- 您現在的位置：買賣IC網 > PDF目錄8608 > LTC6404HUD-4#TRPBF (Linear Technology)IC AMP/DRIVER DIFF 16-QFN PDF資料下載
參數資料
| 型號： | LTC6404HUD-4#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 14/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP/DRIVER DIFF 16-QFN |
| 標準包裝： | 2,500 |
| 類型： | ADC 驅動器 |
| 應用： | 數據采集 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-QFN-EP（3x3） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC6404
21
6404f
APPLICATIONS INFORMATION
VINCM is dened as the average of the two input voltages
VINP, and VINM (also called the source-referred input com-
mon mode voltage):
VV
V
INCM
INP
INM
=+
()
1
2
and VINDIFF is dened as the difference of the input
voltages:
VINDIFF = VINP – VINM
When the feedback ratios mismatch (
Δβ), common mode
to differential conversion occurs.
Setting the differential input to zero (VINDIFF = 0), the de-
gree of common mode to differential conversion is given
by the equation:
VV
V
VV
V
OUTDIFF
OUT
INCM
OCM
AVG
I
=
≈
()
Δ
+ –
–
β
N
NDIFF = 0
In general, the degree of feedback pair mismatch is a
source of common mode to differential conversion of both
signals and noise. Using 1% resistors or better will mitigate
most problems, and will provide about 34dB worst-case of
common mode rejection. Using 0.1% resistors will provide
about 54dB of common mode rejection. A low impedance
ground plane should be used as a reference for both the
input signal source, and the VOCM pin. A direct short of
VOCM to this ground or bypassing the VOCM with a high
quality 0.1μF ceramic capacitor to this ground plane, will
further prevent common mode signals from being con-
verted to differential.
There may be concern on how feedback ratio mismatch
affects distortion. Distortion caused by feedback ratio mis-
match using 1% resistors or better is negligible. However,
in single supply level shifting applications where there is
a voltage difference between the input common mode
voltage and the output common mode voltage, resistor
mismatch can make the apparent voltage offset of the
amplier appear higher than specied.
The apparent input referred offset induced by feedback
ratio mismatch is derived from the following equation:
VOSDIFF(APPARENT) ≈ (VICM – VOCM) Δβ
Using the LTC6404-1 in a single supply application on a
single 5V supply with 1% resistors, and the input common
mode grounded, with the VOCM pin biased at mid-supply,
the worst-case DC offset can induce 25mV of apparent
offset voltage. With 0.1% resistors, the worst case appar-
ent offset reduces to 2.5mV.
Input Impedance and Loading Effects
The input impedance looking into the VINP or VINM input
of Figure 1 depends on whether the sources VINP and
VINM are fully differential. For balanced input sources
(VINP = –VINM), the input impedance seen at either input
is simply:
RINP = RINM = RI
For single ended inputs, because of the signal imbalance
at the input, the input impedance increases over the bal-
anced differential case. The input impedance looking into
either input is:
RR
R
RR
INP
INM
I
F
IF
==
+
1
2
–
Input signal sources with non-zero output impedances can
also cause feedback imbalance between the pair of feedback
networks. For the best performance, it is recommended
that the source’s output impedance be compensated for.
If input impedance matching is required by the source,
R1 should be chosen (see Figure 4):
R
RR
INM
S
INM
S
1 =
–
Figure 4. Optimal Compensation for Signal Source Impedance
VS
+
–
+
RF
RI
RINM
RS
RI
R2 = RS || R1
R1 CHOSEN SO THAT R1 || RINM = RS
R2 CHOSEN TO BALANCE R1 || RS
R1
6404 F04
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2610IGN#TRPBF | IC DAC R-R 14-BIT OCTAL 16-SSOP |
| LTC6409HUDB#TRMPBF | IC AMP/DRIVER DIFF GBW 10-QFN |
| AD8331ARQZ-RL | IC VGA SINGLE W/PREAMP 20QSOP |
| AD8331ARQZ-R7 | IC AMP VAR GAIN 1CHAN 20QSOP |
| VE-21V-MW-B1 | CONVERTER MOD DC/DC 5.8V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6404IUD-1#PBF | 功能描述:IC AMP/DRIVER DIFF 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6404IUD-1#TRPBF | 功能描述:IC AMP/DRIVER DIFF 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6404IUD-1-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:600MHz, Low Noise, High Precision Fully Differential Input/Output Amplifi er/Driver |
| LTC6404IUD-1-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:600MHz, Low Noise, High Precision Fully Differential Input/Output Amplifi er/Driver |
| LTC6404IUD-2#PBF | 功能描述:IC AMP/DRIVER DIFF 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。