參數資料
型號： M29F800FB55N3E2
元件分類： PROM
英文描述： 512K X 16 FLASH 5V PROM, 55 ns, PDSO48
封裝： 12 X 20 MM, ROHS COMPLIANT, PLASTIC, TSOP1-48
文件頁數： 13/65頁
文件大小： 1669K
代理商： M29F800FB55N3E2
Signal Descriptions
M29FxxxFT, M29FxxxFB
20/65
2.7
Write Enable (W).
The Write Enable, W, controls the Bus Write operation of the memory’s Command Interface.
2.8
Reset/Block Temporary Unprotect (RP).
The Reset/Block Temporary Unprotect pin can be used to apply a Hardware Reset to the
memory or to temporarily unprotect all Blocks that have been protected.
A Hardware Reset is achieved by holding Reset/Block Temporary Unprotect Low, VIL, for at
least tPLPX. After Reset/Block Temporary Unprotect goes High, VIH, the memory will be
ready for Bus Read and Bus Write operations after tPHEL or tRHEL, whichever occurs last.
See the Ready/Busy Output section, Table Table 18. and Figure Figure 22.,
Reset/Temporary Unprotect AC Characteristics for more details.
Holding RP at VID will temporarily unprotect the protected Blocks in the memory. Program
and Erase operations on all blocks will be possible. The transition from VIH to VID must be
slower than tPHPHH.
2.9
Ready/Busy Output (RB).
The Ready/Busy pin is an open-drain output that can be used to identify when the device is
performing a Program or Erase operation. During Program or Erase operations Ready/Busy
is Low, VOL. Ready/Busy is high-impedance during Read mode, Auto Select mode and
Erase Suspend mode.
After a Hardware Reset, Bus Read and Bus Write operations cannot begin until Ready/Busy
becomes high-impedance. See Table Table 18. and Figure Figure 22., Reset/Temporary
Unprotect AC Characteristics.
The use of an open-drain output allows the Ready/Busy pins from several memories to be
connected to a single pull-up resistor. A Low will then indicate that one, or more, of the
memories is busy.
2.10
Byte/Word Organization Select (BYTE).
The Byte/Word Organization Select pin is used to switch between the 8-bit and 16-bit Bus
modes of the memory. When Byte/Word Organization Select is Low, VIL, the memory is in 8-
bit mode, when it is High, VIH, the memory is in 16-bit mode.
2.11
VCC Supply Voltage.
The VCC Supply Voltage supplies the power for all operations (Read, Program, Erase etc.).
The Command Interface is disabled when the VCC Supply Voltage is less than the Lockout
Voltage, VLKO. This prevents Bus Write operations from accidentally damaging the data
during power up, power down and power surges. If the Program/Erase Controller is
programming or erasing during this time then the operation aborts and the memory contents
being altered will be invalid.
相關PDF資料
PDF描述
MC12L1NZGF ROTARY SWITCH-12POSITIONS, SP12T, LATCHED, 0.25A, 28VDC, PANEL MOUNT-THREADED
MD00S1NCQF ROTARY SWITCH-6POSITIONS, DP6T, LATCHED, 0.25A, 28VDC, THROUGH HOLE-STRAIGHT
MD06L1NZGD ROTARY SWITCH-6POSITIONS, DP6T, LATCHED, 0.25A, 28VDC, PANEL MOUNT-THREADED
MD06L2NCQD ROTARY SWITCH-6POSITIONS, DP6T, LATCHED, 0.25A, 28VDC, THROUGH HOLE-STRAIGHT
ME00L1NZQD ROTARY SWITCH-10POSITIONS, SP10T, LATCHED, 0.25A, 28VDC, PANEL MOUNT-THREADED
相關代理商/技術參數
參數描述
M29F800FB55N3F2 制造商:Micron Technology Inc 功能描述:NOR Flash Parallel 5V 8Mbit 1M/512K x 8bit/16bit 55ns 48-Pin TSOP T/R 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Tape and Reel 制造商:Micron Technology 功能描述:NOR Flash Parallel 5V 8Mbit 1M/512K x 8bit/16bit 55ns 48-Pin TSOP T/R
M29F800FB55N3F2 TR 制造商:Micron Technology Inc 功能描述:IC FLASH 8MBIT 55NS 48TSOP
M29F800FB5AM6E2 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays
M29F800FB5AM6F2 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Tape and Reel
M29F800FB5AM6F2 TR 制造商:Micron Technology Inc 功能描述:IC FLASH 8MBIT 55NS 44SO
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*