參數資料
型號： LTC6405CMS8E#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PDSO8
封裝： LEAD FREE, MSOP-8
文件頁數： 20/24頁
文件大?。?/td> 281K
代理商： LTC6405CMS8E#TRPBF
LTC6405
5
6405fa
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Input pins (+IN, –IN, VOCM, SHDN and VTIP) are protected by
steering diodes to either supply. If the inputs should exceed either supply
voltage, the input current should be limited to less than 10mA. In addition,
the inputs +IN, –IN are protected by a pair of back-to-back diodes. If the
differential input voltage exceeds 1.4V, the input current should be limited
to less than 10mA.
Note 3: A heat sink may be required to keep the junction temperature
below the Absolute Maximum Rating when the output is shorted
indenitely.
Note 4: The LTC6405C/LTC6405I are guaranteed functional over the
operating temperature range –40°C to 85°C.
Note 5: The LTC6405C is guaranteed to meet specied performance from
0°C to 70°C. The LTC6405C is designed, characterized, and expected
to meet specied performance from –40°C to 85°C but is not tested or
QA sampled at these temperatures. The LTC6405I is guaranteed to meet
specied performance from –40°C to 85°C.
Note 6: Input bias current is dened as the average of the input currents
owing into the inputs (–IN, and +IN). Input Offset current is dened as
the difference between the input currents (IOS = IB+ – IB–).
Note 7: Input common mode range is tested using the test circuit of Figure
1 by taking 3 measurements of differential gain with a ±1VDC differential
output with VICM = 0V; VICM = 2.5V; VICM = 5V, verifying that the differential
gain has not deviated from the VICM = 2.5V case by more than 0.5%, and
that the common mode offset (VOSCM) has not deviated from the common
mode offset at VICM = 2.5V by more than ±35mV.
The voltage range for the output common mode range is tested using the
test circuit of Figure 1 by applying a voltage on the VOCM pin and testing at
both VOCM = 2.5V and at the Electrical Characteristics table limits to verify
that the common mode offset (VOSCM) has not deviated by more than
±20mV from the VOCM = 2.5V case.
Note 8: Input CMRR is dened as the ratio of the change in the input
common mode voltage at the pins +IN or –IN to the change in differential
input referred voltage offset. Output CMRR is dened as the ratio of
the change in the voltage at the VOCM pin to the change in differential
input referred voltage offset. This specication is strongly dependent on
feedback ratio matching between the two outputs and their respective
inputs, and it is difcult to measure actual amplier performance. (See
the “Effects of Resistor Pair Mismatch” in the Applications Information
section of this data sheet.) For a better indicator of actual amplier
performance independent of feedback component matching, refer to the
PSRR specication.
Note 9: Differential Power Supply Rejection (PSRR) is dened as the
ratio of the change in supply voltage to the change in differential input
referred voltage offset. Common mode power supply rejection (PSRRCM)
is dened as the ratio of the change in supply voltage to the change in the
common mode offset, VOUTCM – VOCM.
Note 10: Extended operation with the output shorted may cause the
junction temperature to exceed the 150°C limit.
Note 11: Because the LTC6405 is a feedback amplier with low output
impedance, a resistive load is not required when driving an ADC.
Therefore, typical output power can be very small in many applications. In
order to compare the LTC6405 with “RF style” ampliers that require 50Ω
load, the output voltage swing is converted to dBm as if the outputs were
driving a 50Ω load. For example, 2VP-P output swing is equal to 10dBm
using this convention.
Note 12: Includes offset/drift induced by feedback resistors mismatch. See
the Applications Information section for more details.
Note 13: QFN package only—refer to datasheet curves for MSOP package
numbers.
ELECTRICAL CHARACTERISTICS
相關PDF資料
PDF描述
LTC6405IMS8E#TRPBF SPECIALTY ANALOG CIRCUIT, PDSO8
LTM4600HVEV 17 A SWITCHING REGULATOR, 800 kHz SWITCHING FREQ-MAX, PBGA104
LTM4600HVIV 17 A SWITCHING REGULATOR, 800 kHz SWITCHING FREQ-MAX, PBGA104
LV5103LP SPECIALTY ANALOG CIRCUIT, QCC40
LV5103LP SPECIALTY ANALOG CIRCUIT, QCC40
相關代理商/技術參數
參數描述
LTC6405CUD 制造商:Linear Technology 功能描述:DIFF AMP 5V 2.7GHZ R/R 16QFN 制造商:Linear Technology 功能描述:DIFF AMP, 5V, 2.7GHZ, R/R, 16QFN
LTC6405CUD#PBF 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤
LTC6405CUD#TR 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 2.7GHZ, 690V/US, QFN-16, No. of Amplifiers:1, Input Offset Voltage:6mV, Bandwidth:2.7GHz, Amplifier Case Style:QFN, No. of Pins:16, Supply Voltage Range:4.5V to 5.25V, Slew Rate:690V/s, Supply Current:18mA, MSL:- , RoHS Compliant: No
LTC6405CUD#TRPBF 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤
LTC6405CUD-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:2.7GHz, 5V, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*