- 您現在的位置：買賣IC網 > PDF目錄5538 > MAX4163EBL+T (Maxim Integrated Products)IC OPAMP GO RRIO 200KHZ 9UCSP PDF資料下載
參數資料
| 型號： | MAX4163EBL+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/13頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GO RRIO 200KHZ 9UCSP |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.115 V/µs |
| 增益帶寬積： | 200kHz |
| 電流 - 輸入偏壓： | 1pA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 25µA |
| 電流 - 輸出 / 通道： | 15mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 10 V，±1.35 V ~ 5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 9-UFBGA，WLCSP |
| 供應商設備封裝： | 9-UCSP（3x3） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁
MAX4162/MAX4163/MAX4164
UCSP, Micropower, Single-Supply, 10V,
Rail-to-Rail I/O Op Amps
______________________________________________________________________________________
11
1) The on-board charge pumps generate a small
amount of 700kHz switching noise at the op amp’s
output. The amplitude of this noise is typically
100VP-P. The noise is not referred to the input, and
is independent of amplifier gain. The charge-pump
switching frequency is well beyond the amplifier’s
200kHz bandwidth, and is therefore unnoticeable in
most applications.
2) The charge pumps typically require up to 20s on
power-up to fully energize the internal supply rails
(Figure 3).
Power Supplies and Layout
The MAX4162/MAX4163/MAX4164 are guaranteed to
operate from a single 2.5V to 10.0V power supply, but
full rail-to-rail operation typically extends below 2V. For
single-supply operation, bypass the power supply with a
1F capacitor in parallel with a 0.1F ceramic capacitor.
If operating from dual supplies, bypass each supply to
ground.
Good layout improves performance by decreasing the
amount of stray capacitance at the op amp’s inputs and
output. To decrease stray capacitance, minimize both
trace and external component lead lengths, and place
external components close to the op amp’s pins.
UCSP Package Consideration
For general UCSP package information and PC layout
considerations, please refer to the Maxim Application
Note (Wafer-Level Ultra-Chip-Board-Scale-Package).
UCSP Reliability
The UCSP represents a unique packaging form factor
that may not perform equally to a packaged product
through traditional mechanical reliability tests. UCSP
reliability is integrally linked to the user’s assembly
methods, circuit board material, and usage environ-
ment. The user should closely review these areas when
considering use of a UCSP. Performance through oper-
ating life test and moisture resistance remains uncom-
promised as it is primarily determined by the
wafer-fabrication process. Mechanical stress perfor-
mance is a greater consideration for a UCSP package.
UCSPs are attached through direct solder contact to
the user’s PC board, foregoing the inherent stress relief
of a packaged product lead frame. Solder joint contact
integrity must be considered.
Table 1 shows the testing done to characterize the
UCSP reliability performance. In conclusion, the UCSP
is capable of performing reliably through environmental
stresses as indicated by the results in the table.
Additional usage data and recommendations are
detailed in the UCSP application note, which can be
found on Maxim’s website at www.maxim-ic.com.
TEST
CONDITIONS
DURATION
NO. OF FAILURES PER
SAMPLE SIZE
Temperature Cycle
-35°C to +85°C, -40°C to +100°C
150 cycles, 900 cycles
0/10, 0/200
Operating Life
TA = +70°C
240h
0/10
Moisture Resistance
-20°C to +60°C, 90% RH
240h
0/10
Low-Temperature Storage
-20°C
0/10
Low-Temperature Operational
-10°C
24h
0/10
Solderability
8h steam age
—
0/15
ESD
±2000V, Human Body Model
—
0/5
High-Temperature Operating
Life
TJ = +150°C
168h
0/45
Table 1. Reliability Test Data
相關PDF資料 |
PDF描述 |
|---|---|
| RCWL0805R470JNEA | RES .47 OHM 1/8W 5% 0805 SMD |
| 1.5KE82C-E3/54 | TVS BIDIR 1.5KW 82V 10% 1.5KE |
| RCWL0805R430JMEA | RES .43 OHM 1/8W 5% 0805 SMD |
| 1.5KE82-E3/54 | TVS UNIDIR 1.5KW 82V 10% 1.5KE |
| RCWL0805R390JMEA | RES .39 OHM 1/8W 5% 0805 SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4163ESA | 功能描述:運算放大器 - 運放 uPower Single Supply Rail-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4163ESA+ | 功能描述:運算放大器 - 運放 uPower Single Supply Rail-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4163ESA+T | 功能描述:運算放大器 - 運放 uPower Single Supply Rail-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4163ESAT | 制造商:MAXIM 功能描述:NEW |
| MAX4163ESA-T | 功能描述:運算放大器 - 運放 uPower Single Supply Rail-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。