- 您現在的位置：買賣IC網 > PDF目錄10789 > LTC2870IUFD#PBF (Linear Technology)IC TXRX RS485/RS422 28-QFN PDF資料下載
參數資料
| 型號： | LTC2870IUFD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/36頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX RS485/RS422 28-QFN |
| 產品培訓模塊： | LTC2870 and LTC2871 Multi-Protocol Transceivers |
| 標準包裝： | 73 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/2 |
| 規程： | RS232，RS422，RS485 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 28-QFN（4x5） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC2870/LTC2871
19
28701f
Overview
The LTC2870 and LTC2871 are flexible multiprotocol trans-
ceivers supporting RS485/RS422 and RS232 protocols.
These parts can be powered from a single 3V to 5.5V
supply with optional logic interface supply as low as 1.7V.
An integrated DC/DC converter provides the positive and
negative supply rails needed for RS232 operation. Auto-
matically selected integrated termination resistors for both
RS232 and RS485 protocols are included, eliminating the
need for external components and switching relays. Both
parts include loopback control for self-test and debug as
well as logically-switchable half- and full-duplex control
of the RS485 bus interface.
The LTC2870 offers a single port that can be configured
as either two RS232 receivers and drivers or one RS485/
RS422 receiver and driver depending on the state of the
485/232 pin. Control inputs DXEN and RXEN provide
independent control of driver and receiver operation for
either RS232 or RS485 transceivers, depending on the
selected operating protocol.
The LTC2871 separates the RS232 and RS485 transceivers
into independent I/Os allowing simultaneous operation
of two RS232 transceivers and one RS485 transceiver.
Independent control over driver and receiver mode for
each protocol is provided with logic inputs DX232, RX232,
DX485, RX485. Single channel RS232 operation is possible
via the CH2 control pin. The disabled channel maintains a
Hi-Z state on the receiver input and driver output, allowing
these lines to be shared with other transceivers.
Both parts feature rugged operation with ESD ratings
of ±26kV (LTC2870) and ±16kV (LTC2871) HBM on the
RS232 and RS485 receiver inputs and driver outputs, both
unpowered and powered. All other pins offer protection
exceeding ±4kV.
DC/DC Converter
The on-chip DC/DC converter operates from the VCC input,
generating a 7V VDD supply and a charge pumped –6.3V
VEE supply, as shown in Figure 13. VDD and VEE power
the output stage of the RS232 drivers and are regulated
to levels that guarantee greater than ±5V output swing.
The DC/DC converter requires a 10μH inductor (L1) and a
bypass capacitor (C4) of 2.2μF. The charge pump capacitor
(C1) is 220nF and the storage capacitors (C2 and C3) are
1μF. Larger storage capacitors up to 4.7μF may be used if
C1 and C4 are scaled proportionately. Locate C1–C4 close
to their associated pins.
Up to two LTC2870 or LTC2871 devices can be powered
from one of the devices; see Figure 48 in the Typical Ap-
plications section.
Inductor Selection
A 10μH inductor with a saturation current (ISAT) rating
of at least 220mA and a DCR (copper wire resistance) of
less than 1.3Ω is required. Some small inductors meeting
these requirements are listed in Table 12.
Table 12. Recommended Inductors
PART NUMBER
ISAT
(mA)
MAX
DCR (Ω)
SIZE(mm)
MANUFACTURER
LBC2016T100K
CBC2016T100M
245
380
1.07
2 × 1.6 × 1.6
Taiyo Yuden
www.t-yuden.com
FSLB2520-100K
220
1.1
2.5 × 2 × 1.6
Toko
www.tokoam.com
Capacitor Selection
The small size of ceramic capacitors makes them ideal
for the LTC2870 and LTC2871. Use X5R or X7R dielectric
types; their ESR is low and they retain their capacitance
over relatively wide voltage and temperature ranges. Use
a voltage rating of at least 10V.
APPLICATIONS INFORMATION
Figure 13. DC/DC Converter
28701 F13
3V TO 5.5V
C1
220nF
L1
10μH
C4
2.2μF
VCC
VDD
VEE
SW
CAP
C2
1μF
C3
1μF
PULSE-SKIPPING
BOOST
REGULATOR
f = 1.2MHz
相關PDF資料 |
PDF描述 |
|---|---|
| SY58620LMG | TXRX 4.25GBPS CML OUT 24-MLF |
| VE-JT0-MY-S | CONVERTER MOD DC/DC 5V 50W |
| VI-BNJ-MW | CONVERTER MOD DC/DC 36V 100W |
| LTC1657LIGN#TRPBF | IC DAC 16BIT R-R MICROPWR 28SSOP |
| VE-J4H-MY-S | CONVERTER MOD DC/DC 52V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2871CFE#PBF | 功能描述:IC TXRX RS485/RS422 38-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6 |
| LTC2871CFE#TRPBF | 功能描述:IC TXRX RS485/RS422 38-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LTC2871CUHF#PBF | 功能描述:IC TXRX RS485/RS422 38-QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| LTC2871CUHF#TRPBF | 功能描述:IC TXRX RS485/RS422 38-QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LTC2871IFE#PBF | 功能描述:IC TXRX RS485/RS422 38-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
發布緊急采購，3分鐘左右您將得到回復。