- 您現在的位置：買賣IC網 > PDF目錄10035 > LTC487ISW#TRPBF (Linear Technology)IC DVR RS485 LOW PWR QUAD 16SOIC PDF資料下載
參數資料
| 型號： | LTC487ISW#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DVR RS485 LOW PWR QUAD 16SOIC |
| 標準包裝： | 1,000 |
| 類型： | 驅動器 |
| 驅動器/接收器數： | 4/0 |
| 規程： | RS422，RS485 |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
LTC487
487fc
applicaTions inForMaTion
AC Cable Termination
Cable termination resistors are necessary to prevent un-
wanted reflections, but they consume power. The typical
differential output voltage of the driver is 2V when the
cable is terminated with two 120 resistors, causing
33mA of DC current to flow in the cable when no data is
being sent. This DC current is about 220 times greater than
the supply current of the LTC487. One way to eliminate
the unwanted current is by AC coupling the termination
resistors as shown in Figure 10.
LTC487 TA11
C = LINE LENGTH (FT) 16.3pF
120
RECEIVER
RX
C
Figure 10. AC-Coupled Termination
The coupling capacitor must allow high-frequency energy
to flow to the termination, but block DC and low frequen-
cies. The dividing line between high and low frequency
depends on the length of the cable. The coupling ca-
pacitor must pass frequencies above the point where the
line represents an electrical one-tenth wavelength. The
value of the coupling capacitor should therefore be set at
16.3pF per foot of cable length for 120 cables. With the
coupling capacitors in place, power is consumed only
on the signal edges, and not when the driver output is
idling at a 1 or 0 state. A 100nF capacitor is adequate for
lines up to 4000 feet in length. Be aware that the power
savings start to decrease once the data rate surpasses
1/(120 C).
Receiver Open-Circuit Fail-Safe
Some data encoding schemes require that the output of
the receiver maintains a known state (usually a logic 1)
when the data is finished transmitting and all drivers on
the line are forced into three-state. All LTC RS485 receivers
have a fail-safe feature which guarantees the output to be
in a logic 1 state when the receiver inputs are left floating
(open-circuit). However, when the cable is terminated with
120, the differential inputs to the receiver are shorted
together, not left floating. Because the receiver has about
70mV of hysteresis, the receiver output will maintain the
last data bit received.
If the receiver output must be forced to a known state, the
circuits of Figure 11 can be used.
LTC487 TA12
140
RECEIVER
RX
5V
1.5k
RECEIVER
RX
5V
110
130
110
130
120
RECEIVER
RX
C
5V
100k
1.5k
Figure 11. Forcing ‘0’ When All Drivers Are Off
The termination resistors are used to generate a DC
bias which forces the receiver output to a known state,
in this case a logic 0. The first method consumes about
208mW and the second about 8mW. The lowest power
solution is to use an AC termination with a pull-up resis-
tor. Simply swap the receiver inputs for data protocols
ending in logic 1.
Fault Protection
All of LTC’s RS485 products are protected against ESD
transients up to 2kV using the human body model
(100pF, 1.5k). However, some applications need more
protection. The best protection method is to connect a
bidirectional TransZorb from each line side pin to ground
(Figure 12).
相關PDF資料 |
PDF描述 |
|---|---|
| MS27466T15B35P | CONN RCPT 37POS WALL MNT W/PINS |
| MS27467T19B32SC | CONN PLUG 32POS STRAIGHT W/SCKT |
| AD9271BSVZRL-50 | IC ADC OCT 12BIT 50MSPS 100-TQFP |
| VE-J6Z-EY-S | CONVERTER MOD DC/DC 2V 20W |
| MS27656T15B19PB | CONN RCPT 19POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC488CN | 功能描述:IC LINE RCVR RS485 QUAD 16-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LTC488CN#PBF | 功能描述:IC LINE RCVR RS485 QUAD 16-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| LTC488CNPBF | 制造商:Linear Technology 功能描述:LTC488CNPBF |
| LTC488CS | 制造商:Linear Technology 功能描述:Quad RS485 Line Receiver |
| LTC488CSW | 功能描述:IC LINE RCVR RS485 QUAD 16-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。