參數資料
型號: LTC3388IMSE-3#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 0.21 A SWITCHING REGULATOR, PDSO10
封裝: LEAD FREE, PLASTIC, MSOP-10
文件頁數: 5/20頁
文件大?。?/td> 282K
代理商: LTC3388IMSE-3#TRPBF
LTC3388-1/LTC3388-3
13
338813f
OPERATION
Enable and Standby Modes
Two logic pins, EN and STBY, determine the operating
mode of the LTC3388-1/LTC3388-3. When EN is high and
STBY is low the synchronous buck converter is enabled
and will regulate the output if the input voltage is above
the programmed output voltage and above the UVLO
threshold. If EN is low the buck converter circuitry is
powered down to save quiescent current. The internal rail
generation circuits are kept alive and the voltages at VIN2
and CAP are maintained. When low, EN also shuts down
the PGOOD circuitry and pulls the PGOOD pin low. If EN
is high and the input falls below the UVLO threshold, the
buck converter is shut down.
While enabled, the LTC3388-1/LTC3388-3 can be placed
in standby mode by bringing STBY high. In standby mode
the buck converter is disabled, eliminating the quiescent
current used to run the buck circuitry. The PGOOD and
sleep comparators are kept alive to maintain the state of
the PGOOD pin.
The sleep comparator has lower quiescent current than the
PGOOD comparator and when the LTC3388-1/LTC3388-3
is in sleep mode the PGOOD comparator is shut down and
PGOOD is held high. The same occurs in standby mode.
If the LTC3388-1/LTC3388-3 was in sleep before entering
standby it will stay in sleep in standby, saving the quiescent
current of the PGOOD comparator. If VOUT falls below the
sleep falling threshold the PGOOD comparator will be
enabled. If VOUT falls below the PGOOD falling threshold
the PGOOD pin will be pulled low.
If STBY is driven high with EN low it will be ignored and
the LTC3388-1/LTC3388-3 will remain shut down.
If EN and STBY are driven high but near VIH or low but near
VIL, additional quiescent current may appear on VIN. This
additional quiescent current is typically 40nA and depends
on VIN and temperature. Driving EN or STBY to 0V or VIN2
will prevent additional quiescent current on VIN.
Figure 4 shows VOUT during a transition into and out of
standby. While in standby, the buck is off and VOUT is
quiet.
Figure 4. LTC3388-3 Standby Transient,
VOUT = 3.3V, ILOAD = 5mA
500μs/DIV
0V
VOUT
50mV/DIV
AC-COUPLED
VIN = 5.5V,
L = 22μH, COUT = 100μF
STANDBY TRANSIENT
STANDBY
5V/DIV
338813 F04
相關PDF資料
PDF描述
LTC3388EDD-1#TRPBF 0.21 A SWITCHING REGULATOR, PDSO10
LTC3388EMSE-1#TRPBF 0.21 A SWITCHING REGULATOR, PDSO10
LTC3388IDD-1#TRPBF 0.21 A SWITCHING REGULATOR, PDSO10
LTC3388IMSE-1#TRPBF 0.21 A SWITCHING REGULATOR, PDSO10
LTC3419EDD-1#TR 1.2 A DUAL SWITCHING CONTROLLER, 2250 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
LTC3400 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23
LTC3400/LTC3400B 制造商:LINER 制造商全稱:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN
LTC3400-1 制造商:LINER 制造商全稱:Linear Technology 功能描述:600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT
LTC3400B 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23
LTC3400BES6 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 0.5V to 6V 6-Pin TSOT-23