參數資料
型號: M95020-DW6TP
廠商: 意法半導體
元件分類: EEPROM
英文描述: 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
中文描述: 4Kbit,2Kbit和1Kbit SPI總線串行EEPROM的高速時鐘
文件頁數: 17/37頁
文件大小: 586K
代理商: M95020-DW6TP
17/37
M95040, M95020, M95010
Write to Memory Array (WRITE)
As shown in
Figure 13.
, to send this instruction to
the device, Chip Select (S) is first driven Low. The
bits of the instruction byte, address byte, and at
least one data byte are then shifted in, on Serial
Data Input (D).
The instruction is terminated by driving Chip Se-
lect (S) High after the rising edge of Serial Clock
(C) that latches the last data bit, and before the
next rising edge of Serial Clock (C) occurs any-
where on the bus. In the case of
Figure 13.
, this
occurs after the eighth bit of the data byte has
been latched in, indicating that the instruction is
being used to write a single byte. The self-timed
Write cycle starts, and continues for a period t
WC
(as specified in
Table 18.
to
Table 22.
), at the end
of which the Write in Progress (WIP) bit is reset to
0.
If, though, Chip Select (S) continues to be driven
Low, as shown in
Figure 14.
, the next byte of input
data is shifted in. In this way, all the bytes from the
given address to the end of the same page can be
programmed in a single instruction.
If Chip Select (S) still continues to be driven Low,
the next byte of input data is shifted in, and is used
to overwrite the byte at the start of the current
page.
The instruction is not accepted, and is not execut-
ed, under the following conditions:
if the Write Enable Latch (WEL) bit has not
been set to 1 (by executing a Write Enable
instruction just before)
if a Write cycle is already in progress
if the device has not been deselected, by Chip
Select (S) being driven High, at a byte
boundary (after the rising edge of Serial Clock
(C) that latches the last data bit, and before
the next rising edge of Serial Clock (C) occurs
anywhere on the bus)
if Write Protect (W) is Low or if the addressed
page is in the region protected by the Block
Protect (BP1 and BP0) bits.
Figure 13. Byte Write (WRITE) Sequence
Note: Depending on the memory size, as shown in
Table 6.
, the most significant address bits are Don’t Care.
AI01442D
C
D
S
Q
A7
2
1
3
4
5
6
7
8
9 10 11 12 13 14 15 16 17 18 19
A6 A5 A4 A3 A2 A1 A0
A8
20 21 22 23
High Impedance
Instruction
Byte Address
0
7
6
5
4
3
2
0
1
Data Byte
相關PDF資料
PDF描述
M95020-DW6TG 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-DW6T 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-DW6P 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-BN6 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-BN5T 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
相關代理商/技術參數
參數描述
M95020-DW6TP/W 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-DWDW4TP/K 功能描述:IC EEPROM 2KBIT SPI BUS 8TSSOP 制造商:stmicroelectronics 系列:- 包裝:剪切帶(CT) 零件狀態:有效 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:2K(256 x 8) 速度:20MHz 接口:SPI 串行 電壓 - 電源:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 145°C(TA) 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 供應商器件封裝:8-TSSOP 標準包裝:1
M95020MN 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-MN3 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
M95020-MN3/W 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock