC ADC 24BIT 2CH MICROPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2402CMS#PBF | 功能描述:IC ADC 24BIT 2CH MICROPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。