參數資料
型號: M37906M4H-XXXSP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
封裝: 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-42
文件頁數: 29/99頁
文件大?。?/td> 1313K
代理商: M37906M4H-XXXSP
58
After that, the AT86RF212 switches to receive mode and expects an acknowledgement
response, which is indicated by register subfield TRAC_STATUS (register 0x02,
TRX_STATE) set to SUCCESS_WAIT_FOR_ACK. After a period of aTurnaroundTime
+ aUnitBackoff, the transmission of the ACK frame must have started. During the entire
transaction, including frame transmit, wait for ACK, and ACK receive, the radio
transceiver status register TRX_STATUS (register 0x01, TRX_STATUS) signals
BUSY_TX_ARET.
A successful reception of the acknowledgment frame is indicated by interrupt IRQ_3
(TRX_END). The status register TRX_STATUS (register 0x01, TRX_STATUS) changes
back to TX_ARET_ON. At the same time, register TRAC_STATUS changes to
SUCCESS or to SUCCESS_DATA_PENDING if the “Frame Pending” subfield of the
acknowledgment frame was set to 1.
Figure 5-13. Exemplary Timing of a TX_ARET Transaction (without Pending Data Bit set in ACK Frame)
Frame
on
Ai
r
5.2.5 Interrupt Handling
The interrupt handling in the Extended Operating Mode is similar to the Basic Operating
Mode. Interrupts can be enabled by setting the appropriate bit in register 0x0E
(IRQ_MASK).
For RX_AACK and TX_ARET, the following interrupts inform about the status of a
frame reception and transmission:
IRQ_2 (RX_START)
IRQ_3 (TRX_END)
IRQ_5 (AMI)
For RX_AACK mode, it is recommended to enable only interrupt IRQ_3 (TRX_END).
This interrupt is issued only if the Frame Filter (see section 6.2) reports a matching
address and the FCS is valid (see section 6.3). The usage of other interrupts is
optional.
On reception of a frame, the RX_START interrupt indicates the detection of a correct
synchronization header (SHR) and a non-zero PHY header (PHR). This interrupt is
issued after the PHR. AMI indicates address match, refer to filter rules in section 6.2.
AT86RF212
8168C-MCU Wireless-02/10
相關PDF資料
PDF描述
M37906M4C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M6C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
M37906M4C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42
M37906M4C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
相關代理商/技術參數
參數描述
M37906M6C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M6C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M8C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M8C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906T-PRB 功能描述:DEV POD PROBE FOR M37900T2-RPD-E RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF)