- 您現在的位置：買賣IC網 > PDF目錄45008 > LX1688IPW-TR (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) FLUORESCENT LIGHT CONTROLLER, 70 kHz SWITCHING FREQ-MAX, PDSO24 PDF資料下載
參數資料
| 型號： | LX1688IPW-TR |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 穩壓器 |
| 英文描述： | FLUORESCENT LIGHT CONTROLLER, 70 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | ROHS COMPLIANT, PLASTIC, TSSOP-24 |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 484K |
| 代理商： | LX1688IPW-TR |
RangeMAX
LX1688
PRODUCTION DATA SHEET
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 8
Copyright
2001
Rev. 1.2, 2006-03-09
WWW
.Microse
m
i
.CO
M
Multiple Lamp CCFL Controller
TM
DE TAILED DESCRIP T ION
and may or may not be externally synchronized to the LCD
video frame rate. It will directly gate the signal BRT.
CPWM should not be used in this case.
FAULT PIN
The fault pin is a digital output that indicates that the
maximum numbers of strike attempts has occurred without
lamp ignition. In this condition the FAULT pin will go
active high with typically 20mA drive capability. Holding
the OLSNS pin low (<200mV) will also force timeout and
activate the FAULT pin. When used as a master, fault
condition true does not inhibit master clock outputs
PHA_SYNC and RMP_RST.
I_R PIN
The run mode frequency of the output is one half the
internal ramp frequency, which is proportional to a bias
current set by resistor RI of 80.6K. The output frequency
can thus be adjusted by varying the value of RI-R, the
typical range from about 50K to 100K. Since there is some
variation in the frequency due to change in the input supply
(VDD) it is recommended that the value of RI-R be selected
at the nominal input voltage.
SLEEP MODE (ENABLE SIGNAL) AND SWITCHED VDD
(VDDSW)
Since the LX1688 can be used in portable battery
operated systems, a very low power sleep mode is included.
The IC will consume less than 10A quiescent current from
both the VDD and VDD_P pins combined, when the
ENABLE pin is deactivated. The polarity of the ENABLE
pin is programmable by the BEPOL input (see table 1). In
addition the controller provides a switched supply pin
VDDSW this output supplies at least 10mA at VDD ─ .2V
for external circuitry. This output can be used to power
additional circuitry that can be enabled with the controller.
RMP_RST AND PHA_SYNC PIN TIMING REQUIREMENT
WITH
SLAVE MODE OPERATION
When the LX1688 is configured for slave mode
operation, and RMP_RST and PHA_SYNC is supplied
from an external source, the signal timing should be met as
outlined below.
RMP_RST should be 2 times frequency of lamp
frequency and duty should be 10 to 13%, and PHA_SYNC
should be generated by divide by 2 of RMP_RST signal.
Phase of these signals should be met the as shown, note the
delay between the RMP_RST and PHA_SYNC signals:
Min
Typ
Max
Unit
T1
150
250
nsec
T2
10
13
%
T3
49
50
51
%
Tr, Tf
100
nsec
T3 duty is 50% of operating frequency.
T2
T1
T3
BIAS & TIM I NG EQUATIONS
Formula 1:
Triangular Wave Generator Frequency, FTRI
[Hz]
)
25
(
1
FTRI
TRI
I
C
R
×
=
Formula 2:
Lamp Frequency (AOUT’s switching frequency), FLAMP
[Hz]
12
200
1
FLAMP
I
R
e-
×
=
Formula 3:
Minimum Current Error Amp Bandwidth, BWIEA_MIN
[Hz]
000048
.
0
BWIEA_MIN
ICOMP
C
=
Formula 4:
Minimum Voltage Error Amp Bandwidth, BWVEA_MIN
[Hz]
000048
0
BWVEA_MIN
VCOMP
C
.
=
Formula 5:
Softstart time, TSS
[sec]
TSS
VCOMP
C
,
×
=
000
500
4
Formula 6:
Minimum Power-on Reset Pulse Width, TMIN_POR
[sec]
6
3
.
2
TMIN_POR
POR
C
e
×
=
AA
PP
LL
IICC
AA
TT
IIOO
NN
SS
相關PDF資料 |
PDF描述 |
|---|---|
| LX1689IPWT | FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LX1689CPWT | FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LX1691AIPW-TR | 0.1 A FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO16 |
| LX1692BIPW-TR | 0.1 A SWITCHING CONTROLLER, PDSO20 |
| LX1692IDW-TR | 0.1 A SWITCHING CONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX1689 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Third Generation CCFL Controller |
| LX1689_06 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Third Generation CCFL Controller |
| LX1689CPW | 功能描述:IC CTRLR CCFL BACKLIGHT 20TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 照明，鎮流器控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:CCFL 控制器 頻率:40 ~ 80 kHz 電流 - 電源:5mA 電流 - 輸出:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) 其它名稱:90-3991V+V01 |
| LX1689CPW-TR | 制造商:Microsemi Corporation 功能描述:CCFL DRVR 28V 20TSSOP - Tape and Reel 制造商:Microsemi Corporation 功能描述:DIRECT DRIVE CONTROLLER |
| LX1689IPW | 功能描述:IC CTLR CCFL BACKLIGHT 20-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 照明，鎮流器控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:CCFL 控制器 頻率:40 ~ 80 kHz 電流 - 電源:5mA 電流 - 輸出:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) 其它名稱:90-3991V+V01 |
發布緊急采購，3分鐘左右您將得到回復。