32-Tap FleaPoT, 2-Wire Digital Potentiometers __________________" />
參數資料
型號: MAX5460EXK+T
廠商: Maxim Integrated Products
文件頁數: 6/10頁
文件大?。?/td> 0K
描述: IC POT DGTL 32-TAP 2WIRE SC70-5
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 1
系列: FleaPoT™
接片: 32
電阻(歐姆): 100k
電路數: 1
溫度系數: 標準值 35 ppm/°C
存儲器類型: 易失
接口: 2 線串行(芯片選擇,增/減)
電源電壓: 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 6-TSSOP(5 引線),SC-88A,SOT-353
供應商設備封裝: SC-70-5
包裝: 標準包裝
產品目錄頁面: 1399 (CN2011-ZH PDF)
其它名稱: MAX5460EXK+TDKR
MAX5460–MAX5468
32-Tap FleaPoT, 2-Wire Digital
Potentiometers
_______________________________________________________________________________________
5
Detailed Description
The MAX5460–MAX5468 consist of a fixed resistor and a
wiper contact with 32-tap points that are digitally con-
trolled through a 2-wire serial interface. Three resistance
values are available: 10k (MAX5466/MAX5467/
MAX5468), 50k (MAX5463/MAX5464/MAX5465), and
100k (MAX5460/MAX5461/MAX5462).
The MAX5462/MAX5465/MAX5468 are designed to oper-
ate as potentiometers. In this configuration, the low termi-
nal of the resistor array is connected to ground (pin 2).
The MAX5461/MAX5464/MAX5467 perform as variable
resistors. In these devices, the wiper terminal and high
terminal of the resistor array are connected at pin 5.
The MAX5460/MAX5463/MAX5466 are similar variable
resistors, except the low terminal is connected to
ground (pin 2).
Digital Interface Operation
The MAX5460–MAX5468 have two modes of operation
when the serial interface is active: increment and
decrement mode. The serial interface is only active
when
CS is low.
The
CS and U/D inputs control the position of the wiper
along the resistor array. When
CS transitions from high to
low, the part will go into increment mode if U/
D is high,
and into decrement mode if U/
D is low. Once the mode is
set, the device will remain in that mode until
CS goes high
again. A low-to-high transition at the U/
D pin will incre-
ment or decrement the wiper position depending on the
current mode (Figures 1 and 2).
When the
CS input transitions to high (serial interface
inactive), the value of the counter is stored and the
wiper position is maintained.
Note that when the wiper reaches the maximum (or mini-
mum) tap position, the wiper will not wrap around to the
minimum (or maximum) position.
CS
U/D
W
NOTE: "W" IS NOT A DIGITAL SIGNAL. IT REPRESENTS WIPER TRANSITIONS.
tCU
tIL
tIH
tSETTLE
tIC
tCI
tSETTLE
Figure 1. Serial Interface Timing Diagram, Increment Mode
CS
U/D
W
tCU
tIL
tIH
tIC
tSETTLE
tCI
tSETTLE
NOTE: "W" IS NOT A DIGITAL SIGNAL. IT REPRESENTS WIPER TRANSITIONS.
Figure 2. Serial Interface Timing Diagram, Decrement Mode
相關PDF資料
PDF描述
VI-22V-MY-F4 CONVERTER MOD DC/DC 5.8V 50W
MS27500E12B35P CONN PLUG 22POS RT ANG W/PINS
MS3106A28-10SW CONN PLUG 7POS STRAIGHT W/SCKT
MS3106A28-10S CONN PLUG 7POS STRAIGHT W/SCKT
DS12R885S-33+ IC RTC W/RAM 128 BYTE 24-SOIC
相關代理商/技術參數
參數描述
MAX5461EXT 制造商:Maxim Integrated Products 功能描述:32-TAP FLEAPOT 2-WIRE DIGITAL POTEN - Cut Tape Product
MAX5461EXT+ 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 32POS 100KOHM SGL 6PIN SC-70 - Rail/Tube
MAX5461EXT+T 功能描述:數字電位計 IC 32-Tap FleaPoT 2Wire RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5461EXT-T 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5462EXT 制造商:Maxim Integrated Products 功能描述:32-TAP FLEAPOT 2-WIRE DIGITAL POTEN - Cut Tape Product