- 您現在的位置：買賣IC網 > PDF目錄8628 > LTC2609CGN-1#PBF (Linear Technology)IC DAC 16BIT R-R QUAD 16SSOP PDF資料下載
參數資料
| 型號： | LTC2609CGN-1#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/22頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT R-R QUAD 16SSOP |
| 標準包裝： | 100 |
| 設置時間： | 10µs |
| 位數： | 16 |
| 數據接口： | 串行 |
| 轉換器數目： | 4 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 750µW |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 4 電壓，單極 |
| 采樣率（每秒）： | * |
| 產品目錄頁面： | 1351 (CN2011-ZH PDF) |
| 配用： | DC936A-ND - BOARD DAC LTC2609 |
LTC2609/LTC2619/LTC2629
26091929fb
operation
loads a 16-bit data word from the 32-bit shift register
into the input register of the selected DAC, n. An update
operation copies the data word from the input register to
the DAC register. Once copied into the DAC register, the
data word becomes the active 16-, 14- or 12-bit input
code, and is converted to an analog voltage at the DAC
output. The update operation also powers up the selected
DAC if it had been in power-down mode. The data path
and registers are shown in the Block Diagram.
Power-Down Mode
Forpower-constrainedapplications,power-downmodecan
be used to reduce the supply current whenever less than
four outputs are needed. When in power-down, the buffer
amplifiers, bias circuits and reference inputs are disabled,
and draw essentially zero current. The DAC outputs are
put into a high impedance state, and the output pins are
passively pulled to REFLO through individual 90k resis-
tors. Input- and DAC-register contents are not disturbed
during power down.
Any channel or combination of channels can be put into
power-down mode by using command 0100b in combi-
nation with the appropriate DAC address, (n). The 16-bit
data word is ignored. The supply current is reduced by
approximately 1/4 for each DAC powered down. The effec-
tive resistance at REFx (Pins 3, 6, 12 and 15) are at high
impedance(typically>1GΩ)whenthecorrespondingDACs
are powered down. Normal operation can be resumed by
executing any command which includes a DAC update,
as shown in Table 2.
The selected DAC is powered up as its voltage output is
updated. When a DAC which is in a powered-down state
is powered up and updated, normal settling is delayed. If
less than four DACs are in a powered-down state prior to
the update command, the power-up delay time is 5s. If on
the other hand, all four DACs are powered down, then the
C3
1ST DATA BYTE
Input Word (LTC2609)
Write Word Protocol for LTC2609/LTC2619/LTC1629
C2 C1 C0 A3
D13
D14
D15
S
W
A
SLAVE ADDRESS
1ST DATA BYTE
D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
A
2ND DATA BYTE
A 3RD DATA BYTE
A
P
2609 F03
2ND DATA BYTE
INPUT WORD
3RD DATA BYTE
C3
1ST DATA BYTE
Input Word (LTC2619)
C2 C1 C0 A3
D11
D12
D13
D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
X
2ND DATA BYTE
3RD DATA BYTE
C3
1ST DATA BYTE
Input Word (LTC2629)
C2 C1 C0 A3
A2
A1
A0
D9
D10
D11
D8 D7 D6 D5 D4 D3 D2 D1 D0
X
2ND DATA BYTE
3RD DATA BYTE
Figure 3
Table 2
COMMAND*
C3 C2 C1 C0
0
0 Write to Input Register n
0
1 Update (Power Up) DAC Register n
0
1
0 Write to Input Register n, Update (Power Up) All n
0
1
1 Write to and Update (Power Up) n
0
1
0
0 Power Down n
1
1 No Operation
ADDRESS (n)*
A3 A2 A1 A0
0
0 DAC A
0
1 DAC B
0
1
0 DAC C
0
1
1 DAC D
1
1 All DACs
*Command and address codes not shown are reserved and should not be used.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J31-MW-S | CONVERTER MOD DC/DC 12V 100W |
| VI-25J-MW-B1 | CONVERTER MOD DC/DC 36V 100W |
| VI-254-MW-B1 | CONVERTER MOD DC/DC 48V 100W |
| VE-2WJ-IV-F3 | CONVERTER MOD DC/DC 36V 150W |
| VI-B3R-MX-S | CONVERTER MOD DC/DC 7.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2609IGN#PBF | 功能描述:IC DAC 16BIT R-R QUAD 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC2609IGN#TRPBF | 功能描述:IC DAC 16BIT R-R QUAD 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| LTC2609IGN-1#PBF | 功能描述:IC DAC 16BIT R-R QUAD 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| LTC2609IGN-1#TRPBF | 功能描述:IC DAC 16BIT R-R QUAD 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| LTC2610CGN | 功能描述:IC DAC OCTAL R-R 14BIT 16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。