- 您現在的位置：買賣IC網 > PDF目錄377777 > LTC4221CGN (LINEAR TECHNOLOGY CORP) Dual Hot Swap Controller/ Power Sequencer with Dual Speed, Dual Level Fault Protection PDF資料下載
參數資料
| 型號： | LTC4221CGN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Dual Hot Swap Controller/ Power Sequencer with Dual Speed, Dual Level Fault Protection |
| 中文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 311K |
| 代理商： | LTC4221CGN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
13
LTC4221
4221f
APPLICATIOU
Undervoltage Lockout
An internal undervoltage lockout (UVLO) occurs if either
V
CC
supply is too low for normal operation. The LTC4221
is kept in lockout mode in which the internal charge pumps
are off, the GATE pins, TIMER are held low by internal
N-channel MOSFET pull-downs and the FAULT latch reset,
cutting off both channels. V
CC1
has a low-to-high UVLO
threshold of 2.5V with 110mV hysteresis. V
CC2
has a low-
to-high UVLO threshold of 0.8V with 25mV hysteresis.
Both UVLOs have glitch filters that filter out dips that are
less than 30
μ
s, allowing for bus supply transients. An
additional requirement for normal operation is V
CC1
≥
V
CC2
.
W
U
U
ON Pin Functions
The ON1 pin serves as a global reset for the LTC4221. It
has an internal reset comparator with a high-to-low thresh-
old of 0.4V, a 25mV hysteresis and a high-to-low glitch
filter of 15
μ
s. Pulling ON1 below this threshold will put the
LTC4221 into a reset state in which the TIMER is pulled low
by an internal N-channel MOSFET pull-down, the GATE
pins are pulled low by separate internal 100
μ
A pull-downs
and the FAULT latch resets. A low-to-high transition on the
ON1 pin past the reset threshold releases the reset on the
FAULT latch and both channels go into an off state.
In addition to its global reset function, ON1 also serves as
an on/off switch for channel 1. ON2 performs the same
role for channel 2. Both pins have an off comparator with
a high-to-low threshold of 0.821V and 30mV hysteresis.
With these, ON1 and ON2 can be used to force a simulta-
neous or sequential power-up/power-down of the two
channels. A simultaneous power-up and power-down is
shown in Figure 2b. Both V
CC
pins clear their respective
UVLO at time point 1 and both channels enter reset state.
When ON1 clears its reset threshold, either ON1 or ON2
clears its off threshold, both GATEs < 0.4V and TIMER <
0.4V (time point 2), an initial timing cycle starts. At time
point 4, the initial timing cycle completes and the LTC4221
checks that FILTER is low and FAULT is high. If both
conditions are met, it then monitors the voltage of ON1 and
ON2. As long as its ON pin has cleared its off threshold,
each channel powers up regardless of the state of the other
channel. Similarly, if its ON pin goes below its off thresh-
old, each channel pulls its GATE pin down with an internal
100
μ
A pull-down and turns off its external MOSFET re-
gardless of the state of the other channel. As the circuit in
Figure 2a has its two ON pins shorted together, a simulta-
neous power-up is programmed at time points 4 to 5 and
a simultaneous power down is programmed between time
points 7 and 8. The timing waveforms in Figure 3 show a
+
V
CC1
ON1
ON2
LTC4221*
SENSE1
R
F2
15k
GATE1
FB1
4221 F02a
4221 F02b
1
16
10
9
C
TIMER
1
μ
GND
TIMER
(2a) Circuit
(2b) Timing Waveforms
R
F1
56k
V
3.3V
5A
V
2.5V
5A
Q1
IRF7413
R
0.004
C
LOAD1
Z1
Z1 = SMAJ10
* ADDITIONAL DETAILS
OMITTED FOR CLARITY
R
X1
10
C
100nF
R1
10k
R2
10k
LONG
LONG
V
CC1
V
CC2
LONG
PCB EDGE
CONNECTOR
(MALE)
SHORT
BACKPLANE
CONNECTOR
(FEMALE)
DISCHARGE
BY LOAD
1
V
CCn
V
OUTn
ONn
GATEn
UVLO
TIMING
CHANNEL
START-UP
RESET STATE
TIMER
0.851V
1.234V
1.9
μ
A
0.821V
9.5
μ
A
100
μ
A
V
TH
20
μ
A
2
3 4
5 6
7 8
NORMAL
RESET
V
CCn(UVL)
Figure 2. Simultaneous Power On/Off
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4221IGN | Dual Hot Swap Controller/ Power Sequencer with Dual Speed, Dual Level Fault Protection |
| LTC4221 | Dual Hot Swap Controller/ Power Sequencer with Dual Speed, Dual Level Fault Protection |
| LTC4240 | CompactPCI Hot Swap Controller with I2C Compatible Interface |
| LTC4240IGN | CompactPCI Hot Swap Controller with I2C Compatible Interface |
| LTC4240CGN | CompactPCI Hot Swap Controller with I2C Compatible Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4221CGN#PBF | 功能描述:IC CTLR HOT SWAP DUAL 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LTC4221CGN#TR | 功能描述:IC CTRLR HOTSWAP DUAL 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LTC4221CGN#TRPBF | 功能描述:IC CTRLR HOTSWAP DUAL 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LTC4221IGN | 功能描述:IC CTRLR HOTSWAP DUAL 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LTC4221IGN#PBF | 功能描述:IC CTRLR HOTSWAP DUAL 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。