- 您現在的位置：買賣IC網 > PDF目錄8590 > MAX3507EGI+T (Maxim Integrated Products)IC AMP CATV UPSTREAM 28QFN PDF資料下載
參數資料
| 型號： | MAX3507EGI+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP CATV UPSTREAM 28QFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 類型： | 可變?cè)鲆娣糯笃?br> |
| 應用： | CATV |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 28-QFN/MLP 裸露焊盤（5x5） |
| 包裝： | 帶卷 (TR) |
MAX3507
word (D6–D0) programmed through the serial data
interface (Tables 1 and 2).
Equalizer Function
It is possible to add passband amplitude equalization
to the MAX3507. This is accomplished by adding pole-
zero peaking to the Gm stage of the PGA. Placing a
series RC network between pins EQ+ and EQ- realizes
the peaking function. Refer to Typical Operating
Characteristics for typical values and the associated
degree of equalization.
Power Amplifier
The power amplifier is a Class A differential amplifier
capable of driving +64dBmV (QPSK) differentially. This
architecture provides superior even-order distortion
performance but requires that a transformer be used to
convert to a single-ended output. In transmit-disable
mode, the output amplifier is shut off. Disabling the out-
put devices also allows the lowest standby noise.
To achieve the proper load line, the output impedance
of the power amplifier is 300
differential. To match the
output impedance to a 75
load, the transformer must
have a turns ratio (voltage ratio) of 2:1 (4:1 impedance
ratio). The differential amplifier is biased directly from
the +5V supply using the center tap of the output trans-
former. This provides a significant benefit when switch-
ing between transmit mode and transmit disable mode.
Stored energy due to bias currents will cancel within
the transformer and prevent switching transients from
reaching the load.
Serial Interface
The serial interface has an active-low enable (CS) to
bracket the data, with data clocked in MSB first on the
rising edge of SCLK. Data is stored in the storage latch
on the rising edge of CS. The serial interface controls
the gain state of the PGA and the output amplifier.
Tables 1 and 2 show the register format. Serial interface
timing is shown in Figure 1.
Applications Information
Transmit High-Power and Low-Noise Modes
The MAX3507 has two transmit modes, high-power
(HP) mode and low-noise (LN) mode. Each of these
modes is controlled by D7 (MSB) of the 8-bit program-
ming word. When D7 is a logical 1, HP mode is
enabled. When D7 is a logical 0, LN mode is enabled.
Each of these modes is characterized by the activation
of a distinct output stage. In HP mode, the output stage
exhibits a gain that is 15dB higher than gain in LN
mode. In LN mode, the lower gain output stage allows
for significantly lower output noise and lower
transmit/transmit disable transients.
The full range of gain codes (D6–D0) may be used in
either mode. For DOCSIS applications, HP mode is rec-
ommended for output levels at or above +42dBmV, and
LN mode is recommended for output levels below
+42dBmV.
Shutdown Mode
In normal operation, the shutdown pin (SHDN) is held
high. When SHDN is set low, all circuits within the
device are disabled. Only leakage currents flow in this
state. Data stored within the serial data interface latch-
es will be lost upon entering this mode. Current con-
sumption is reduced to 1A (typ) in shutdown mode.
Output Match
The MAX3507 output impedance is internally matched
to 300
. This 300 internal resistor is placed across
the OUT+ and OUT- terminals. When used in conjunc-
tion with a 2:1 (voltage ratio) transformer, the MAX3507
output impedance is matched to 75
.
To improve the output impedance matching for the high-
end frequency range (65MHz), a reactive match may be
employed as part of the ensuing diplex filter. The reac-
tive match normally consists of a series inductor (180nH
typ) followed by a shunt capacitor (33pF typ), and is
placed directly after the output transformer. This match
will also improve the gain flatness substantially.
As mentioned above, the matching components may be
incorporated into the diplex filter design. Optimize the
input impedance of the diplex filter to be 35 + j35 (typ)
at 65MHz when using the specified output transformer.
Transformer
To match the output of the MAX3507 to a 75
load, a
2:1 (voltage ratio) transformer is required. This trans-
Upstream CATV Amplifier with
On-Chip Anti-Alias Filter
8
_______________________________________________________________________________________
Table 1. Serial-Interface Control Word
BIT
MNEMONIC
DESCRIPTION
7 (MSB)
D7
High-Power/Low-Noise Mode
Select
6
D6
Gain Code, Bit 6
5
D5
Gain Code, Bit 5
4
D4
Gain Code, Bit 4
3
D3
Gain Code, Bit 3
2
D2
Gain Code, Bit 2
1
D1
Gain Code, Bit 1
0 (LSB)
D0
Gain Code, Bit 0
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B6P-MV-B1 | CONVERTER MOD DC/DC 13.8V 150W |
| VE-B3W-MU | CONVERTER MOD DC/DC 5.5V 200W |
| VE-B3V-MU | CONVERTER MOD DC/DC 5.8V 200W |
| VI-25V-IV-F4 | CONVERTER MOD DC/DC 5.8V 150W |
| VE-B30-MU | CONVERTER MOD DC/DC 5V 200W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3509EUP | 功能描述:射頻放大器 RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| MAX3509EUP+ | 功能描述:射頻放大器 RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| MAX3509EUP+T | 功能描述:射頻放大器 Upstream CATV Amplifier RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| MAX3509EUP-T | 功能描述:射頻放大器 Upstream CATV Amplifier RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| MAX3509EVKIT | 功能描述:射頻放大器 Evaluation Kit for the MAX3509 RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。