- 您現在的位置：買賣IC網 > PDF目錄10692 > LTC2488CDE#PBF (Linear Technology)IC ADC 16BIT DELTA SIG 14-DFN PDF資料下載
參數資料
| 型號： | LTC2488CDE#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 5/30頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT DELTA SIG 14-DFN |
| 標準包裝： | 91 |
| 位數： | 16 |
| 采樣率（每秒）： | 6.9 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 800µW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 14-DFN-EP（4x3） |
| 包裝： | 管件 |
| 輸入數目和類型： | 4 個單端，雙極；2 個差分，雙極 |
| 配用： | DC1009A-B-ND - BOARD DELTA SIGMA ADC LTC2488 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
LTC2488
13
2488fa
APPLICATIONS INFORMATION
The serial clock pin (SCK) can be congured as either a
master (SCK is an output generated internally) or a slave
(SCK is an input and applied externally). Master mode
(Internal SCK) is selected by simply oating the SCK pin.
Slave mode (External SCK) is selected by driving SCK low
during power up and each falling edge of CS. Specic
details of these SCK modes are described in the Serial
Interface Timing Modes section.
Serial Data Output (SDO)
The serial data output pin (SDO) provides the result of the
last conversion as a serial bit stream (MSB rst) during
the data output state. In addition, the SDO pin is used as
an end of conversion indicator during the conversion and
sleep states.
When CS is HIGH, the SDO driver is switched to a high
impedance state in order to share the data output line with
other devices. If CS is brought LOW during the conversion
phase, the EOC bit (SDO pin) will be driven HIGH. Once the
conversion is complete, if CS is brought LOW, EOC will be
driven LOW indicating the conversion is complete and the
result is ready to be shifted out of the device.
Chip Select (CS)
The active low CS pin is used to test the conversion status,
enable I/O data transfer, initiate a new conversion, control
the duration of the sleep state, and set the SCK mode.
At the conclusion of a conversion cycle, while CS is HIGH,
the device remains in a low power sleep state where the
supply current is reduced several orders of magnitude. In
order to exit the sleep state and enter the data output state,
CS must be pulled low. Data is now shifted out the SDO pin
under control of the SCK pin as described previously.
A new conversion cycle is initiated either at the conclusion
of the data output cycle (all 24 data bits read) or by pulling
CS HIGH any time between the rst and 24th rising edges
of the serial clock (SCK). In this case, the data output is
aborted and a new conversion begins.
Serial Data Input (SDI)
The serial data input (SDI) is used to select the input
channel. Data is shifted into the device during the data
output/input state on the rising edge of SCK while CS is
low.
OUTPUT DATA FORMAT
The LTC2488 serial output stream is 24 bits long. The
rst bit indicates the conversion status, the second bit is
always zero, and the third bit conveys sign information.
The next 17 bits are the conversion result, MSB rst. The
remaining 4 bits are always LOW.
Bit 23 (rst output bit) is the end of conversion (EOC)
indicator. This bit is available on the SDO pin during the
conversion and sleep states whenever CS is LOW. This
bit is HIGH during the conversion cycle, goes LOW once
the conversion is complete, and is HIGH-Z when CS is
HIGH.
Bit 22 (second output bit) is a dummy bit (DMY) and is
always LOW.
Bit 21 (third output bit) is the conversion result sign
indicator (SIG). If the selected input (VIN = IN+ – IN–) is
greater than or equal to 0V, this bit is HIGH. If VIN < 0,
this bit is LOW.
Bit 20 (fourth output bit) is the most signicant bit (MSB)
of the result. This bit in conjunction with Bit 21 also pro-
vides underrange and overrange indication. If both Bit 21
and Bit 20 are HIGH, the differential input voltage is above
+FS. If both Bit 21 and Bit 20 are LOW, the differential
input voltage is below –FS. The function of these bits is
summarized in Table 1.
Table 1. LTC2488 Status Bits
Input Range
Bit 23
EOC
Bit 22
DMY
Bit 21
SIG
Bit 20
MSB
VIN ≥ 0.5 VREF
0011
0V ≤ VIN < 0.5 VREF
0010
–0.5 VREF ≤ VIN < 0V
0001
VIN < –0.5 VREF
0000
Bits 20 to 4 are the 16-bit plus sign conversion result
MSB rst.
Bit 4 is the least signicant bit (LSB16).
Bits 3 to 0 are always LOW.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B1Z-MW-B1 | CONVERTER MOD DC/DC 2V 40W |
| VI-B1Y-MY-B1 | CONVERTER MOD DC/DC 3.3V 33W |
| AD7904BRUZ | IC ADC 8BIT 4CH 1MSPS 16-TSSOP |
| LTC2483IDD#PBF | IC ADC 16BIT I2C 10-DFN |
| LTC2482IDD#PBF | IC ADC 16BIT 10-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2488IDE#PBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2488IDE#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2489CDE#PBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2489CDE#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2489IDE | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 16-bit Serial 14-Pin DFN EP |
發布緊急采購，3分鐘左右您將得到回復。