- 您現在的位置：買賣IC網 > PDF目錄377840 > M95040 (意法半導體) 4K Serial SPI EEPROM with High Speed Clock and Positive Clock Strobe(帶高速時鐘和正向時鐘選通的4K串聯SPI EEPROM) PDF資料下載
參數資料
| 型號： | M95040 |
| 廠商： | 意法半導體 |
| 元件分類： | DRAM |
| 英文描述： | 4K Serial SPI EEPROM with High Speed Clock and Positive Clock Strobe(帶高速時鐘和正向時鐘選通的4K串聯SPI EEPROM) |
| 中文描述： | 4K的串行SPI EEPROM，帶有高速時鐘和積極的時鐘選通（帶高速時鐘和正向時鐘選通的4K的串聯的SPI EEPROM的） |
| 文件頁數： | 3/20頁 |
| 文件大?。?/td> | 151K |
| 代理商： | M95040 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
AI01438
C
C
MSB
LSB
CPHA
D or Q
0
1
CPOL
0
1
Figure 3. Data and Clock Timing
AI00869
SPI Interface with
(CPOL, CPHA) =
('0', '0') or ('1', '1')
MICROCONTROLLER
(ST6, ST7, ST9, ST10, OTHERS)
M95xx0
SCK
SDI
SDO
C
Q
D
Figure 4. Microcontroller and SPI Interface Set-up
Serial Clock (C).
The serial clock provides the
timing of the serial interface. Instructions, ad-
dresses, or data present at the input pin are latched
on the rising edge of the clock input, while data on
the Q pin changes after the falling edge of the clock
input.
Chip Select (S).
When S is high, the Memory is
deselected and the Q output pin is at high imped-
ance and, unless an internal write operation is
underway the Memory will be in the standby power
mode. S low enables the Memory, placing it in the
active power mode. For a safe design, it should be
noted that during power up, the S input must be
driven constantly high (or low) but must NOT be left
floating until the supplied voltage reaches the
specified V
CC
value. After power up, a high to low
transition on S is required prior to the start of any
operation.
Write Protect (W).
This pin is for hardware write
protection. When W is low, writes to the Memory
are disabled but any other operations stay enabled.
When W is high, all writes operations are available.
W going low at any time before the last bit D0 of
the data stream will reset the write enable latch and
prevent programming. No action on W or on the
write enable latch can interrupt a write cycle which
has commenced.
3/20
M95040, M95020, M95010
相關PDF資料 |
PDF描述 |
|---|---|
| M95010 | 1K Serial SPI EEPROM with High Speed Clock and Positive Clock Strobe(帶高速時鐘和正向時鐘選通的1K串聯SPI EEPROM) |
| M95080-R | 16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock |
| M95080-W | 16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock |
| M95160-R | 16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock |
| M95160-W | 16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M95040_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Kbit, 2 Kbit and 1 Kbit Serial SPI bus EEPROM with high speed Clock |
| M95040_08 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Kbit, 2 Kbit and 1 Kbit serial SPI bus EEPROM with high-speed clock |
| M95040_09 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4 Kbit, 2 Kbit and 1 Kbit serial SPI bus EEPROM with high-speed clock |
| M950400WMN6T | 制造商:ST MICRO 功能描述:New |
| M95040BN | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock |
發布緊急采購，3分鐘左右您將得到回復。