參數(shù)資料
型號: M37225M6
廠商: Mitsubishi Electric Corporation
英文描述: Single Chip 8 Bits Microcomputer(8位單片機)
中文描述: 單芯片8位單片機(8位單片機)
文件頁數(shù): 87/133頁
文件大?。?/td> 1610K
代理商: M37225M6
87
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
M37225M6–XXXSP, M37225M8–XXXSP
M37225ECSP
MITSUBISHI MICROCOMPUTERS
Rev. 1.0
8.13 CLOCK GENERATING CIRCUIT
The built-in clock generating circuit is shown in Figure 8.13.3. When
the STP instruction is executed, the internal clock
φ
stops at HIGH.
At the same time, timers 3 and 4 are connected by hardware and
“FF
16
” is set in timer 3 and “07
16
” is set in the timer 4. Select f(X
IN
)/16
as the timer 3 count source (set bit 0 of the timer mode register 2 to
“0” before the execution of the STP instruction). Moreover, set the
timer 3 and timer 4 interrupt enable bits to disabled (“0”) before ex-
ecution of the STP instruction). The oscillator restarts when external
interrupt is accepted. However, the internal clock
φ
keeps its HIGH
until timer 4 overflows, allowing time for oscillation stabilization when
a ceramic resonator or a quartz-crystal oscillator is used.
When the WIT instruction is executed, the internal clock
φ
stops in
the HIGH but the oscillator continues running. This wait state is re-
leased when an interrupt is accepted (See note). Since the oscillator
does not stop, the next instruction can be executed at once.
When returning from the stop or the wait state, to accept an interrupt,
set the corresponding interrupt enable bit to “1” before executing the
STP or the WIT instructions.
Note:
In the wait mode, the following interrupts are invalid.
V
SYNC
interrupt
OSD interrupt
Timer 2 interrupt using external clock input from TIM2 pin as count
source
Timer 3 interrupt using external clock input from TIM3 pin as count
source
Timer 4 interrupt using f(X
IN
)/2 as count source
Timer 1 interrupt using f(X
IN
)/4096 as count source
f(X
IN
)/4096 interrupt
Multi-master I
2
C-BUS interface interrupt
A-D conversion interrupt
SPRITE interrupt
A circuit example using a ceramic resonator (or a quartz-crystal os-
cillator) is shown in Figure 8.13.1. Use the circuit constants in accor-
dance with the resonator manufacture’s recommended values. A cir-
cuit example with external clock input is shown in Figure 8.13.2. In-
put the clock to the X
IN
pin, and open the X
OUT
pin.
Fig.8.13.1 Ceramic Resonator Circuit Example
Fig.8.13.2 External Clock Input Circuit Example
X
IN
X
OUT
C
IN
Microcomputer
C
OUT
X
IN
Microcomputer
Vcc
Vss
External oscillation circuit
Fig.8.13.3 Clock Generating Circuit Block Diagram
Interrupt request
Interrupt disable
flag I
Reset
S
Q
R
STP instruction
S
Q
R
WIT
instruction
S
Q
R
STP
instruction
Reset
Internal clock
φ
1/2
1/8
Timer 3
Timer 4
X
OUT
X
IN
TM20
TM22
Selection gate :
Connected to black
side at reset.
TM2 : Timer mode register 2
相關PDF資料
PDF描述
M37225M8 SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37702M4AXXXFP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M37702M4BXXXFP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M37702S4AFP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M37702S4BFP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
相關代理商/技術參數(shù)
參數(shù)描述
M37225M8 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37225MA 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M372429100 制造商:ITW Switches 功能描述:IN-RUSH
M372429200 制造商:ITW Switches 功能描述:IN-RUSH
M372499100 制造商:ITW Switches 功能描述:IN-RUSH