- 您現在的位置：買賣IC網 > PDF目錄11614 > LTC4311CDC#TRPBF (Linear Technology)IC ACCELERATOR I2C/SMBUS 6-DFN PDF資料下載
參數資料
| 型號： | LTC4311CDC#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ACCELERATOR I2C/SMBUS 6-DFN |
| 產品培訓模塊： | LTC4310 - Hot-Swappable I²C Isolators |
| 標準包裝： | 2,500 |
| 類型： | SMBus 加速器 |
| Tx/Rx類型： | I²C Logic |
| 電源電壓： | 1.6 V ~ 5.5 V |
| 電流 - 電源： | 300µA |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 6-DFN-EP（2x2） |
| 包裝： | 帶卷 (TR) |
LTC4311
10
4311fa
APPLICATIONS INFORMATION
t
2 = –13kΩ 400pF
In
2.1V
+ 0.15V – 3.3V – 13kΩ2.5mA
0.9V – 3.3V – 13k
Ω2.5mA
= 0.205s
(20)
t
r = t1 + t2 = 0.515s + 0.205s = 0.72s
(21)
t
f = 293Ω 400pF
In
2.1V
+ 0.15V
3.3V
(13k
Ω+ 300Ω)– 300Ω
0.8V – 0.15V
3.3V
(13k
Ω+ 300Ω)– 300Ω
= 0.156s
(22)
The rise time meets the 1μs SMBus requirement and the
fall time meets the 0.3μs requirement. The VOL is satised
while meeting the minimum slew rate requirements, so RP
is chosen to be 13kΩ. If the rise time was not met due to
a large t1, equation 6 can be used to calculate a maximum
value of RP that will meet the rise time requirements.
ACK Data Setup Time
Care must be taken in selecting the value of RS (in series
with the pull-down driver) to ensure that the data setup
time requirement for ACK (acknowledge) is fullled. An
acknowledge is the host releasing the SDA line (pulling
high) at the end of the last bit sent and the slave device
pulling the SDA line low before the rising edge of the ACK
clock pulse.
The LTC4311 5mA pull-up current is activated when the
host releases the SDA line, allowing the voltage to rise
above the LTC4311’s comparator threshold (VTHR). If
a slave device has a high value of RS, a longer time is
required for the slave device to pull SDA low before the
rising edge of the ACK clock pulse. To ensure sufcient
data setup time for ACK, slave devices with high values
of RS should pull the SDA low earlier.
An alternative is the slave device can hold the SCL line low
until the SDA line reaches a stable state. Then, SCL can
be released to generate the ACK clock pulse.
Multiple LTC4311s in Parallel
In very heavily loaded systems, stronger pull up current
may be desired. Two LTC4311’s may be used in parallel
to increase the total pull up current to meet rise time
requirements.
Notes on Using the LTC4311 in LTC1694 Applications
Although the LTC1694 and LTC4311 are functionally similar
accelerators for I2C, SMBus, and other comparable open
drain/collector bus applications, the LTC4311 offers a lower
power, higher performance solution in a smaller package
as compared to the LTC1694. These and other differences
are listed in Table 1 and must be accounted for if using
the LTC4311 in LTC1694 applications.
Table 1. Differences Between LTC1694 and LTC4311
SPECIFICATION
LTC1694
LTC4311
COMMENTS
Enable Pin (typ)
N/A
1V
Allows the LTC4311 to be Disabled, Consuming Less than 5μA
VCC
2.7V – 6V
1.6V – 5.5V
Lower Operating Supply Voltage for Low Voltage Systems
ICC (typ), BUS1, BUS2 High
60μA
26μA
Lower Standby Current to Conserve Power
VTHRES (typ)
0.65V
Dependent on VCC
Tighter, Higher Noise Margins and Improved Rise Times
IPULL-UP (typ)
2.2mA
5mA
Stronger Slew-Limited Source Current for Slewing Higher Bus Capacitances
fMAX
100kHz
400kHz
Higher Operating Frequency for I2C’s Fast Mode Bus Specication
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4311CSC6#TRPBF | IC ACCELERATOR SMBUS DL SC70-6 |
| D38999/24MJ4PN | CONN RCPT 56POS JAM NUT W/PINS |
| D38999/26JH53SA | CONN PLUG 53POS STRAIGHT W/SCKT |
| D38999/20JJ43SA | CONN RCPT 43POS WALL MNT W/SCKT |
| PT08E-14-19S | CONN PLUG 19 POS R/A W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4311CSC6#PBF | 制造商:Linear Technology 功能描述:I2C/SMBus Accelerator 6-Pin SC-70 制造商:Linear Technology 功能描述:IC I2C / SMBUS ACCELERATOR 6 制造商:Linear Technology 功能描述:IC, I2C / SMBUS ACCELERATOR, 6SC-70 制造商:Linear Technology 功能描述:I2C/SMBUS ACCELERATOR, 5.5V, SC-70-6; IC Interface Type:I2C; Interface Applications:Battery Chargers, Industrial Control, Notebook and Palmtop Computers, Portable Instruments, TV/Video; Supply Voltage Min:1.6V; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC4311CSC6#TRMPBF | 功能描述:IC ACCELERATOR SMBUS DL SC70-6 RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4311CSC6#TRPBF | 功能描述:IC ACCELERATOR SMBUS DL SC70-6 RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4311IDC#TRMPBF | 功能描述:IC ACCELERATOR SMBUS DL 6-DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4311IDC#TRPBF | 功能描述:IC ACCELERATOR SMBUS DL 6-DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
發布緊急采購，3分鐘左右您將得到回復。