• 參數資料
    型號: MAX3098EAEPE+
    廠商: Maxim Integrated Products
    文件頁數: 3/16頁
    文件大小: 0K
    描述: IC RS485/422 RX 32MBPS 16-DIP
    產品培訓模塊: Lead (SnPb) Finish for COTS
    Obsolescence Mitigation Program
    標準包裝: 25
    類型: 接收器
    驅動器/接收器數: 0/3
    規(guī)程: RS422,RS485
    電源電壓: 3 V ~ 5.5 V
    安裝類型: 通孔
    封裝/外殼: 16-DIP(0.300",7.62mm)
    供應商設備封裝: 16-PDIP
    包裝: 管件
    MAX3097E/MAX3098E
    ±15kV ESD-Protected, 32Mbps, 3V/5V,
    Triple RS-422/RS-485 Receivers with Fault Detection
    ______________________________________________________________________________________
    11
    Common-Mode Range
    The MAX3097E/MAX3098E contain circuitry that de-
    tects if the input stage is going outside its useful com-
    mon-mode range. If the received data could be
    unreliable, a fault signal is triggered.
    Detecting Low Input Differential
    Due to cable attenuation on long wire runs, it is possi-
    ble that VID < 200mV, and incorrect data will be
    received. In this condition, a fault will be indicated.
    Delayed Fault Output
    The delayed fault output provides a programmable
    blanking delay to allow transient faults to occur without
    triggering an alarm. Such faults may occur with slow
    signals triggering the receiver alarm through the zero
    crossover region.
    Figure 9 shows the delayed alarm output.
    ALARMD performs a logic OR of ALARMA, ALARMB,
    and ALARMZ (Figure 10). A NOR gate drives an N-
    channel MOSFET so that in normal operation with no
    faults, the current source (10A typ) is shunted to
    ground. Upon activation of any alarm from receiver A,
    B, or Z, the MOSFET is turned off, allowing the current
    source to charge CDELAY. When VDELAY exceeds the
    DELAY threshold, the comparator output, ALARMD,
    goes high. ALARMD is reset when all receiver alarms
    go low, quickly discharging CDELAY to ground.
    Setting Delay Time
    ALARMD’s delay time is set with a single capacitor
    connected from DELAY to GND. The delay comparator
    threshold varies with supply voltage, and the CDELAY
    value can be determined for a given time delay period
    from the Capacitance vs. ALARMD Output Delay graph
    in the Typical Operating Characteristics or using the
    following equations:
    tD = 15 + 0.33 x CDELAY (for VCC = 5V)
    and
    tD = 10 + 0.187 x CDELAY (for VCC = 3V)
    where tD is in s and CDELAY is in pF.
    ALARMA
    ALARMB
    ALARMD
    tD
    ALARMA
    ALARMB
    ALARMZ
    ALARMD
    DELAY
    COMPARATOR
    NMOS
    DELAY
    CURRENT
    SOURCE
    CDELAY*
    (EXTERNAL)
    G1
    DELAY THRESHOLD
    tDLY
    ALARM_
    DELAY
    ALARMD
    *The capacitor (CDELAY) charges up slowly, but discharges rapidly.
    If the duration of an ALARM_ pulse is less than tDLY, no alarm
    output will be present at ALARMD.
    Figure 9. Delayed Alarm Output
    Figure 10. ALARMD Simplified Schematic
    Figure 8. Short-Circuit Detection
    A
    NORMAL OPERATION
    SHORT CIRCUIT A TO A
    A
    相關PDF資料
    PDF描述
    MC10EP16VADTR2G IC RCVR/DRVR 5V DIFF ECL 8-TSSOP
    MC10EP16VADR2G IC RCVR/DRVR 5V DIFF ECL 8-SOIC
    MC100EP16VCDTR2G IC RCVR/DRVR 5V DIFF ECL 8-TSSOP
    HI5746KCA IC ADC 10-BIT 40MSPS 28-SSOP
    MAX3172EAI+ IC TERM/TXRX MULTIPROT 28-SSOP
    相關代理商/技術參數
    參數描述
    MAX3098EAEPE+ 功能描述:RS-422/RS-485 接口 IC 10Mbps 3V/5V Quad RS-422/RS-485 Rcvr RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube
    MAX3098EAESE 功能描述:RS-422/RS-485 接口 IC RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube
    MAX3098EAESE+ 功能描述:RS-422/RS-485 接口 IC 10Mbps 3V/5V Quad RS-422/RS-485 Rcvr RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube
    MAX3098EAESE+T 功能描述:RS-422/RS-485 接口 IC 10Mbps 3V/5V Quad RS-422/RS-485 Rcvr RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube
    MAX3098EAESE-T 功能描述:RS-422/RS-485 接口 IC RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube