- 您現在的位置：買賣IC網 > PDF目錄2084 > LTC2497IUHF#TRPBF (Linear Technology)IC ADC 16BIT W/PGA 38-QFN PDF資料下載
參數資料
| 型號： | LTC2497IUHF#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT W/PGA 38-QFN |
| 標準包裝： | 2,500 |
| 位數： | 16 |
| 采樣率（每秒）： | 7.5 |
| 數據接口： | I²C，串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 480µW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 16 個單端，雙極；8 個差分，雙極 |
| 配用： | DC1012A-B-ND - BOARD DELTA SIGMA ADC LTC2497 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2497
2497fa
Initiating a New Conversion
When the LTC2497 finishes a conversion, it automatically
enters the sleep state. Once in the sleep state, the device is
ready for a read operation. After the device acknowledges
a read request, the device exits the sleep state and enters
the data output state. The data output state concludes and
the LTC2497 starts a new conversion once a Stop condi-
tion is issued by the master or all 24 bits of data are read
out of the device.
Duringthedatareadcycle,aStopcommandmaybeissued
by the master controller in order to start a new conversion
and abort the data transfer. This Stop command must be
issued during the ninth clock cycle of a byte read when
the bus is free (the ACK/NAK cycle).
LTC2497 Address
The LTC2497 has three address pins (CA0, CA1, CA2).
Each may be tied high, low, or left floating enabling one
of 27 possible addresses (see Table 4).
In addition to the configurable addresses listed in Table 4,
the LTC2497 also contains a global address (1110111)
whichmaybeusedforsynchronizingmultipleLTC2497sor
otherLTC24XXdelta-sigmaI2Cdevices,(SeeSynchronizing
Multiple LTC2497s with Global Address Call section).
Operation Sequence
The LTC2497 acts as a transmitter or receiver, as shown
in Figure 4. The device may be programmed to select
an input channel, differential or single-ended mode, and
channel polarity.
Continuous Read
In applications where the input channel does not need to
change for each cycle, the conversion can be continuously
performed and read without a write cycle (see Figure 5).
The input channel remains unchanged from the last value
written into the device. If the device has not been writ-
ten to since power up, the channel selection is set to the
default value of CH0 = IN+, CH1 = IN–. At the end of a read
operation, a new conversion automatically begins. At the
conclusion of the conversion cycle, the next result may
be read using the method described above. If the conver-
Table 4. Address Assignment
CA2
CA1
CA0
ADDRESS
LOW
0010100
LOW
HIGH
0010110
LOW
FLOAT
0010101
LOW
HIGH
LOW
0100110
LOW
HIGH
0110100
LOW
HIGH
FLOAT
0100111
LOW
FLOAT
LOW
0010111
LOW
FLOAT
HIGH
0100101
LOW
FLOAT
0100100
HIGH
LOW
1010110
HIGH
LOW
HIGH
1100100
HIGH
LOW
FLOAT
1010111
HIGH
LOW
1110100
HIGH
1110110
HIGH
FLOAT
1110101
HIGH
FLOAT
LOW
1100101
HIGH
FLOAT
HIGH
1100111
HIGH
FLOAT
1100110
FLOAT
LOW
0110101
FLOAT
LOW
HIGH
0110111
FLOAT
LOW
FLOAT
0110110
FLOAT
HIGH
LOW
1000111
FLOAT
HIGH
1010101
FLOAT
HIGH
FLOAT
1010100
FLOAT
LOW
1000100
FLOAT
HIGH
1000110
FLOAT
1000101
sion cycle is not concluded and a valid address selects
the device, the LTC2497 generates a NAK signal indicating
the conversion cycle is in progress.
Continuous Read/Write
Once the conversion cycle is concluded, the LTC2497 can
be written to and then read from using the Repeated Start
(Sr) command.
Figure 6 shows a cycle which begins with a data Write,
a repeated Start, followed by a Read and concluded with
a Stop command. The following conversion begins after
applicaTions inForMaTion
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2499IUHF#TRPBF | IC ADC 24BIT DELTA SIG 38-QFN |
| LTC6360HDD#TRPBF | IC ADC DRIVER TRUE ZERO 8DFN |
| LTC6400IUD-14#TRPBF | IC ADC DRIVER DIFF 2.4GHZ 16QFN |
| LTC6400IUD-20#TRPBF | IC ADC DRIVER DIFF 16-QFN |
| LTC6400IUD-26#TRPBF | IC ADC DRIVER DIFF 16-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2498CUHF | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 24-bit Serial 38-Pin QFN EP |
| LTC2498CUHF#PBF | 功能描述:IC ADC 24BIT 16CH 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC2498CUHF#TRPBF | 功能描述:IC ADC 24BIT 16CH 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2498HUHF#PBF | 功能描述:IC ADC 24BIT 16CH DELTA 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2498HUHF#TRPBF | 功能描述:IC ADC 24BIT 16CH DELTA 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。