- 您現在的位置：買賣IC網 > PDF目錄367620 > LX1882-00CDM Charge Pump PDF資料下載
參數資料
| 型號： | LX1882-00CDM |
| 英文描述： | Charge Pump |
| 中文描述： | 電荷泵 |
| 文件頁數： | 2/13頁 |
| 文件大?。?/td> | 309K |
| 代理商： | LX1882-00CDM |
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 2
Copyright
2000
Rev. 1.0c, 2002-08-01
W
M
.
C
LX1882
Charge Pump Doubler with Linear Regulator
P
RODUCTION
D
ATA
S
HEET
I N T E G R A T E D P R O D U C T S
A B S O L U T E M A X I M U M R A T I N G S
V
IN
to GND.....................................................................................................-0.3V to 5V
V
OUT
Voltage..................................................................................................-0.3V to 6V
CPO to Ground...........................................................................................................10V
SHDN
, FILT, FB Voltage to Ground...........................................-0.3V to (VIN + 0.3V)
V
OUT
Short –Circuit Duration............................................................................ Indefinite
I
OUT
..........................................................................................................................90mA
Operating Temperature Range
Commercial................................................................................................... 0°C to 70°C
Storage Temperature ................................................................................-65°C to 150°C
Lead Temperature (Soldering 10sec).......................................................................300°C
Maximum Junction Temperature.............................................................................125°C
Note:
Exceeding these ratings could cause damage to the device. All voltages are with respect to Ground.
Currents are positive into, negative out of specified terminal.
T H E R M A L D A T A
DM
T
HERMAL
R
ESISTANCE
-J
UNCTION TO
A
MBIENT
,
θ
JA
T
HERMAL
R
ESISTANCE
-J
UNCTION TO
C
ASE
,
θ
JC
Plastic 8-Pin SOIC
163°C/W
38°C/W
DU
T
HERMAL
R
ESISTANCE
-J
UNCTION TO
A
MBIENT
,
θ
JA
T
HERMAL
R
ESISTANCE
-J
UNCTION TO
C
ASE
,
θ
JC
Plastic 8-Pin MSOP
206°C/W
39°C/W
Junction Temperature Calculation: T
J
= T
A
+ (P
D
x
θ
JA
).
The
θ
JA
numbers are guidelines for the thermal performance of the device/pc-board system. All
of the above assume no ambient airflow.
P A C K A G E P I N O U T
V
OUT
SHDN
FB
GND
C
+
V
IN
C
-
CPO
1
2
3
4
5
6
7
8
_______
DM P
ACKAGE
(Top View)
CPO
C
-
FB
V
IN
V
______
GND
SHDN
1
2
3
4
5
6
7
8
C
+
DU P
ACKAGE
(Top View)
F U N C T I O N A L P I N D E S C R I P T I O N
P
IN
N
AME
P
IN
#
D
ES CRIPT ION
V
OUT
1
Regulated Output Voltage. It is recommended to bypass V
OUT
with a low ESR capacitor (> 2μF) placed as close
to the pin as possible for best performance. For the adjustable version, the output voltage range is 2.5V to 5.5V.
Shutdown Pin. The LX1882 is in shutdown mode when a logic low is applied to this pin. Inversely, a logic high
applied to this pin enables the device. When in shutdown mode, the charge pump output is disconnected from V
IN
(CPO will be high impedance) and V
OUT
is connected to ground through an internal 100
switch.
Adjustable Version Only. The output voltage can be set by two resistors with the following relationship: V
OUT
=
FB * (1+ (R
1
/R
2
)) where R
1
is the resistor connected between V
OUT
and FB, and R
2
is the resistor connected
between FB and GND (see figure 3 on page 6).
Fixed Version Only. Filter pin for internal voltage reference. Typically a 1nF capacitor is connected from FILT to
GND.
System Ground.
Flying Capacitor Negative Input.
Input Voltage. The input voltage range is 1.8V to 4.4V for the LX1882-00 and 2V to 4.4V for the LX1882-33.
V
IN
should be bypassed with a > 2μF low ESR capacitor placed as close to the pin as possible for best
performance. A minimum capacitance value of 0.1μF is required.
Flying Capacitor Positive Input.
Charge Pump Output Voltage. CPO is approximately 1.95(V
IN
) at low loads. CPO should be bypassed with a low
ESR capacitor (>2μF).
SHDN
2
FB
3
FILT
3
GND
C
-
4
5
V
IN
6
C
+
7
CPO
8
P
A
C
K
A
G
E
D
A
T
A
相關PDF資料 |
PDF描述 |
|---|---|
| LX1882-00CDU | Charge Pump |
| LX1882-33CDM | Charge Pump |
| LX1882-33CDU | Charge Pump |
| LX1882EVALKIT | Charge Pump |
| LX1990-02EVAL | LED Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX1882-00CDM-TR | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Charge Pump Doubler with Linear Regulator |
| LX1882-00CDU | 功能描述:IC REG SWITCHD CAP DBL ADJ 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
| LX1882-00CDU-TR | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Charge Pump Doubler with Linear Regulator |
| LX1882-03 EVAL KIT | 制造商:Microsemi Corporation 功能描述:CHARGE PUMP - Bulk |
| LX1882-33CDM | 功能描述:IC REG SWITCHED CAP DBL 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
發布緊急采購，3分鐘左右您將得到回復。