參數資料
型號: LTC2440IGN#TRPBF
廠商: Linear Technology
文件頁數: 16/28頁
文件大?。?/td> 0K
描述: IC ADC DIFFER 24-BIT HS 16-SSOP
標準包裝: 2,500
位數: 24
采樣率(每秒): 3.5k
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 2
功率耗散(最大): 40mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-SSOP(0.154",3.90mm 寬)
供應商設備封裝: 16-SSOP
包裝: 帶卷 (TR)
輸入數目和類型: 1 個差分,雙極
配用: DC570A-ND - BOARD DELTA SIGMA ADC LTC2440
LTC2440
23
2440fd
APPLICATIONS INFORMATION
Figure 18. Input Capacitors Allow Longer Connection
Between the Low Impedance Source and the ADC.
Direct Connection to Low Impedance Sources
If the ADC can be located physically close to the sensor,
it can be directly connected to sensors or other sources
with impedances up to 350Ω with no other components
required (see Figure 17).
Longer Connections to Low Impedance Sources
If longer lead lengths are unavoidable, adding an input
capacitor close to the ADC input pins will average the
charging pulses and prevent reections or ringing (see
Figure 18). Averaging the current pulses results in a DC
input current that should be taken into account. The re-
sulting 110kΩ input impedance will result in a gain error
of 0.44% for a 350Ω bridge (within the full scale specs
of many bridges) and a very low 12.6ppm error for a 2Ω
thermocouple connection.
Buffering the LTC2440
Many applications will require buffering, particularly
where high impedance sources are involved or where the
device being measured is located some distance from the
LTC2440. When buffering the LTC2440 a few simple steps
should be followed.
Figure 19 shows a network suitable for coupling the inputs
of a LTC2440 to a LTC2051 chopper-stabilized op amp. The
3μV offset and low noise of the LTC2051 make it a good
choice for buffering the LTC2440. Many other op amps
will work, with varying performance characteristics.
The LTC2051 is congured to be able to drive the 1μF ca-
pacitors at the inputs of the LTC2440. The 1μF capacitors
should be located close to the ADC input pins.
The measured total unadjusted error of Figure 19 is well
within the specications of the LTC2440 by itself. Most
autozero ampliers will degrade the overall resolution to
some degree because of the extremely low input noise
of the LTC2440, however the LTC2051 is a good general
purpose buffer. The measured input referred noise of two
LTC2051s buffering both LTC2440 inputs is approximately
double that of the LTC2440 by itself, which reduces the ef-
fective resolution by 1-bit for all oversample ratios. Adding
gain to the LTC2051 will increase gain and offset errors
and will not appreciably increase the overall resolution,
so it has limited benet.
Procedure For Coupling Any Amplier to the LTC2440
The LTC2051 is suitable for a wide range of DC and low
frequency measurement applications. If another ampli-
er is to be selected, a general procedure for evaluating
the suitability of an amplier for use with the LTC2440 is
suggested here:
1. Perform a thorough error and noise analysis on the
amplier and gain setting components to verify that the
amplier will perform as intended.
2. Measure the large signal response of the overall circuit.
The capacitive load may affect the maximum slew rate of
the amplier. Verify that the slew rate is adequate for the
Figure 17. Direct Connection to Low Impedance (<350Ω) Source
is Possible if the Sensor is Located Close to the ADC.
2440 F17
REF+
REF
IN+
IN
LTC2440
1μF
4.5V to 5.5V
2440 F18
1μF
4.5V to 5.5V
REMOTE
THERMOCOUPLE
VREF+ VCC
GND
IN+
IN
LTC2440
1μF
相關PDF資料
PDF描述
LTC2450IDC-1#TRPBF IC ADC 16BIT DELTA SIG 6-DFN
LTC2450IDC#TRPBF IC ADC 16BIT DELTA SIG 6-DFN
LTC2480HMS#TRPBF IC ADC DELTA SIGMA 16BIT 10MSOP
LTC2481HDD#TRPBF IC ADC DELTA SIGMA 16BIT 10DFN
LTC2484IDD#TRPBF IC ADC 24BIT 10-DFN
相關代理商/技術參數
參數描述
LTC2442CG 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 8ksps 24-bit Serial 36-Pin SSOP
LTC2442CG#PBF 功能描述:IC ADC 24BIT 4CH 36-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2442CG#TRPBF 功能描述:IC ADC 24BIT 250MSPS 36-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2442CGPBF 制造商:Linear Technology 功能描述:ADC 8ksps 24-Bit Serial SSOP36
LTC2442IG#PBF 功能描述:IC ADC 24BIT 4CH 36-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極