- 您現在的位置：買賣IC網 > PDF目錄16288 > MAX14566EEVKIT# (Maxim Integrated Products)EVAL KIT PDF資料下載
參數資料
| 型號： | MAX14566EEVKIT# |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVAL KIT |
| 標準包裝： | 1 |
| 系列： | * |
MAX14566E/MAX14566AE/MAX14566BE
USB Host Charger Identification
Analog Switches
11
with CB1. Connect CB1 to a logic-level low for auto mode
(AM) or connect CB1 to a logic-level high for forced
dedicated-charger mode (FM).
Autodetection
All the devices feature autodetection charger mode for
dedicated chargers and USB masters. CB must be set
low to activate autodetection charger mode.
In autodetection charger mode, the MAX14566E moni-
tors the voltages at DM and DP to determine the type of
the device attached. If the voltage at DM is +2.3V (typ)
or higher and the voltage at DP is +2.3V (typ) or lower,
the voltage stays unchanged.
If the voltage at DM is forced below the +2.3V (typ)
threshold, the internal switch disconnects DM and DP
from the resistor-divider and DP and DM are shorted
together for dedicated charging mode.
If the voltage at DP is forced higher than the +2.3V (typ)
threshold, the internal switch disconnects DM and DP
from the resistor-divider and DP and DM are shorted
together for dedicated charging mode.
Once the charging voltage is removed, the short between
DP and DM is disconnected for normal operation.
Automatic Peripheral Reset
The MAX14566E/MAX14566AE feature automatic current-
limit switch control output. This feature resets the peripher-
al connected to VBUS in the event the USB host switches to
or from standby mode. CEN/CEN provide a 1s (typ) pulse
on the rising or falling edge of CB (Figures 4, 5, and 6).
Table 1. Digital Input State (MAX14566E/MAX14566AE)
Table 2. Digital Input State (MAX14566BE)
Figure 4. MAX14566E Peripheral Reset Timing Diagram
X = Don't care.
ATTACH
CEN
VBUS
CB
5V
AM
PM
AM
USB PERIPHERAL
STANDBY
tVBT
USB CONNECTION
CHARGING CURRENT
1000mA
500mA
1000mA
500mA
1000mA
CB
MODE
DP/DM
COMMENT
INTERNAL RESISTOR-DIVIDER
0
AM
Autodetection Circuit Active
Auto Mode
Connected
1
PM
Connected to TDP/TDM
USB Traffic Active
Not Connected
CB
CB1
MODE
STATUS
0
AM
Auto Mode
0
1
FM
Forced Dedicated-Charger Mode: DP/DM Shorted
1
X
PM
Pass-Through (USB) Mode: Connect DP/DM to TDP/TDM
相關PDF資料 |
PDF描述 |
|---|---|
| RSM08DRYH-S13 | CONN EDGECARD 16POS .156 EXTEND |
| MAX98089EVKIT#WLP | KIT EVAL FOR MAX98089-WLP |
| RMM08DRYH-S13 | CONN EDGECARD 16POS .156 EXTEND |
| MAX98089EVKIT#TQFN | KIT EVAL FOR MAX98089-TQFN |
| GBM24DSEF-S13 | CONN EDGECARD 48POS .156 EXTEND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX14566EEVKIT# | 功能描述:交換機 IC 開發工具 MAX14566E Eval Kit RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
| MAX14566ETA+T | 功能描述:模擬開關 IC USB HiSpeed an swtch w/USB host chrgr IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX14566EVKIT+ | 功能描述:交換機 IC 開發工具 MAX14566 EVKIT RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
| MAX14568EEWA+T | 功能描述:多路器開關 IC Dual 8:2 MUX RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻（最大值）:7 Ohms 開啟時間（最大值）: 關閉時間（最大值）: 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16 |
| MAX14569EEE+ | 功能描述:轉換 - 電壓電平 Dual LLT w/Cpump & ESD Protection RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
發布緊急采購，3分鐘左右您將得到回復。