參數資料
型號： LTC2439-1CGN
廠商： LINEAR TECHNOLOGY CORP
元件分類： ADC
英文描述： 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC
中文描述： 16-CH 16-BIT DELTA-SIGMA ADC, SERIAL ACCESS, PDSO28
封裝： 0.150 INCH, PLASTIC, SSOP-28
文件頁數： 17/28頁
文件大?。?/td> 288K
代理商： LTC2439-1CGN
LTC2439-1
17
24391f
APPLICATIOU
Internal Serial Clock, Single Cycle Operation
This timing mode uses an internal serial clock to shift out
the conversion result and a CS signal to monitor and
control the state of the conversion cycle, see Figure 9.
In order to select the internal serial clock timing mode, the
serial clock pin (SCK) must be floating (Hi-Z) or pulled
HIGH prior to the falling edge of CS. The device will not
enter the internal serial clock mode if SCK is driven LOW
on the falling edge of CS. An internal weak pull-up resistor
is active on the SCK pin during the falling edge of CS;
therefore, the internal serial clock timing mode is auto-
matically selected if SCK is not externally driven.
The serial data output pin (SDO) is Hi-Z as long as CS is
HIGH. At any time during the conversion cycle, CS may be
pulled LOW in order to monitor the state of the converter.
Once CS is pulled LOW, SCK goes LOW and EOC is output
to the SDO pin. EOC = 1 while a conversion is in progress
and EOC = 0 if the conversion is complete.
When testing EOC, if the conversion is complete (EOC =0),
the device will exit the low power mode during the EOC
test. In order to allow the device to return to the low power
sleep state, CS must be pulled HIGH before the first rising
W
U
U
edge of SCK. In the internal SCK timing mode, SCK goes
HIGH and the device begins outputting data at time t
EOCtest
after the falling edge of CS (if EOC = 0) or t
EOCtest
after EOC
goes LOW (if CS is LOW during the falling edge of EOC).
The value of t
EOCtest
is 23
μ
s if the device is using its internal
oscillator (F
O
= logic LOW or HIGH). If F
O
is driven by an
external oscillator of frequency f
EOSC
, then t
EOCtest
is
3.6/f
EOSC
. If CS is pulled HIGH before time t
EOCtest
, the
device returns to the sleep state and the conversion result
is held in the internal static shift register.
If CS remains LOW longer than t
EOCtest
, the first rising
edge of SCK will occur and the conversion result is serially
shifted out of the SDO pin. The data I/O cycle concludes
after the 19th rising edge. The input data is then shifted in
via the SDI pin on the rising edge of SCK (including the first
rising edge) and the output data is shifted out of the SDO
pin on each falling edge of SCK. The internally generated
serial clock is output to the SCK pin. This signal may be
used to shift the conversion result into external circuitry.
EOC can be latched on the first rising edge of SCK and the
last bit of the conversion result on the 19th rising edge of
SCK. After the 19th rising edge, SDO goes HIGH (EOC = 1),
SCK stays HIGH and a new conversion starts.
Figure 9. Internal Serial Clock, Single Cycle Operation
(1)
(0)
EN
SGL
A2
A1
A0
ODD/
SIGN
SDI
DON’T CARE
DON’T CARE
SDO
SCK
(INTERNAL)
CS
MSB
SIG
BIT 0
LSB
BIT 6
TEST EOC
BIT 14
BIT 13
BIT 12
BIT 11
BIT 15
BIT 16
BIT 17
EOC
BIT 18
SLEEP
SLEEP
DATA OUTPUT
CONVERSION
CONVERSION
24391 F08
<t
EOCtest
Hi-Z
Hi-Z
Hi-Z
Hi-Z
TEST EOC
V
CC
F
O
REF
+
REF
–
CH0
CH7
CH8
CH15
COM
SCK
SDI
SDO
CS
GND
9
20
11
12
21
28
1
8
10
18
17
15
16
19
REFERENCE
VOLTAGE
0.1V TO V
CC
ANALOG
INPUTS
1
μ
F
2.7V TO 5.5V
LTC2439-1
4-WIRE
SPI INTERFACE
V
CC
10k
= EXTERNAL CLOCK SOURCE
= INTERNAL OSC/SIMULTANEOUS
50Hz/60Hz REJECTION
“O”
相關PDF資料
PDF描述
LTC2439-1 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC
LTC2439-1IGN 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC
LTC2440CGN 24-Bit High Speed Differential delta-sigma ADC with Selectable Speed/Resolution
LTC2440IGN 24-Bit High Speed Differential delta-sigma ADC with Selectable Speed/Resolution
LTC2444 24-Bit High Speed 8-/16-Channel ADCs with Selectable Speed/Resolution
相關代理商/技術參數
參數描述
LTC2439-1CGN#PBF 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2439-1CGN#TR 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2439-1CGN#TRPBF 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC24391IGN 制造商:Linear Technology 功能描述:
LTC2439-1IGN 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*