- 您現在的位置：買賣IC網 > PDF目錄6087 > LTC6246HS6#TRMPBF (Linear Technology)IC OPAMP RRRIO 180MHZ TSOT23-6 PDF資料下載
參數資料
| 型號： | LTC6246HS6#TRMPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP RRRIO 180MHZ TSOT23-6 |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 90 V/µs |
| 增益帶寬積： | 180MHz |
| -3db帶寬： | 120MHz |
| 電流 - 輸入偏壓： | 400nA |
| 電壓 - 輸入偏移： | 100µV |
| 電流 - 電源： | 1.25mA |
| 電流 - 輸出 / 通道： | 100mA |
| 電壓 - 電源，單路/雙路(±)： | 2.5 V ~ 5.25 V，±1.25 V ~ 2.625 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 細型，TSOT-23-6 |
| 供應商設備封裝： | TSOT-23-6 |
| 包裝： | 標準包裝 |
| 其它名稱： | LTC6246HS6#TRMPBFDKR |
LTC6246/LTC6247/LTC6248
624678fa
applicaTions inForMaTion
Figure 2. 5pF Feedback Cancels Parasitic Pole
Feedback Components
When feedback resistors are used to set up gain, care
must be taken to ensure that the pole formed by the
feedback resistors and the parasitic capacitance at the
inverting input does not degrade stability. For example if
the amplifier is set up in a gain of +2 configuration with
gain and feedback resistors of 5k, a parasitic capacitance
of 5pF (device + PC board) at the amplifier’s inverting
input will cause the part to oscillate, due to a pole formed
at 12.7MHz. An additional capacitor of 5pF across the
feedback resistor as shown in Figure 2 will eliminate any
ringing or oscillation. In general, if the resistive feedback
network results in a pole whose frequency lies within the
closed loop bandwidth of the amplifier, a capacitor can be
added in parallel with the feedback resistor to introduce
a zero whose frequency is close to the frequency of the
pole, improving stability.
624678 F02
CPAR
5k
–
+
VOUT
VIN
5k
5pF
Power Dissipation
The LTC6246 and LTC6247 contain one and two amplifiers
respectively. Hence the maximum on-chip power dis-
sipation for them will be less than the maximum on-chip
power dissipation for the LTC6248, which contains four
amplifiers.
The LTC6248 is housed in a small 16-lead MS package and
typically has a thermal resistance (
θJA) of 125°C/ W. It is
necessary to ensure that the die’s junction temperature
does not exceed 150°C. The junction temperature, TJ, is
calculated from the ambient temperature, TA, power dis-
sipation, PD, and thermal resistance,
θJA:
TJ = TA + (PD θJA)
The power dissipation in the IC is a function of the supply
voltage, output voltage and load resistance. For a given
supply voltage with output connected to ground or supply,
the worst-case power dissipation PD(MAX) occurs when
the supply current is maximum and the output voltage at
half of either supply voltage for a given load resistance.
PD(MAX) is approximately (since IS actually changes with
output load current) given by:
PD(MAX) =(VS IS(MAX))+
VS
2
2
/ RL
Example:ForanLTC6248ina16-leadMSpackageoperating
on ±2.5V supplies and driving a 100Ω load to ground, the
worst-case power dissipation is approximately given by
PD(MAX)/Amp = (5 1.3mA) + (1.25)2/100 = 22mW
If all four amplifiers are loaded simultaneously then the
total power dissipation is 88mW.
AttheAbsoluteMaximumambientoperatingtemperature,
the junction temperature under these conditions will be:
TJ = TA + PD 125°C/W
= 125 + (0.088W 125°C/W) = 136°C
which is less than the absolute maximum junction tem-
perature for the LTC6248 (150°C).
Refer to the Pin Configuration section for thermal resis-
tances of various packages.
Shutdown
The LTC6246 and LTC6247MS have SHDN pins that can
shut down the amplifier to 42A typical supply current.
The SHDN pin needs to be taken below 0.8V above the
negative supply for the amplifier to shut down. When left
supply and the amplifier remains on.
相關PDF資料 |
PDF描述 |
|---|---|
| PEC11SADN | CONN HEADER .100 SINGL STR 11POS |
| PEC29SAAN | CONN HEADER .100 SINGL STR 29POS |
| AD8062ARMZ-R7 | IC OPAMP VF R-R DUAL LP 8MSOP |
| 9-146282-0-16 | CONN HDR BRKWAY .100 16POS VERT |
| 4-103741-0-16 | CONN HEADR BRKWAY .100 16POS STR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6246HS6TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:180MHz, 1mA Power Efficient Rail-to-Rail I/O Op Amps |
| LTC6246IS6 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:180MHz, 1mA Power Efficient Rail-to-Rail I/O Op Amps |
| LTC6246IS6#PBF | 制造商:Linear Technology 功能描述:OP Amp Single GP R-R I/O 5.25V 6-Pin TSOT-23 制造商:Linear Technology 功能描述:OP AMP RRIO 5.25V 180MHZ 6TSOT23 制造商:Linear Technology 功能描述:IC OP-AMP 180MHZ 90V/ TSOT-23-6 制造商:Linear Technology 功能描述:OP AMP, RRIO, 5.25V, 180MHZ, 6TSOT23 制造商:Linear Technology 功能描述:IC, OP-AMP, 180MHZ, 90V/ us, TSOT-23-6; Op Amp Type:Low Power; No. of Amplifiers:1; Slew Rate:90V/s; Supply Voltage Range:2.5V to 5.25V; Amplifier Case Style:TSOT-23; No. of Pins:6; Bandwidth:180MHz; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
| LTC6246IS6#TRMPBF | 功能描述:IC OPAMP R-R I/O 180MHZ TSOT23-6 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| LTC6246IS6#TRPBF | 功能描述:IC OPAMP R-R I/O 180MHZ TSOT23-6 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。