- 您現在的位置：買賣IC網 > PDF目錄4478 > M1A3P600-PQG208I (Microsemi SoC)IC FPGA 1KB FLASH 600K 208-PQFP PDF資料下載
參數資料
| 型號： | M1A3P600-PQG208I |
| 廠商： | Microsemi SoC |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FPGA 1KB FLASH 600K 208-PQFP |
| 標準包裝： | 24 |
| 系列： | ProASIC3 |
| RAM 位總計： | 110592 |
| 輸入/輸出數： | 154 |
| 門數： | 600000 |
| 電源電壓： | 1.425 V ~ 1.575 V |
| 安裝類型： | 表面貼裝 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 208-BFQFP |
| 供應商設備封裝： | 208-PQFP（28x28） |
ARM CortexTM-M1
8P ro d u c t B r i e f
Exception Priority
In the processor exception model, priority determines
when and how the processor takes exceptions. You can
assign software priority levels to interrupts.
The NVIC supports software-assigned priority levels. You
can assign a priority level from 0 to 3 to an interrupt by
writing to the 2-bit IP_N field in an Interrupt Priority
Register. Hardware priority decreases with increasing
interrupt number. Priority level –3 is the highest priority
level, and priority level 3 is the lowest. The priority level
overrides the hardware priority.
Stacks
The processor supports two separate stacks:
Process stack – You can configure Thread mode
to use the process stack. Thread mode uses the
main stack out of reset. SP_process is the Stack
Pointer (SP) register for the process stack.
Main stack – Handler mode uses the main stack.
SP_main is the SP register for the main stack.
Only one stack, the process stack or the main stack, is
visible at any time, using R13. After pushing the content,
the ISR uses the main stack, and all subsequent interrupt
preemptions use the main stack.
Clocking and Resets
The processor has one functional clock input, HCLK, and
one reset signal, SYSRESETn. If debug is implemented,
there is also a SWJ-DP clock, SWCLKTCK, and nTRST.
SWCLKTCK relates to the DAP logic. The debug reset
signal DBGRESETn relates to the debug logic clocked by
HCLK.
The SYSRESETn signal resets the entire processor system
with the exception of debug logic in the following:
Nested Vectored Interrupt Controller (NVIC)
Debug subsystem
The register file cannot be reset by SYSRESETn or
DBGRESETn.
Nested Vectored Interrupt Controller
The NVIC facilitates low-latency exception and interrupt
handling, and implements System Control Registers. The
NVIC supports reprioritizable interrupts. The NVIC and
the processor core interface are closely coupled, which
enables low latency interrupt processing and efficient
processing of late-arriving interrupts. All NVIC registers
are only accessible using word transfers. Any attempt to
write a halfword or byte individually causes corruption
of the register bits. All NVIC registers and system debug
registers are little-endian, regardless of the endianness
state of the processor. See Table 4 for a list of the NVIC
registers and their addresses
.
Table 4
NVIC Register
Name of Register
Type
Address
Reset Value
IRQ 0 to 31 Set Enable Register
R/W
0xE000E100
0x00000000
IRQ 0 to 31 Clear Enable Register
R/W
0xE000E180
0x00000000
IRQ 0 to 31 Set Pending Register
R/W
0xE000E200
0x00000000
IRQ 0 to 31 Clear Pending Register
R/W
0xE000E280
0x00000000
Priority 0 Register
R/W
0xE000E400
0x00000000
Priority 1 Register
R/W
0xe000e404
0x00000000
Priority 2 Register
R/W
0xe000e408
0x00000000
Priority 3 Register
R/W
0xe000e40c
0x00000000
Priority 4 Register
R/W
0xe000e410
0x00000000
Priority 5 Register
R/W
0xe000e414
0x00000000
Priority 6 Register
R/W
0xe000e418
0x00000000
Priority 7 Register
R/W
0xe000e41c
0x00000000
相關PDF資料 |
PDF描述 |
|---|---|
| A40MX02-3VQG80 | IC FPGA MX SGL CHIP 3K 80-VQFP |
| A40MX02-3VQ80 | IC FPGA MX SGL CHIP 3K 80-VQFP |
| FMM18DSEN | CONN EDGECARD 36POS .156 EYELET |
| EP4CE22F17I8L | IC CYCLONE IV FPGA 22K 256FBGA |
| EP4CE22F17I7 | IC CYCLONE IV FPGA 22K 256FBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M1A3P600-VQ144 | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3 Flash Family FPGAs |
| M1A3P600-VQ144ES | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3 Flash Family FPGAs |
| M1A3P600-VQ144I | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3 Flash Family FPGAs |
| M1A3P600-VQ144PP | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3 Flash Family FPGAs |
| M1A3P600-VQG144 | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3 Flash Family FPGAs |
發布緊急采購，3分鐘左右您將得到回復。