- 您現在的位置：買賣IC網 > PDF目錄8612 > LTC6406CMS8E#TRPBF (Linear Technology)IC AMP/DRIVER DIFF 8-MSOP PDF資料下載
參數資料
| 型號： | LTC6406CMS8E#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 9/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP/DRIVER DIFF 8-MSOP |
| 標準包裝： | 2,500 |
| 類型： | ADC 驅動器 |
| 應用： | 數據采集 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 |
| 供應商設備封裝： | 8-MSOP-EP |
| 包裝： | 帶卷 (TR) |
LTC6406
17
6406fc
Output Common Mode Voltage Range
The output common mode voltage is dened as the aver-
age of the two outputs:
V
OUTCM = VOCM =
V+OUT + V–OUT
2
The VOCM pin sets this average by an internal common
mode feedback loop which internally forces VOUTCM =
VOCM. The output common mode range extends from 0.5V
above V– to 1V below V+. The VOCM voltage is internally
set by a resistive divider between the supplies, develop-
ing a default voltage potential of 1.25V with a 3V supply.
In single supply applications, where the LTC6406 is used
to interface to an ADC, the optimal common mode input
range to the ADC is often determined by the ADC’s refer-
ence. If the ADC makes a reference available for setting
the input common mode voltage, it can be directly tied
to the VOCM pin (as long as it is able to drive the 18kΩ
Thevenin equivalent input impedance presented by the
VOCM pin).
The VOCM pin should be bypassed with a high quality
ceramic bypass capacitor of at least 0.01μF to lter any
common mode noise rather than being converted to dif-
ferential noise and to prevent common mode signals on
this pin from being inadvertently converted to differential
signals by impedance mismatches both externally and
internally to the IC.
Output Filter Considerations and Use
Filtering at the output of the LTC6406 is often desired to
provide antialiasing or to improve signal to noise ratio.
To simplify this ltering, the LTC6406 in the QFN package
includes an additional pair of differential outputs (+OUTF
and –OUTF) which incorporate an internal lowpass RC
network with a –3dB bandwidth of 850MHz (Figure 6).
These pins each have an output resistance of 50
Ω (toler-
ance ±12%). Internal capacitances are 1.25pF (tolerance
±15%) to V– on each ltered output, plus an additional
APPLICATIONS INFORMATION
1.25pF (tolerance ±15%) capacitor connected between the
two ltered outputs. This resistor/capacitor combination
creates ltered outputs that look like a series 50
Ω resistor
with a 3.75pF capacitor shunting each ltered output to
AC ground, providing a –3dB bandwidth of 850MHz, and
a noise bandwidth of 1335MHz. The lter cutoff frequency
is easily modied with just a few external components. To
increase the cutoff frequency, simply add two equal value
resistors, one between +OUT and +OUTF and the other
between –OUT and –OUTF (Figure 7). These resistors, in
parallel with the internal 50
Ω resistors, lower the overall
resistance and therefore increase lter bandwidth. For
example, to double the lter bandwidth, add two external
50
Ω resistors to lower the series lter resistance to 25Ω.
The 3.75pF of capacitance remains unchanged, so lter
bandwidth doubles. Keep in mind, the series resistance
also serves to decouple the outputs from load capacitance.
The outputs of the LTC6406 are designed to drive 5pF to
ground, so care should be taken to not lower the effec-
tive impedance between +OUT and +OUTF or –OUT and
–OUTF below 15
Ω.
To decrease lter bandwidth, add two external capacitors,
one from +OUTF to ground, and the other from –OUTF to
ground. A single differential capacitor connected between
+OUTF and –OUTF can also be used, but since it is being
Figure 6. LTC6406 Internal Filter Topology
–
+
7
+OUT
8
+OUTF
14
–OUT
13
–OUTF
+OUTF
–OUTF
1.25pF
50Ω
1.25pF
12
V–
9
V–
6406 F06
LTC6406
FILTERED OUTPUT
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2TV-MW-B1 | CONVERTER MOD DC/DC 5.8V 100W |
| LTC6404CUD-2#TRPBF | IC AMP/DRIVER DIFF 16-QFN |
| VE-2TT-MW-B1 | CONVERTER MOD DC/DC 6.5V 100W |
| VE-242-IV-F4 | CONVERTER MOD DC/DC 15V 150W |
| VE-2T0-MW-B1 | CONVERTER MOD DC/DC 5V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6406CUD#PBF | 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6406CUD#TRPBF | 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6406CUD-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3GHz, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
| LTC6406CUD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3GHz, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
| LTC6406IMS8E#PBF | 功能描述:IC AMP/DRIVER DIFF 8-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。