- 您現在的位置：買賣IC網 > PDF目錄6074 > LTC6240HVCS8#PBF (Linear Technology)IC OP AMP SNGL R-R 8-SOIC PDF資料下載
參數資料
| 型號： | LTC6240HVCS8#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OP AMP SNGL R-R 8-SOIC |
| 標準包裝： | 100 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 10 V/µs |
| 增益帶寬積： | 18MHz |
| 電流 - 輸入偏壓： | 0.5pA |
| 電壓 - 輸入偏移： | 60µV |
| 電流 - 電源： | 2.7mA |
| 電流 - 輸出 / 通道： | 35mA |
| 電壓 - 電源，單路/雙路(±)： | 2.8 V ~ 11 V，±1.4 V ~ 5.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 管件 |
| 產品目錄頁面： | 1322 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC6240/LTC6241/LTC6242
19
624012fe
Amplier Characteristics
Figure 1 is a simplied schematic of the amplier, which
has a pair of low noise input transistors M1 and M2. A
simple folded cascode Q1, Q2 and R1, R2 allow the input
stage to swing to the negative rail, while performing level
shift to the differential drive generator. Low offset voltage
is accomplished by laser trimming the input stage.
Capacitor C1 reduces the unity cross frequency and im-
proves the frequency stability without degrading the gain
bandwidth of the amplier. Capacitor CM sets the overall
amplier gain bandwidth. The differential drive generator
supplies signals to transistors M3 and M4 that swing the
output from rail-to-rail.
The photo of Figure 2 shows the output response to an
input overdrive with the amplier connected as a voltage
follower. If the negative going input signal is less than
a diode drop below V–, no phase inversion occurs. For
input signals greater than a diode drop below V–, limit the
current to 3mA with a series resistor RS to avoid phase
inversion.
ESD
The LTC6240/LTC6241/LTC6242 have reverse-biased ESD
protection diodes on all input and outputs as shown in
Figure 1. If these pins are forced beyond either supply,
unlimited current will ow through these diodes. If the
current is transient and limited to one hundred milliamps
or less, no damage to the device will occur.
The amplier input bias current is the leakage current of
these ESD diodes. This leakage is a function of the tempera-
ture and common mode voltage of the amplier, as shown
in the Typical Performance Characteristics curves.
Noise
The LTC6240/LTC6241/LTC6242 exhibit exceptionally
low 1/f noise in the 0.1Hz to 10Hz region. This 550nVP-P
noise allows these op amps to be used in a wide variety
of high impedance low frequency applications, where
zero-drift ampliers might be inappropriate due to their
charge injection.
In the frequency region above 1kHz the LTC6240/LTC6241/
LTC6242 also show good noise voltage performance. In
this frequency region, noise can easily be dominated by
the total source resistance of the particular application.
Specically, these ampliers exhibit the noise of a 3.1kΩ
resistor, meaning it is desirable to keep the source and
feedback resistance at or below this value, i.e. RS + RG||RFB
≤ 3.1kΩ. Above this total source impedance, the noise
voltage is not dominated by the amplier.
Noise current can be estimated from the expression in =
√2qIB, where q = 1.6 10–19 coulombs. Equating √4kTRΔf
and R√2qIBΔf shows that for source resistors below 50GΩ
the amplier noise is dominated by the source resistance.
See the Typical Performance Characteristics curve Noise
Current vs Frequency.
Figure 1. Simplied Schematic
Figure 2. Unity Gain Follower Test Circuit
APPLICATIONS INFORMATION
R2
Q2
6241 F01
VIN
+
ITAIL
VIN
–
VO
V+
V–
CM
DESD5
DIFFERENTIAL
DRIVE
GENERATOR
BIAS
DESD6
V+
DESD2
V+
DESD4
V–
DESD1
V–
DESD3
R1
Q1
M2
M1
M3
M4
C1
CLAMP
+2.5V
–2.5V
6241 F02
–
+
LTC6240
RS
VIN
VOUT
VOUT AND VIN OF FOLLOWER WITH LARGE INPUT OVERDRIVE
VDD =
+2.5V
VSS =
–2.5V
相關PDF資料 |
PDF描述 |
|---|---|
| KD1245PFB3 H | FAN 12VDC 45X10.5MM .7W 6.1CFM |
| AD8220ARMZ-R7 | IC AMP INST JFET R-R 15MA 8MSOP |
| KD1205PFB1 H | FAN 12VDC 50X10.5MM 1.6W 11.4CFM |
| KD1205PFB3 H | FAN 12VDC 50X10.5MM .8W 8.0CFM |
| AD8651ARZ | IC OPAMP VF CMOS 50MHZ LN 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6240HVHS5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 18MHz, Low Noise, Rail-to-Rail Output, CMOS Op Amps |
| LTC6240HVHS5#PBF | 制造商:Linear Technology 功能描述:OP AMP 12V 18MHZ 10V/US 5TSOT23 制造商:Linear Technology 功能描述:SC-Amps/Industrial, Cut Tape Single Precision 18MHz Low Noise CMOS Op Amp |
| LTC6240HVHS5#TRMPBF | 功能描述:IC OP AMP SINGLE R-R TSOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| LTC6240HVHS5#TRPBF | 功能描述:IC OP AMP SINGLE R-R TSOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| LTC6240HVHS8 | 制造商:Linear Technology 功能描述:OP Amp Single GP R-R O/P 5.5V/11V 8-Pin SOIC N |
發布緊急采購，3分鐘左右您將得到回復。