參數資料
型號： M30842MC-XXXGP
元件分類： 微控制器/微處理器
英文描述： 32-BIT, MROM, 32 MHz, MICROCONTROLLER, PQFP144
封裝： 20 X 20 MM, 0.50 MM PITCH, PLASTIC, LQFP-144
文件頁數： 41/91頁
文件大?。?/td> 903K
代理商： M30842MC-XXXGP
45
38C2 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
WATCHDOG TIMER
The watchdog timer gives a mean of returning to the reset status
when a program cannot run on a normal loop (for example, because
of a software run-away). The watchdog timer consists of an 8-bit
counter.
Initial Value of Watchdog Timer
At reset or writing to the watchdog timer control register, each watch-
dog timer is set to “FF16.” Instructions such as STA, LDM and CLB to
generate the write signals can be used.
The written data in bits 0 to 5 are not valid, and the above values are
set.
Standard Operation of Watchdog Timer
The watchdog timer is in the stop state at reset and the watchdog
timer starts to count down by writing an optional value in the watch-
dog timer control register. An internal reset occurs at an underflow of
the watchdog timer. Then, reset is released after the reset release
time is elapsed, the program starts from the reset vector address.
Normally, writing to the watchdog timer control register before an
underflow of the watchdog timer is programmed. If writing to the watch-
dog control register is not executed, the watchdog timer does not
operate.
Fig. 44 Timing diagram of reset output
When reading the watchdog timer control register is executed, the
contents of the high-order 6-bit counter and the STP instruction dis-
able bit (bit 6), and the count source selection bit (bit 7) are read out.
When the STP instruction disable bit is “0”, the STP instruction is
valid. The STP instruction is disabled by writing to “1” to this bit. In
this time, when the STP instruction is executed, it is handled as the
undefined instruction, the internal reset occurs. This bit cannot be
cleared to “0” by program. This bit is “0” after reset.
The time until the underflow of the watchdog timer control register
after writing to the watchdog timer control register is executed is as
follows (when the bit 7 of the watchdog timer control register is “0”) ;
at frequency/2/4/8 mode (f(XIN)) = 8 MHz): 32.768 ms
at low-speed mode (f(XCIN) = 32 KHz): 8.19s
s Note
The watchdog timer continues to count even during the wait time set
by timer 1 and timer 2 to release the stop state and in the wait mode.
Accordingly, do not underflow the watchdog timer in this time.
Fig. 42 Block diagram of Watchdog timer
Fig. 43 Structure of Watchdog timer control register
b0
STP instruction disable bit
0: STP instruction enabled
1: STP instruction disabled
Watchdog timer count source selection bit
0: 1/1024 of system clock
1: 1/4 of system clock
Watchdog timer H (for read-out of high-order 6 bit)
“FF16” is set to watchdog timer by writing to these bits.
Watchdog timer control register
(WDTCON : address 003716)
b7
Internal reset
signal
Watchdog timer detected
≈ 32msec (at f(XIN)=8MHZ)
f(XIN)
XIN
XCIN
System clock control
bit (bit 6)
1/1024
Undefined instruction
Reset
RESET
Wait until reset release
1/4
Data bus
Watchdog timer H
count source
selection bit
Reset
circuit
STP instruction disable bit
Watchdog timer
H (6)
Internal reset
STP instruction
Watchdog timer
L (2)
“FF16” is set when
watchdog timer
control register is
written to.
“0”
“1”
“0”
“1”
相關PDF資料
PDF描述
M30843FJGP 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP100
M30843FJTGP 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP100
M30843MW-XXXFP 32-BIT, MROM, 32 MHz, MICROCONTROLLER, PQFP100
M30845FHTGP 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP144
M30840ME-XXXGP 32-BIT, MROM, 32 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M30842ME-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16/32-BIT CMOS MICROCOMPUTER
M30842SGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16/32-BIT CMOS MICROCOMPUTER
M30842SGP#U3 功能描述:MCU 3/5V 0K I-TEMP 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M32C/80/84 產品培訓模塊:CAN Basics Part-1 CAN Basics Part-2 Electromagnetic Noise Reduction Techniques Part 1 M16C Product Overview Part 1 M16C Product Overview Part 2 標準包裝:1 系列:M16C™ M32C/80/87 核心處理器:M32C/80 芯體尺寸:16/32-位 速度:32MHz 連通性:EBI/EMI，I²C，IEBus，IrDA，SIO，UART/USART 外圍設備:DMA，POR，PWM，WDT 輸入/輸出數:121 程序存儲器容量:384KB（384K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:24K x 8 電壓 - 電源 (Vcc/Vdd):3 V ~ 5.5 V 數據轉換器:A/D 34x10b，D/A 2x8b 振蕩器型:內部 工作溫度:-20°C ~ 85°C 封裝/外殼:144-LQFP 包裝:托盤 產品目錄頁面:749 (CN2011-ZH PDF) 配用:R0K330879S001BE-ND - KIT DEV RSK M32C/87
M30842SGP#U5 功能描述:IC M32C MPU ROMLESS 144LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M32C/80/84 標準包裝:1 系列:87C 核心處理器:MCS 51 芯體尺寸:8-位 速度:16MHz 連通性:SIO 外圍設備:- 輸入/輸出數:32 程序存儲器容量:8KB（8K x 8） 程序存儲器類型:OTP EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4 V ~ 6 V 數據轉換器:- 振蕩器型:外部 工作溫度:0°C ~ 70°C 封裝/外殼:44-DIP 包裝:管件 其它名稱:864285
M30843FHFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16/32-BIT CMOS MICROCOMPUTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*