- 您現在的位置：買賣IC網 > PDF目錄9774 > MAX13234EIUP+ (Maxim Integrated Products)TXRX RS-232 250KBPS 2X2 20TSSOP PDF資料下載
參數資料
| 型號： | MAX13234EIUP+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | TXRX RS-232 250KBPS 2X2 20TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 74 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/2 |
| 規程： | RS232 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 管件 |
MAX13234E–MAX13237E
3Mbps RS-232 Transceivers with
Low-Voltage Interface
10
______________________________________________________________________________________
Detailed Description
VL Logic Supply Input
The MAX13234E–MAX13237E feature a separate logic
supply input (VL) that sets the receiver’s output level
(VOH), and sets the transmitter’s input thresholds (VIL,
VIH). This feature allows flexibility in interfacing to
UARTs or communication controllers that have different
logic levels. Connect this input to the host logic supply
(1.62V ≤ VL ≤ VCC).
Dual Charge-Pump Voltage Converter
The internal power supply consists of a regulated dual
charge pump that provides output voltages of +5.5V
and -5.5V (inverting charge pump), over the +3.0V to
+5.5V range. The charge pump operates in discontinu-
ous mode: if the output voltages are less than +5.5V,
the charge pump is enabled; if the output voltages
exceed +5.5V, the charge-pump is disabled. The
charge pumps require flying capacitors (C1, C2) and
reservoir capacitors (C3, C4) to generate the V+ and V-
supplies. The READY output is low when the charge
pumps are disabled in shutdown mode. The READY
signal asserts high when V- goes below -4V.
RS-232 Transmitters
The transmitters are inverting level translators that con-
vert CMOS-logic levels to ±5.0V EIA/TIA-232 levels.
The MAX13234E/MAX13236E guarantee a 250kbps
data rate with worst-case loads of 3k in parallel with
1000pF. The MAX13235E/MAX13237E guarantee a
1Mbps data rate with worst-case loads of 3k in paral-
lel with 250pF, and a 3Mbps data rate with worst-case
loads of 3k in parallel with 150pF. Transmitters can be
paralleled to drive multiple receivers. When FORCEOFF
is driven to ground or when the AutoShutdown Plus cir-
cuitry senses that all receiver and transmitter inputs are
inactive for more than 30s, the transmitters are disabled
and the outputs go into a high-impedance state. When
powered off or shut down, the outputs can be driven to
±12V. The transmitter inputs do not have pullup resis-
tors. Connect unused inputs to GND or VL.
RS-232 Receivers
The receivers convert RS-232 signals to CMOS-logic
output levels. The MAX13234E–MAX13237E have
inverting outputs that are active when in shutdown
(FORCEOFF = GND) (Table 1).
AutoShutdown Plus Mode
Drive FORCEOFF high and FORCEON low to invoke
AutoShutdown Plus mode. When these devices do not
sense a valid signal transition on any receiver and
transmitter input for 30s, the onboard charge pumps
are shut down, reducing supply current to 1A. This
occurs if the RS-232 cable is disconnected or
if the devices driving the transmitter and receiver
inputs are inactive for more than 30s. The
MAX13234E–MAX13237E turn on again when a valid
transition is applied to any RS-232 receiver or transmit-
ter input. As a result, the system saves power without
requiring any control.
Figure 6 and Table 1 summarize the MAX13234E–
MAX13237E operating modes. The FORCEON and
FORCEOFF inputs override AutoShutdown Plus circuit-
ry. When neither control is asserted, the IC selects
between these states automatically based on the last
receiver or transmitter input edge received.
Hardware-Controlled Shutdown
Drive FORCEOFF low to place the MAX13234E–
MAX13237E into shutdown mode.
FORCEON
MASTER SHDN LINE
0.1F1M
FORCEOFF
MAX13234E
MAX13235E
MAX13236E
MAX13237E
POWER-
MANAGEMENT
UNIT
Figure 7. AutoShutdown Plus Initial Turn-On to Wake Up a
Mouse or Another System
相關PDF資料 |
PDF描述 |
|---|---|
| MS3106A32-2PY | CONN PLUG 5POS STRAIGHT W/PINS |
| MAX13235EIUP+ | TXRX RS-232 3MBPS 2X2 20TSSOP |
| MS3106A32-2PX | CONN PLUG 5POS STRAIGHT W/PINS |
| MAX13235EETP+ | TXRX RS-232 3MBPS 2X2 20TQFN |
| MS3106A32-2PW | CONN PLUG 5POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX13234EIUP+ | 功能描述:RS-232接口集成電路 3-5.5V 250Kbps RS232 Line Driver/Receiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX13234EIUP+T | 功能描述:RS-232接口集成電路 3-5.5V 250Kbps RS232 Line Driver/Receiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX13235EETP | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX13235EETP+ | 功能描述:RS-232接口集成電路 3-5.5V 3Mbps RS232 Line Driver/Receiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX13235EETP+GH7 | 功能描述:RS-232接口集成電路 3Mbps RS-232 Transceivers with Low-Voltage Interface RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。