- 您現在的位置：買賣IC網 > PDF目錄383291 > LTC3456EUF (LINEAR TECHNOLOGY CORP) ECONOLINE: RSZ/P - 1kVDC PDF資料下載
參數資料
| 型號： | LTC3456EUF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | ECONOLINE: RSZ/P - 1kVDC |
| 中文描述： | 0.9 A BATTERY CHARGE CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, PLASTIC, MO-220-WGGD, QFN-24 |
| 文件頁數： | 19/28頁 |
| 文件大小： | 358K |
| 代理商： | LTC3456EUF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
19
LTC3456
3456f
VOLTAGE MONITORS
Low-Battery Detection
The LTC3456 has an on-chip gain block that can be used
for low-battery detection. The low-battery trip point can be
set by two resistors (Figure 10). The nominal voltage at
AIN is 0.8V. If the voltage at AIN falls below 0.8V, AO sinks
current to ground.
The battery minimum voltage can be set according to the
formula:
R
R
1
The AIN input bias current is quite low, on the order of 2nA
(typ). Large resistor values (R2 ~ 100k) can be used in the
divider network. This helps in minimizing the loading on
the battery. AO is an open-drain logic output. The voltage
at AIN must always be kept less than 2V. If the gain block
is not used then connect AIN to ground.
There is no built-in hysteresis in the gain block. Hysteresis
can be added by connecting resistor R4 from AIN to AO as
shown in Figure 10. Ensure that R4
10R3 for correct
operation. With the values shown in Figure 10b, the circuit
has 180mV of hysteresis.
V
V
BATT MIN
(
)
.
=
+
0 8
1
2
Figure 10. Low-Battery Detector (10a) and
Low-Battery Detector with Hysteresis (10b)
Figure 11. Generating Auxiliary Voltage Supply
(10b)
V
CORE
R4
1M
R3
100k
3456 F10
R2
100k
R1
80.6k
V
BATT
LTC3456
AIN
AO
(10a)
V
CORE
R3
100k
R2
100k
R1
80.6k
V
1.8V TO 3.2V
LTC3456
AIN
AO
100k
2.2
μ
F
V
3.3V
20.5k
43.2k
3456 F11
V
2.5V
20mA
Q1
PHILIPS
MMBT3906
LTC3456
AIN
AO
The gain block can be configured to drive an external PNP
transistor and generate an auxiliary voltage as shown in
Figure 11. An auxiliary output voltage 2.5V/20mA is gen-
erated from the V
MAIN
(3.3V) power supply.
External Power Detection
The LTC3456 has an EXT_PWR output pin to indicate the
presence of USB or wall power. Whenever the WALLFB pin
is pulled higher than 1.25V (AC adapter present), or the
USB input is greater than 4V and the SUSPEND pin is low
(USB power available), the EXT_PWR pin is pulled to
ground. When pulled low, this pin is capable of sinking
5mA suitable for driving an external LED. Otherwise, this
pin is in a high impedance state.
Overtemperature Protection
The maximum allowable junction temperature for LTC3456
is 125
°
C. In normal operation, the IC does not dissipate
much heat and its junction temperature stays well below
125
°
C at an ambient temperature of 85
°
C or less. If the
junction temperature exceeds 150
°
C, the Core, Main and
Hot Swap outputs are turned off and RESET is pulled low.
The V
INT
output stays alive in this state. The Core and Main
outputs will remain off until the die temperature falls below
150
°
C, regardless of the state of the PWRKEY and PWRON
inputs.
OPERATIOU
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3828EG | Dual 2-Phase Step-Down Controller with Tracking |
| LTC3828EUH | Model HB Series Horizontal Stacking Banana Plug Patch Cord, Banana Plug Each End Operating Voltage 30VAC/60VDC Max, Current-15A Cont, Operating Temp Max +55 degrees C, Color-Red, Length-24" RoHS Compliant: Yes |
| LTC3828 | 16-Bit Bus Transceiver With 3-State Outputs 48-SSOP -40 to 85 |
| LTC486 | Quad Low Power RS485 Driver |
| LTC486C | ; LED Color:Red; Luminous Intensity:63mcd; Viewing Angle:80 ; Forward Current:20mA; Forward Voltage:2.1V; Operating Temperature Range:-40 C to +100 C RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3456EUF#PBF | 功能描述:IC CONV DC/DC USB BATT 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3456EUF#TRPBF | 功能描述:IC CONV DC/DC USB BATT 24-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3458 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.7A, 1.5MHz Synchronous Step-Up DC/DC Converter with Output Disconnect |
| LTC3458EDE | 功能描述:IC REG BOOST SYNC ADJ 1.4A 12DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3458EDE#PBF | 功能描述:IC REG BOOST SYNC ADJ 1.4A 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
發布緊急采購，3分鐘左右您將得到回復。