- 您現在的位置：買賣IC網 > PDF目錄377774 > LTC3443 (Linear Technology Corporation) 700mA Low Noise High Current LED Charge Pump PDF資料下載
參數資料
| 型號： | LTC3443 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 700mA Low Noise High Current LED Charge Pump |
| 中文描述： | 700mA的低噪音，高電流LED電荷泵 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 162K |
| 代理商： | LTC3443 |
LTC3215
8
3215f
V
IN
, CPO Capacitor Selection
The value and type of capacitors used with the LTC3215
determine several important parameters such as regulator
control loop stability, output ripple, charge pump strength
and minimum start-up time.
To reduce noise and ripple, it is recommended that low
equivalent series resistance (ESR) ceramic capacitors be
used for both C
VIN
and C
CPO
. Tantalum and aluminum
capacitors are not recommended because of their high ESR.
The value of C
CPO
directly controls the amount of output
ripple for a given load current. Increasing the size of
C
CPO
will reduce the output ripple at the expense of higher
start-up current. The peak-to-peak output ripple for 1.5x
mode is approximately given by the expression:
V
RIPPLE(P-P)
= I
OUT
/(3f
OSC
C
CPO
)
Where f
OSC
is the LTC3215’s oscillator frequency (typi-
cally 900kHz) and C
CPO
is the output storage capacitor.
Both the style and value of the output capacitor can
significantly affect the stability of the LTC3215. As shown
in the block diagram, the LTC3215 uses a control loop to
adjust the strength of the charge pump to match the
current required at the output. The error signal of this loop
is stored directly on the output charge storage capacitor.
The charge storage capacitor also serves as the dominant
pole for the control loop. To prevent ringing or instability,
it is important for the output capacitor to maintain at least
2.2
μ
F of actual capacitance over all conditions.
Likewise, excessive ESR on the output capacitor will tend
to degrade the loop stability of the LTC3215. The closed
loop output resistance of the LTC3215 is designed to be
76m
. For a 100mA load current change, the error signal
will change by about 7.6mV. If the output capacitor has
76m
or more of ESR, the closed-loop frequency re-
sponse will cease to roll off in a simple one-pole fashion
and poor load transient response or instability could
result. Multilayer ceramic chip capacitors typically have
exceptional ESR performance. MLCCs combined with a
tight board layout will yield very good stability. As the value
of C
CPO
controls the amount of output ripple, the value of
C
VIN
controls the amount of ripple present at the input pin
(V
IN
). The input current to the LTC3215 will be relatively
constant while the charge pump is on either the input
(3)
charging phase or the output charging phase but will drop
to zero during the clock nonoverlap times. Since the
nonoverlap time is small (~15ns), these missing “notches”
will result in only a small perturbation on the input power
supply line. Note that a higher ESR capacitor such as
tantalum will have higher input noise due to the input
current change times the ESR. Therefore, ceramic capaci-
tors are again recommended for their exceptional ESR
performance. Input noise can be further reduced by pow-
ering the LTC3215 through a very small series inductor as
shown in Figure 3. A 10nH inductor will reject the fast
current notches, thereby presenting a nearly constant
current load to the input power supply. For economy, the
10nH inductor can be fabricated on the PC board with
about 1cm (0.4") of PC board trace.
Flying Capacitor Selection
APPLICATIU
W
U
U
Figure 3. 10nH Inductor Used for Input Noise Reduction
(Approximately 1cm of Wire)
Warning: Polarized capacitors such as tantalum or alumi-
num should never be used for the flying capacitors since
their voltage can reverse upon start-up of the LTC3215.
Ceramic capacitors should always be used for the flying
capacitors.
The flying capacitors control the strength of the charge
pump. In order to achieve the rated output current it is
necessary to have at least 2.2
μ
F of actual capacitance for
each of the flying capacitors. Capacitors of different mate-
rials lose their capacitance with higher temperature and
voltage at different rates. For example, a ceramic capacitor
made of X7R material will retain most of its capacitance from
–40
o
C to 85
o
C whereas a Z5U or Y5V style capacitor
will lose considerable capacitance over that range. Z5U and
Y5V capacitors may also have a very poor voltage coeffi-
cient causing them to lose 60% or more of their capacitance
when the rated voltage is applied. Therefore, when compar-
ing different capacitors, it is often more appropriate to
V
IN
GND
LTC3215
2.2
μ
F
0.1
μ
F
10nH
3215 F03
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3216EDE | 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control |
| LT3467 | 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control |
| LT3467A | 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control |
| LTC3216 | Single Cell 350mA LED Driver |
| LTC3400ES6 | 600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3443EDE | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3443EDE#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3443EDE#TR | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3443EDE#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3444 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Effi ciency, Synchronous, 4-Switch Buck-Boost Controller |
發布緊急采購，3分鐘左右您將得到回復。