參數資料
型號: LTC6244HDD#PBF
廠商: Linear Technology
文件頁數: 9/26頁
文件大小: 0K
描述: IC OPAMP CMOS R-R DUAL 8-DFN
標準包裝: 121
放大器類型: 通用
電路數: 2
輸出類型: 滿擺幅
轉換速率: 35 V/µs
增益帶寬積: 50MHz
電流 - 輸入偏壓: 1pA
電壓 - 輸入偏移: 100µV
電流 - 電源: 6.25mA
電流 - 輸出 / 通道: 35mA
電壓 - 電源,單路/雙路(±): 2.8 V ~ 6 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 8-WFDFN 裸露焊盤
供應商設備封裝: 8-DFN-EP(3x3)
包裝: 管件
產品目錄頁面: 1322 (CN2011-ZH PDF)
LTC6244
17
6244fb
Large Area Photodiode Ampliers
A simple large area photodiode amplier is shown in
Figure 4a. The capacitance of the photodiode is 3650pF
(nominally 3000pF), and this has a signicant effect on
the noise performance of the circuit. For example, the
photodiode capacitance at 10kHz equates to an impedance
of 4.36kΩ, so the op amp circuit with 1MΩ feedback has a
noise gain of NG = 1 + 1M/4.36k = 230 at that frequency.
Therefore, the LTC6244 input voltage noise gets to the
output as NG 7.8nV/√Hz = 1800nV/√Hz, and this can
clearly be seen in the circuit’s output noise spectrum in
Figure 4b. Note that we have not yet accounted for the
op amp current noise, or for the 130nV/√Hz of the gain
resistor, but these are obviously trivial compared to the op
amp voltage noise and the noise gain. For reference, the
DC output offset of this circuit is about 100μV, bandwidth
is 52kHz, and the total noise was measured at 1.7mVRMS
on a 100kHz measurement bandwidth.
An improvement to this circuit is shown in Figure 5a,
where the large diode capacitance is bootstrapped by a
1nV/√Hz JFET. This depletion JFET has a VGS of about
–0.5V, so that RBIAS forces it to operate at just over 1mA of
drain current. Connected as shown, the photodiode has a
reverse bias of one VGS, so its capacitance will be slightly
lower than in the previous case (measured 2640pF), but
the most drastic effects are due to the bootstrapping.
Figure 5b shows the output noise of the new circuit.
Noise at 10kHz is now 220nV/√Hz, and the 130nV/√Hz
noise thermal noise oor of the 1M feedback resistor
is discernible at low frequencies. What has happened is
that the 7.8nV/√Hz of the op amp has been effectively
replaced by the 1nV/√Hz of the JFET. This is because the
1M feedback resistor is no longer “l(fā)ooking back” into the
large photodiode capacitance. It is instead looking back
into a JFET gate capacitance, an op amp input capacitance,
and some parasitics, approximately 10pF total. The large
photodiode capacitance is across the gate-source volt-
age of the low noise JFET. Doing a sample calculation at
10kHz as before, the photodiode capacitance looks like
6kΩ, so the 1nV/√Hz of the JFET creates a current noise
of 1nV/6k = 167fA/√Hz. This current noise necessarily
ows through the 1M feedback resistor, and so appears
as 167nV/√Hz at the output. Adding the 130nV/√Hz of the
resistor (RMS wise) gives a total calculated noise density
of 210nV/√Hz, agreeing well with the measured noise of
Figure 5b. Another drastic improvement is in bandwidth,
now over 350kHz, as the bootstrap enabled a reduction
of the compensating feedback capacitance. Note that the
bootstrap does not affect the DC accuracy of the amplier,
except by adding a few picoamps of gate current.
There is one drawback to this circuit. Most photodiode
circuits require the ability to set the amount of applied
reverse bias, whether it’s 0V, 5V, or 200V. This circuit has
a xed reverse bias of about 0.5V, dictated by the JFET.
Figure 4b. Output Noise Spectral Density of the Circuit of Figure
4a. At 10kHz, the 1800nV/√Hz Output Noise is Due Almost
Entirely to the 7.8nV Voltage Noise of the LTC6244 and the High
Noise Gain of the 1M Feedback Resistor Looking Into the High
Photodiode Capacitance
Figure 4a. Large Area Photodiode Transimpedance Amplier
APPLICATIONS INFORMATION
5V
VOUT = 1M IPD
BW = 52kHz
NOISE = 1800nV/√Hz AT 10kHz
IPD
RF
1M
HAMAMATSU
LARGE AREA
PHOTODIODE
S1227-1010BQ
CPD = 3000pF
CF
3.9pF
–5V 6244 F04a
+
1/2
LTC6244HV
VOUT
1k
10k
FREQUENCY (Hz)
6244 F04b
100k
OUTPUT
NOISE
(800nV/√
Hz
/DIV)
相關PDF資料
PDF描述
77311-122-05LF CONN HEADER .100 SINGL STR 5POS
77311-127-05LF CONN HEADER .100 SINGL STR 5POS
AD8276BRZ IC AMP DIFF R-R 550KHZ LP 8SOIC
57102-F08-02LF MINITEK
77311-102-08LF CONN HEADER .100 SINGL STR 8POS
相關代理商/技術參數
參數描述
LTC6244HMS8 制造商:Linear Technology 功能描述:SC-Amps/Industrial, Dual Precision 50MHz Low noise CMOS Op Amp
LTC6244HMS8#PBF 功能描述:IC OP AMP DUAL R-R 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
LTC6244HMS8#TRPBF 功能描述:IC OP AMP DUAL R-R 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
LTC6244HVCDD 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 50MHz, Low Noise, Rail-to-Rail, CMOS Op Amp
LTC6244HVCDD#PBF 功能描述:IC OP AMP DUAL R-R 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):2.7 V ~ 5.5 V,±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR