- 您現在的位置：買賣IC網 > PDF目錄5305 > LTC6103CMS8#TRPBF (Linear Technology)IC AMP CURRENT SENSE 8-MSOP PDF資料下載
參數資料
| 型號： | LTC6103CMS8#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP CURRENT SENSE 8-MSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流檢測 |
| 電路數： | 2 |
| 增益帶寬積： | 140kHz |
| 電流 - 輸入偏壓： | 100nA |
| 電壓 - 輸入偏移： | 85µV |
| 電流 - 電源： | 390µA |
| 電流 - 輸出 / 通道： | 1mA |
| 電壓 - 電源，單路/雙路(±)： | 4 V ~ 60 V，±2 V ~ 30 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 帶卷 (TR) |
LTC6103
11
6103f
APPLICATIONS INFORMATION
If the power dissipation of the sense resistor is chosen to
be less than 0.5W then:
R
mW
I
m
SENSE
SENSE MAX
≤=
500
2
()
VSENSE(MAX) = ISENSE(MAX) RSENSE = 500mV
Gain
R
V
mV
OUT
IN
OUT MAX
SENSE MAX
==
=
()
3
500
6
If the maximum output current, IOUT, is limited to 1mA:
R
V
mA
k
value and
R
k
OUT
IN
=≈
3
1
301 1
3
6
499
.( %
)
(%
)
1
value
The output error due to DC offset is ±510V (typ) and the
error due to offset current:
IOS is 3kΩ × 100nA = ±300V (typical)
The maximum output error can therefore reach ±810V
or 0.027% (–71dB) of the output full scale. Considering
the system input 60dB dynamic range (ISENSE = 1mA to
1A), the 71dB performance of the LTC6103 makes this
application feasible.
In many applications the power dissipation of the sense
resistor is of greater importance than the precision of the
measurement. Designing for a VSENSE(MAX) of as low as
100mV is recommended in such cases.
Output Current Limitations Due to Power Dissipation
The LTC6103 can deliver up to 1mA continuous current to
the output pin. This current ows through RIN and enters
the current sense amp via the –IN pin. The power dissipated
in the LTC6103 due to the output signal is:
POUT = (VIN
– – VOUT) IOUT
Since VIN
– ≈ VS, POUT ≈ (VS – VOUT) IOUT
There is also power dissipated due to the quiescent sup-
ply current:
PQ = IS VS
The total power dissipated is the output dissipation plus
the quiescent dissipation:
PTOTAL = POUTA + POUTB + PQA + PQB
At maximum supply and maximum output current, the
total power dissipation can exceed 100mW. This will
cause signicant heating of the LTC6103 die. In order to
prevent damage to the LTC6103, the maximum expected
dissipation in each application should be calculated. This
number can be multiplied by the
θJA value listed in the
Package/Order Information to nd the maximum expected
die temperature. This must not be allowed to exceed 150°C
or performance may be degraded.
As an example, if an LTC6103 in the MS8 package is to
be run at 55V ±5V supply with 0.5mA output current in
both ampliers at 80°C:
PQ(MAX) = IS(MAX) V
+ (MAX) 2 = 82.8mW
POUT(MAX) = IOUT V
+ (MAX) 2 = 60mW
TRISE = θJA PTOTAL(MAX) = 300°C/W (82.8mW +
60mW) ≈ 43°C
TMAX = TAMBIENT + TRISE = 80°C + 43°C = 123°C
TMAX must be <150°C
PTOTAL(MAX) ≈ 143mW and the maximum die tempera-
ture will be 123°C
If this same circuit must run at 125°C, the maximum die
temperature will exceed 150°C. (Note that supply current,
and therefore PQ, is proportional to temperature. Refer to
the Typical Performance Characteristics.) In this condition,
the maximum output current should be reduced to avoid
device damage. It is important to note that the LTC6103
has been designed to provide at least 1mA to the output
when required, and can deliver more depending on the
conditions. Care must be taken to limit the maximum
output current by proper choice of resistors and, if input
fault conditions exist, external clamps.
Output Filtering
The output voltage, VOUT, is simply IOUT ZOUT. This
makes ltering straightforward. Any circuit may be used
which generates the required ZOUT to get the desired lter
response. For example, a capacitor in parallel with ROUT
相關PDF資料 |
PDF描述 |
|---|---|
| EL5151IWZ-T7 | IC AMP VFA SINGLE 200MHZ SOT23-5 |
| TA35-C2F3F180C0 | CIRCUIT BRKR THERMAL 18A RED |
| AD8208WBRMZ-RL | IC AMP DIFF PREC 8MSOP |
| 3404.2414.22 | FUSE&HOLDER 630MA 125V FAST SMD |
| TA35-C2F3F160C0 | CIRCUIT BRKR THERMAL 16A RED |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6103HMS8 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual High Voltage, High Side Current Sense Amplifier |
| LTC6103HMS8#PBF | 功能描述:IC AMP CURRENT SENSE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| LTC6103HMS8#TRPBF | 功能描述:IC AMP CURRENT SENSE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
| LTC6103IMS8 | 制造商:Linear Technology 功能描述:OP Amp Dual GP 60V 8-Pin MSOP |
| LTC6103IMS8#PBF | 功能描述:IC AMP CURRENT SENSE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
發布緊急采購，3分鐘左右您將得到回復。