參數資料
型號: M38258MCMXXXHP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100
封裝: 12 X 12 MM, 0.40 MM PITCH, PLASTIC, TQFP-100
文件頁數: 22/70頁
文件大?。?/td> 994K
代理商: M38258MCMXXXHP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
3825 Group
29
(2) Asynchronous Serial I/O (UART) Mode
Clock asynchronous serial I/O mode (UART) can be selected by
clearing the serial I/O mode selection bit of the serial I/O control
register to “0”.
Eight serial data transfer formats can be selected, and the transfer
formats used by a transmitter and receiver must be identical.
The transmit and receive shift registers each have a buffer regis-
ter, but the two buffers have the same address in memory. Since
the shift register cannot be written to or read from directly, transmit
data is written to the transmit buffer, and receive data is read from
the receive buffer.
The transmit buffer can also hold the next data to be transmitted,
and the receive buffer register can hold a character while the next
character is being received.
Fig. 25 Block diagram of UART serial I/O
Fig. 26 Operation of UART serial I/O function
f(XIN)
1/4
OE
PE FE
1/16
Data bus
Receive buffer register
Address 001816
Receive shift register
Receive buffer full flag (RBF)
Receive interrupt request (RI)
Baud rate generator
Frequency division ratio 1/(n+1)
Address 001C16
ST/SP/PA generator
Transmit buffer register
Data bus
Transmit shift register
Address 001816
Transmit shift register shift completion flag (TSC)
Transmit buffer empty flag (TBE)
Transmit interrupt request (TI)
Address 001916
STdetector
SP detector
UART control register
Address 001B16
Character length selection bit
Address 001A16
BRG count source selection bit
Transmit interrupt source selection bit
Serial I/O synchronization clock selection bit
Clock control circuit
Character length selection bit
7 bits
8 bits
Serial I/O control register
P46/SCLK
Serial I/O status register
P44/RXD
P45/TXD
( f(XCIN) in low-speed
mode)
TSC=0
TBE=1
RBF=0
TBE=0
RBF=1
ST
D0
D1
SP
D0
D1
ST
SP
TBE=1
TSC=1
ST
D0
D1
SP
D0
D1
ST
SP
Transmit buffer write signal
Generated at 2nd bit in 2-stop-bit mode
1 start bit
7 or 8 data bits
1 or 0 parity bit
1 or 2 stop bit (s)
1 : Error flag detection occurs at the same time that the RBF flag becomes “1” (at 1st stop bit, during reception).
2 : The transmit interrupt (TI) can be generated to occur when either the TBE or TSC flag becomes “1”, depending on the setting of the transmit interrupt
source selection bit (TIC) of the serial I/O control register.
3 : The receive interrupt (RI) is set when the RBF flag becomes “1”.
4 : After data is written to the transmit buffer register when TSC=1, 0.5 to 1.5 cycles of the data shift cycle is necessary until changing to TSC=0.
Notes
Serial output TXD
Serial input RXD
Receive buffer read signal
Transmit or receive clock
相關PDF資料
PDF描述
M38258MCDXXXFP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100
M38259EFHP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP100
M38259EFFP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP100
M38259EFGP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP100
M38258MCMXXXHP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M3826 功能描述:電纜固定件和配件 LTRSCG 1000 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M3826 BK001 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 1000'
M3826 BK002 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 500'
M3826 BK005 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 100'
M3826 BK199 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 3000=3000'