- 您現在的位置：買賣IC網 > PDF目錄5300 > LTC6101HVACS5#TRPBF (Linear Technology)IC AMP CURRENT SENSE TSOT23-5 PDF資料下載
參數資料
| 型號： | LTC6101HVACS5#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP CURRENT SENSE TSOT23-5 |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流檢測 |
| 電路數： | 1 |
| 增益帶寬積： | 200kHz |
| 電流 - 輸入偏壓： | 100nA |
| 電壓 - 輸入偏移： | 85µV |
| 電流 - 電源： | 350µA |
| 電流 - 輸出 / 通道： | 1mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 100 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-5 細型，TSOT-23-5 |
| 供應商設備封裝： | TSOT-23-5 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
LTC6101/LTC6101HV
12
6101fh
APPLICATIONS INFORMATION
Selection of External Output Resistor, ROUT
The output resistor, ROUT, determines how the output cur-
rent is converted to voltage. VOUT is simply IOUT ROUT.
In choosing an output resistor, the max output voltage
must rst be considered. If the circuit that is driven by
the output does not limit the output voltage, then ROUT
must be chosen such that the max output voltage does
not exceed the LTC6101 max output voltage rating. If the
following circuit is a buffer or ADC with limited input range,
then ROUT must be chosen so that IOUT(MAX) ROUT is less
than the allowed maximum input range of this circuit.
In addition, the output impedance is determined by ROUT. If
the circuit to be driven has high enough input impedance,
then almost any useful output impedance will be accept-
able. However, if the driven circuit has relatively low input
impedance, or draws spikes of current, such as an ADC
might do, then a lower ROUT value may be required in order
to preserve the accuracy of the output. As an example, if
the input impedance of the driven circuit is 100 times ROUT,
then the accuracy of VOUT will be reduced by 1% since:
V
OUT =IOUT
R
OUT RIN(DRIVEN)
R
OUT + RIN(DRIVEN)
=I
OUT ROUT
100
101
=0.99 I
OUT ROUT
Error Sources
The current sense system uses an amplier and resistors
to apply gain and level shift the result. The output is then
dependent on the characteristics of the amplier, such as
gain and input offset, as well as resistor matching.
Ideally, the circuit output is:
V
OUT = VSENSE
R
OUT
R
IN
;V
SENSE = RSENSE ISENSE
In this case, the only error is due to resistor mismatch,
which provides an error in gain only. However, offset
voltage, bias current and nite gain in the amplier cause
additional errors:
Output Error, EOUT, Due to the Amplier DC Offset
Voltage, VOS
EOUT(VOS) = VOS (ROUT/RIN)
The DC offset voltage of the amplier adds directly to the
value of the sense voltage, VSENSE. This is the dominant
error of the system and it limits the available dynamic
range. The paragraph “Selection of External Current Sense
Resistor” provides details.
Output Error, EOUT, Due to the Bias Currents,
IB(+) and IB(–)
The bias current IB(+) ows into the positive input of the
internal op amp. IB(–) ows into the negative input.
EOUT(IBIAS) = ROUT((IB(+) (RSENSE/RIN) – IB(–))
Since IB(+) ≈ IB(–) = IBIAS, if RSENSE << RIN then,
EOUT(IBIAS) ≈ –ROUT IBIAS
For instance if IBIAS is 100nA and ROUT is 1kΩ, the output
error is 0.1mV.
Note that in applications where RSENSE ≈ RIN, IB(+) causes
a voltage offset in RSENSE that cancels the error due to
IB(–) and EOUT(IBIAS) ≈ 0. In applications where RSENSE <
RIN, the bias current error can be similarly reduced if an
external resistor RIN(+) = (RIN – RSENSE) is connected as
shown in Figure 4 below. Under both conditions:
EOUT(IBIAS) = ± ROUT IOS; IOS = IB(+) – IB(–)
LTC6101
ROUT
VOUT
6101 F04
RIN
–
V+
LOAD
RSENSE
RIN
+
–
+
RIN
+ = RIN– – RSENSE
V+
V–
OUT
–IN
+IN
Figure 4. Second Input R Minimizes
Error Due to Input Bias Current
相關PDF資料 |
PDF描述 |
|---|---|
| 0459844213 | CONN RCPT R/A 4PWR 12SGL 1.57MM |
| 0459844212 | CONN RCPT R/A 4PWR 12SGL 2.36MM |
| C30A1P | CIRCUIT BRKR 30A 1POLE RAIL MNT |
| LTC6101HVACMS8#PBF | IC AMP CURRENT SENSE 8-MSOP |
| 0459844211 | CONN RCPT R/A 4PWR 12SGL 3.18MM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6101HVAHMS8 | 制造商:Linear Technology 功能描述:SP Amp Current Sense Amp Single 100V 8-Pin MSOP |
| LTC6101HVAHMS8#PBF | 功能描述:IC AMP CURRENT SENSE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR |
| LTC6101HVAHMS8#TRPBF | 功能描述:IC AMP CURRENT SENSE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:電流檢測 電路數:1 輸出類型:- 轉換速率:- 增益帶寬積:125kHz -3db帶寬:- 電流 - 輸入偏壓:- 電壓 - 輸入偏移:100µV 電流 - 電源:1.1µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:4-WFBGA，CSPBGA 供應商設備封裝:4-UCSP（2x2） 包裝:剪切帶 (CT) 其它名稱:MAX9634WERS+TCT |
| LTC6101HVAHMS8PBF | 制造商:Linear Technology 功能描述:Current Sense Amplifier 100V MSOP8 |
| LTC6101HVAHS5 | 制造商:Linear Technology 功能描述:SP Amp Current Sense Amp Single 100V 5-Pin TSOT-23 |
發布緊急采購，3分鐘左右您將得到回復。