- 您現在的位置：買賣IC網 > PDF目錄367613 > LUCL9215AAU-D GT 3C 3#0 PIN RECP WALL RM PDF資料下載
參數資料
| 型號： | LUCL9215AAU-D |
| 英文描述： | GT 3C 3#0 PIN RECP WALL RM |
| 中文描述： | 短回路正弦波振鈴用戶接口 |
| 文件頁數： | 13/50頁 |
| 文件大?。?/td> | 1115K |
| 代理商： | LUCL9215AAU-D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
Data Sheet
September 2001
Short-Loop Sine Wave Ringing SLIC
L9215A/G
Agere Systems Inc.
13
State Definitions
(continued)
On-Hook Transmission with PPM
—
Forward
Battery
I
Pin PT is positive with respect to PR.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be
between –41 V and –49 V with a –70 V primary bat-
tery.
I
PPM is on.
On-Hook Transmission
—
Reverse Battery
I
Pin PR is positive with respect to PT.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be
between –41 V and –49 V with a –70 V primary bat-
tery.
I
PPM is off.
On-Hook Transmission with PPM
—
Reverse
Battery
I
Pin PR is positive with respect to PT.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be
between –41 V and –49 V with a –70 V primary bat-
tery.
I
PPM is on.
Disconnect
I
The tip/ring amplifiers and all supervision are turned
off.
I
The SLIC goes into a high-impedance state.
I
NSTAT is forced high (on-hook).
Ring
I
Power ring signal is applied to tip and ring.
I
Input waveform at RING
IN
is amplified.
I
Ring trip supervision and common-mode current
supervision are active; loop closure is inactive.
I
Overhead voltage is reduced to typically 4 V, regard-
less of programming on OVH, and current limit set at
V
PROG
is disabled.
I
Current is limited by saturation current of the amplifi-
ers themselves, typically 100 mA at 125 °C.
Thermal Shutdown
I
Not controlled via truth table inputs.
I
NSTAT is forced low (off-hook) during this state
I
This mode is caused by excessive heating of the
device, such as may be encountered in an extended
power cross situation.
相關PDF資料 |
PDF描述 |
|---|---|
| LUCL9215AAU-DT | GT 14C 12# 2#16 PIN RECP WALL |
| LUCL9216GGF-D | Short-Loop Ringing SLIC with Ground Start |
| LUCL9216GGF-DT | Short-Loop Ringing SLIC with Ground Start |
| LUCL9216ARG-D | Short-Loop Ringing SLIC with Ground Start |
| LUCL9216AGF-D | Short-Loop Ringing SLIC with Ground Start |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LUCL9215AAU-DT | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
| LUCL9215ARG-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
| LUCL9215GAU-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
| LUCL9215GAU-DT | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
| LUCL9215GRG-D | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
發布緊急采購，3分鐘左右您將得到回復。