• <menuitem id="jegag"></menuitem>
  • 參數資料
    型號: MAX4274BEESA
    廠商: Maxim Integrated Products
    文件頁數: 4/20頁
    文件大小: 0K
    描述: IC OPAMP GAIN 24 R-TO-R 8-SOIC
    標準包裝: 100
    系列: GainAmp™
    放大器類型: 通用
    電路數: 2
    輸出類型: 滿擺幅
    轉換速率: 0.7 V/µs
    -3db帶寬: 1.7MHz
    電流 - 輸入偏壓: 50pA
    電壓 - 輸入偏移: 500µV
    電流 - 電源: 330µA
    電流 - 輸出 / 通道: 65mA
    電壓 - 電源,單路/雙路(±): 2.5 V ~ 5.5 V,±1.25 V ~ 2.75 V
    工作溫度: -40°C ~ 85°C
    安裝類型: 表面貼裝
    封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
    供應商設備封裝: 8-SOIC
    包裝: 管件
    MAX4174/5,
    MAX4274/5,
    MAX4281/2/4
    SOT23, Rail-to-Rail, Fixed-Gain
    GainAmps/Open-Loop Op Amps
    12
    ______________________________________________________________________________________
    cause output phase reversal. A back-to-back SCR
    structure at the input pins allows either input to safely
    swing ±17V relative to V EE (Figure 3). Additionally, the
    internal op-amp inputs are diode clamped to either
    supply rail for the protection of sensitive input stage cir-
    cuitry. Current through the clamp diodes is limited by a
    5k
    resistor at the noninverting input, and by R G at the
    inverting input. An IN+ or IN- fault voltage as high as
    ±17V will cause less than 3.5mA of current to flow
    through the input pin, protecting both the GainAmp and
    the signal source from damage.
    Applications Information
    GainAmp fixed-gain amplifiers offer a precision, fixed
    gain amplifier in a small package that can be used in a
    variety of circuit board designs. GainAmp fixed-gain
    amplifiers can be used in many op amp circuits that use
    resistive negative feedback to set gain, and that do not
    require other connections to the op-amp inverting input.
    Both inverting and noninverting op-amp configurations
    can be implemented easily using a GainAmp.
    GainAmp Input Voltage Range
    The MAX4174/MAX4175/MAX4274/MAX4275 combine
    both an op amp and gain-setting feedback resistors on
    the same chip. Because the inverting input pin is actu-
    ally tied to the R G input series resistor, the inverting
    input voltage range is different from the noninverting
    input voltage range. Just as with a discrete design,
    care must be taken not to saturate the inputs/output of
    the core op amp, to avoid signal distortions or clipping.
    The inverting inputs (IN_-) of the MAX4174/MAX4175/
    MAX4274/MAX4275 must be within the supply rails or
    signal distortion may result. The GainAmp’s inverting
    input structure includes diodes to both supplies, such
    that driving the inverting input beyond the rails may
    cause signal distortions (Figure 1). For applications that
    require sensing voltages beyond the rails, use the
    MAX4281/MAX4282/MAX4284 open-loop op amps
    (Figure 4).
    OUT
    IN-
    IN+
    RG
    RF
    5k
    VEE
    BIAS RESISTORS (MAX4175/MAX4275 ONLY)
    NOTE: INPUT STAGE PROTECTION INCLUDES
    TWO 17V SCRs AND TWO DIODES AT THE INPUT STAGE.
    VCC
    VEE
    MAX4174
    MAX4175
    MAX4274
    MAX4275
    17V
    SCR
    VEE
    17V
    SCR
    Figure 3. Input Protection
    相關PDF資料
    PDF描述
    MAX4274BAEUA IC OPAMP GAIN 10 R-TO-R 8-UMAX
    MAX4274AOEUA IC OPAMP GAIN 9 R-TO-R 8-UMAX
    MAX4274AOESA IC OPAMP GAIN 9 R-TO-R 8-SOIC
    MAX4274AKEUA IC OPAMP GAIN 4 R-TO-R 8-UMAX
    MAX4274AKESA IC OPAMP GAIN 4 R-TO-R 8-SOIC
    相關代理商/技術參數
    參數描述
    MAX4274BEESA+T 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MAX4274BEESA-T 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MAX4274BEEUA 功能描述:運算放大器 - 運放 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MAX4274BEEUA+T 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
    MAX4274BEEUA-T 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel