- 您現在的位置：買賣IC網 > PDF目錄8611 > LTC6406IMS8E#PBF (Linear Technology)IC AMP/DRIVER DIFF 8-MSOP PDF資料下載
參數資料
| 型號： | LTC6406IMS8E#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP/DRIVER DIFF 8-MSOP |
| 標準包裝： | 50 |
| 類型： | ADC 驅動器 |
| 應用： | 數據采集 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 |
| 供應商設備封裝： | 8-MSOP-EP |
| 包裝： | 管件 |
LTC6406
15
6406fc
APPLICATIONS INFORMATION
In general, the degree of feedback pair mismatch is a
source of common mode to differential conversion of both
signals and noise. Using 1% resistors or better will mitigate
most problems, and will provide about 34dB worst case of
common mode rejection. Using 0.1% resistors will provide
about 54dB of common mode rejection. A low impedance
ground plane should be used as a reference for both the
input signal source and the VOCM pin. Bypassing the VOCM
with a high quality 0.1μF ceramic capacitor to this ground
plane will further help prevent common mode signals from
being converted to differential signals.
There may be concern on how feedback factor mismatch
affects distortion. Feedback factor mismatch from using
1% resistors or better, has a negligible effect on distortion.
However, in single supply level-shifting applications where
there is a voltage difference between the input common
mode voltage and the output common mode voltage,
resistor mismatch can make the apparent voltage offset
of the amplier appear worse than specied.
The apparent input referred offset induced by feedback
factor mismatch is derived from the above equation:
VOSDIFF(APPARENT) ≈ (VICM – VOCM) Δβ
Using the LTC6406 in a single supply application on a
single 3V supply with 1% resistors, and the input com-
mon mode grounded, with the VOCM pin biased at 1.25V,
the worst case DC offset can induce 12.5mV of apparent
offset voltage. With 0.1% resistors, the worst-case ap-
parent offset reduces to 1.25mV.
Input Impedance and Loading Effects
The input impedance looking into the VINP or VINM input
of Figure 1 depends on whether or not the sources VINP
and VINM are fully differential or not. For balanced input
sources (VINP = –VINM), the input impedance seen at either
input is simply:
RINP = RINM = RI
For single-ended inputs, because of the signal imbalance
at the input, the input impedance actually increases over
the balanced differential case. The input impedance looking
into either input is:
R
INP = RINM =
R
I
1–
1
2
R
F
R
I + RF
Input signal sources with non-zero output impedances
can also cause feedback imbalance between the pair of
feedback networks. For the best performance, it is rec-
ommended that the input source output impedance be
compensated for. If input impedance matching is required
by the source, a termination resistor R1 should be chosen
(see Figure 4):
R1
=
R
INM RS
R
INM –RS
Figure 4. Optimal Compensation for Signal Source Impedance
VS
+
–
+
RF
RI
RINM
RS
RI
R2
RS||R1
R1 CHOSEN SO THAT R1||RINM = RS
R2 CHOSEN TO BALANCE R1||RS
R1
6406 F04
According to Figure 4, the input impedance looking into
the differential amp (RINM)reectsthesingle-endedsource
case, thus:
R
INM =
R
I
1–
1
2
R
F
R
I + RF
R2 is chosen to equal R1||RS:
R2
=
R1 R
S
R1
+R
S
相關PDF資料 |
PDF描述 |
|---|---|
| VI-24H-MW-B1 | CONVERTER MOD DC/DC 52V 100W |
| VE-24L-IV-F3 | CONVERTER MOD DC/DC 28V 150W |
| VI-24F-MW-B1 | CONVERTER MOD DC/DC 72V 100W |
| AD8138AARMZ | IC DIFF ADC DVR LOW DISTOR 8MSOP |
| VE-24L-IV-F2 | CONVERTER MOD DC/DC 28V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6406IMS8E-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3GHz, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
| LTC6406IUD#PBF | 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6406IUD#TRPBF | 功能描述:IC DIFF AMP/DRIVER R-R 16-QFN RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LTC6406IUD-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3GHz, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
| LTC6406IUD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:3GHz, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
發布緊急采購，3分鐘左右您將得到回復。