參數資料
型號: M38198MC-XXXKP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, MICROCONTROLLER, PQFP100
封裝: 100P6P-E
文件頁數: 95/217頁
文件大小: 2564K
代理商: M38198MC-XXXKP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁當前第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁
3. APPENDIX
171
MITSUBISHI MICROCOMPUTER
3819 Group
3.1 Notes on use
3819 Group USER’S MANUAL
<Note 3>
The comparator uses internal capacitors whose charge will be lost if the clock frequency is too low. Thus, make sure
the following during an A-D conversion.
q f(XIN) is 500 kHz or more .
q Do not execute the STP instruction and WIT instruction.
3.1.4 Notes on the RESET pin
<Note>
n case where the RESET signal rise time is long, connect a ceramic capacitor or others across the RESET pin and
the VSS pin. And use a 1000 pF or more capacitor for high frequency use. When connecting the capacitor, note the
following :
qMake the length of the wiring which is connected to a capacitor.
qBe sure to check the operation of application products on the user side.
Reason
If the several nanosecond or several ten nanosecond impulse noise enters the RESET pin, it may cause a
microcomputer failure.
3.1.5 Notes on input and output pins
<Note 1>
In stand-by state* for low-power dissipation, do not make input levels of an input and an I/O port “undefined,“
especially for the I/O ports of the P-channel and the N-channel open-drain.
Pull-up (connect the port to VCC) or pull-down (connect the port to VSS) these ports through a resistor.
When determining a resistance value, note the following points:
qExternal circuit
qVariation of output levels during the ordinary operation
When using built-in pull-up or pull-down resistor as an option, note on varied current values.
qWhen setting as an input port : Fix its input level
qWhen setting as an output port : Prevent current from flowing out to external
Reason
Even when setting as an output port with its direction register, in the following state :
qP-channel......when the content of the data register (port latch) is “0”
qN-channel......when the content of the data register (port latch) is “1”
the transistor becomes the OFF state, which causes the ports to be the high-impedance state. Note that the level
becomes “undefined” depending on external circuits.
Accordingly, the potential which is input to the input buffer in a microcomputer is unstable in the state that input levels
of an input and an I/O port are “undefined.” This may cause power source current.
* stand-by state : the stop mode by executing the STP instruction
the wait mode by executing the WIT instruction
相關PDF資料
PDF描述
M38199MF-XXXFP 8-BIT, MROM, MICROCONTROLLER, PQFP100
M38203E4-XXXHP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP80
M38203M4-XXXHP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M38207M8-XXXFP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M38207E8-XXXFP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
M38199MF072F 制造商:Panasonic Industrial Company 功能描述:IC
M38199MF210F 制造商:Panasonic Industrial Company 功能描述:IC
M38199MF217 制造商:Panasonic Industrial Company 功能描述:IC
M38199MF219F 制造商:Panasonic Industrial Company 功能描述:IC
M38199MF227 制造商:Panasonic Industrial Company 功能描述:IC